Huawei EchoLife HG510 Manual de usuario

B roadband

B roadbandB roadband

B roadband P akistan

P akistanP akistan

P akistan

ADSL Installation Guide

HUAWEI EchoLife HG-510

Page 1

PTCL introduces DSL service for our valued subscribers. We are committed to

provide you quality internet services. Please follow the installation instructions and

log on to your ADSL broadband link.

Step 1: Connecting to the Splitter, Power Connection & LAN cable.

1 Line hole connects to PTCL wire or Wall phone Jack (RJ-11 Jack).

2 Modem hole connects to the DSL jack of the ADSL CPE (Customer Premises

Equipment).

3 Phone hole connects to a telephone set.

4 Connect the Power Adapter to the AC power plug and attach the connector of

adapter to the CPE and switch it on.

5 Attach one end of LAN wire (RJ-45) to the LAN interface of CPE and the other

end to the LAN wire to the LAN interface of computer’s LAN card.

6 Link Indicator lights will lit up and show the connectivity. ADSL light will start

blinking and soon will be static as a sign of connectivity with our system, if the

line is properly jumpered in PTCL premises with the DSLAM (Digital

Subscriber Line Access Multiplexer).Joint less and direct cable line from the

nearest PTCL pole or cabinet must be connecting to your splitter and then all

the phone extensions must be taken from the phone hole of splitter. The Drop

wire distance from PTCL pole or Cabinet must not be ideally more than 50

meters.(Twisted pair wire can be longer)

Step 2: ADSL Configuration in CPE and Computer

1. Go to Start Menu < Control Panel < Network and Internet Connections < Network

Connections. Check that the Local Area Connection is enabled. Right click local

Area network and click properties. Following window will be shown.

Page 2

2. Double click “internet protocol (TCP/IP)”, Check “Use the following IP

address” and make the following settings:

IP Address: 192.168.1.3

Subnet Mask: 255.255.255.0

Gateway: 192.168.1.1

Then, check “Use the following DNS server addresses” and make

the following settings:

Preferred DNS Server: 203.99.163.240

Alternate DNS Server: 203.135.0.170

3. Now open Internet Explorer and write “192.168.1.1” in address bar and press

enter. There must not be any proxy setting in the internet Explorer.

Page 3

A small pop up window will open as shown in the figure below and ask ”User Name”

and “Password” for opening the CPE’s interface.

Enter User Name: “admin” and Password: “admin” and press OK.

4. Following page will be displayed after entering correct User name and Password:

Page 4

5. Click the Device Info link on the left hand side tabs, more options will be shown. Click

Statistics and further more options will be shown, among them select ADSL.

Page 5

6. Clicking ADSL will show the ADSL line parameters, Note the SNR Margin and Line

Attenuation. SNR must be higher than 08 dB and Line Attenuation must be less than 45

dB for establishing a stable DSL connection.

7. Select “Advanced Setup” from the left hand tabs and following window will be displayed

8. “Wide Area Network (WAN) Setup” window is shown displaying the list of default

connections. Check all of them except one and click remove button.

9. Edit the connection by pressing the Edit button.

Page 6

10. Enter the values of VPI = 0 & VCI = 103 for copper (Note: For ONU use VPI=8 &

VCI=81) and check “Enable Quality of Service” and click Next as shown under.

11. Select “PPP over Ethernet PPPoE” and click Next.

12. Enter the Username = 051+telephone No. of subscriber e.g., (0512255678) and Password

= New Product No. as provided on External Construction Orders e.g., (1130000xxxx).

Page 7

13. Uncheck the “Enable Firewall” checkbox and click Next as shown below.

Page 8

14. “WAN Setup Summary” page is displayed showing the settings/configurations, click Save

button to save the configurations.

15. Click Save/Reboot, a message window is shown, click OK to save the changes.

Page 9

16. DSL Router Reboot window is shown. Wait until the next window is shown displaying

the Device Info.

17. Go again to Internet Protocol (TCP/IP) Properties and Select Obtain an IP address

automatically and leave the DNS server addresses unchanged as shown in the picture

below and press Ok.

Open the Internet Explorer and start browsing the sites for successful configuration and DSL

connection establishment.

Otros manuales para EchoLife HG510

2

Otros manuales de Módem de Huawei

Huawei

Huawei R227h Manual de usuario

Huawei

Huawei E600 Manual de usuario

Huawei

Huawei E589 Manual de usuario

Huawei

Huawei EC168 Instrucciones de montaje

Huawei

Huawei EC167 Manual de usuario

Huawei

Huawei webConnect Manual de usuario

Huawei

Huawei E5830 Manual de usuario

Huawei

Huawei CG1241 Manual de usuario

Huawei

Huawei EC325 Manual de usuario

Huawei

Huawei E220 Manual de instrucciones

Huawei

Huawei EC168C Manual de usuario

Huawei

Huawei EchoLife HG612 Manual de usuario

Huawei

Huawei 3101 series Manual de usuario

Huawei

Huawei B2368 Manual de usuario

Huawei

Huawei SmartAX MT883 Manual de usuario

Huawei

Huawei LTE CPE Manual de usuario

Huawei

Huawei MT886 Manual de usuario

Huawei

Huawei E166 Manual de usuario

Huawei

Huawei B681 Manual de usuario

Huawei

Huawei B315s Manual de usuario

Huawei

Huawei EC306 Manual de usuario

Huawei

Huawei HiLink E3231 Especificaciones técnicas

Huawei

Huawei E220 Manual de usuario

Huawei

Huawei E153U-6 Manual de usuario

Manuales populares de Módem de otras marcas

Davicom

Davicom DM562AP Manual de usuario

EpiValley

EpiValley TATA indicom SXC-1080 Manual de usuario

Zte

Zte WiMAX Manual de usuario

Intelimax

Intelimax MA-2060 Manual de usuario

SMC Networks

SMC Networks D3CM1604V Manual de uso y cuidado

Telstra

Telstra Wi-Fi 4G Advanced Pro X Manual de usuario

Thrane&Thrane

Thrane&Thrane imarsat EXPLORER 300 Manual de usuario

Samsung

Samsung AceLink SAM-335A Manual de usuario

Enfora

Enfora Enabler-G Guía de configuración rápida

iRZ

iRZ ATM2-232 Manual de usuario

Zhone

Zhone 6310 Manual de usuario

Paradyne

Paradyne Hotwire 7976 Manual de usuario

US Robotics

US Robotics 3453C Manual de usuario

MaxTech

MaxTech Plug & Play Internal Voice/FAX/Data/SVD... Manual de usuario

Zte

Zte MF823 Manual de usuario

Four-Faith

Four-Faith F1403 Manual de usuario

Sierra Wireless

Sierra Wireless AIRLINK MP595W Manual de usuario

Gemtek

Gemtek WiMAX WIXFBR-103 Manual de usuario