Huawei EchoLife HG520s Manual de usuario
EchoLife HG520s Home Gateway User Manual
Issue 01
Date 2006-08-26
No. 202013
Huawei Technologies Co., Ltd.
Address: Administration Building, Huawei Technologies Co., Ltd.,
Bantian, Longgang District, Shenzhen, 518129, People’s
Republic of China
Website: http://www.huawei.com
Email: terminal@huawei.com
Copyright © Huawei Technologies Co., Ltd. 2006. All rights reserved.
No part of this document may be reproduced or transmitted in any form or by
any means without prior written consent of Huawei Technologies Co., Ltd.
Trademarks and Permissions
and other Huawei trademarks are trademarks of Huawei Technologies
Co., Ltd.
All other trademarks and trade names mentioned in this document are the
property of their respective holders.
Notice
The information in this document is subject to change without notice. Every
effort has been made in the preparation of this document to ensure accuracy
of the contents, but all statements, information, and recommendations in this
document do not constitute the warranty of any kind, express or implied.
This product has been designed to comply with the requirements on
environmental protection. For the proper storage, use and disposal of this
product, national laws and regulations must be observed.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation
Class B:
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE
STATEMENT
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-Consult the dealer or an experienced radio/ TV technician for help.
CAUTION:
Any changes or modifications not expressly approved by the grantee of this
device could void the user's authority to operate the equipment.
RF exposure warning ·
This equipment must be installed and operated in accordance with provided
instructions and the antenna(s) used for this transmitter must be installed to
provide a separation distance of at least 20 cm from all persons and must not
be co-located or operating in conjunction with any other antenna or transmitter.
End-users and installers must be provide with antenna installation instructions
and transmitter operating conditions for satisfying RF exposure compliance.
Safety Precautions
Basic Requirements:
Read this manual carefully before installing and using the
equipment.
Take waterproof measures during storage, transportation and
operation of the equipment.
Avoid collision during storage, transportation and operation of the
equipment.
Without prior written consent from Huawei, no company or individual
is allowed to decompile, disassemble, modify or reverse engineer
the equipment and shall be solely responsible for any effect resulted
from such action.
Environmental Requirements:
Place the equipment in a well-ventilated place. Avoid direct
irradiation of any strong light (such as sunlight).
Keep the equipment clean.
Place the equipment on a flat and stable platform which is beyond
the reach of children.
Do not place heavy objects on the equipment.
Maintain at least 10 cm space around the equipment for heat
dissipation. Do not cover the equipment with any object or block the
ventilation holes of the equipment.
Keep the equipment away from appliances with a strong electric
field or magnetic field, such as a microwave oven and a refrigerator.
Usage:
Use only the power adapter provided with the equipment.
The power supply must meet the equipment specifications.
Before plugging or unplugging the cables, turn off the equipment
and unplug the power supply.
In a lightning storm, turn off the equipment and unplug the power
supply, to avoid lightning strike.
Unplug the power supply if the equipment is not used for a long
time.
The temperature of the equipment shell goes up when used for long
hours. This is a normal phenomenon.
Cleaning:
Before cleaning the equipment, turn off the equipment and unplug
the power supply.
Clean the equipment shell with a piece of soft cloth.
Do not spray liquid onto the equipment, to avoid damage to the
internal circuit.
Keep the power socket clean and dry, to avoid electric shock or
other dangers.
i
Table of Contents
Chapter 1 Introduction ........................................................................1
1.1 Functions and Features.........................................................1
1.2 Hardware Configuration ........................................................1
1.2.1 Front Panel .................................................................2
1.2.2 Rear Panel..................................................................3
1.2.3 Splitter.........................................................................4
Chapter 2 Installation of the HG520s..................................................5
2.1 Preparation............................................................................5
2.2 Connecting the HG520s ........................................................5
2.3 Establishing Configuration Environment ...............................7
2.3.1 Parameter Configuration.............................................7
2.3.2 Steps...........................................................................7
2.4 Introduction to the Configuration Management Interface......8
Chapter 3 Service Configuration.......................................................10
3.1 Method ................................................................................10
3.1.1 Protocol Model..........................................................10
3.1.2 Steps.........................................................................11
3.2 Service Modes of the HG520s ............................................12
3.3 Configuring the Pure Bridge Mode......................................13
3.3.1 Preparation ...............................................................13
3.3.2 Steps.........................................................................14
3.4 Configuring the PPPoE Mode .............................................16
3.4.1 Preparation ...............................................................16
ii
3.4.2 Steps.........................................................................17
3.5 Configuring the PPPoA mode .............................................19
3.6 Configuring the DHCP Mode...............................................19
3.6.1 Preparation ...............................................................19
3.6.2 Steps.........................................................................20
3.7 Configuring the Static IP Mode ...........................................21
3.7.1 Preparation ...............................................................21
3.7.2 Steps.........................................................................22
3.8 Configuring the IPoA Mode .................................................24
Chapter 4 Other Settings ..................................................................25
4.1 Changing the IP Address of the LAN of the HG520s..........25
4.2 Changing the Administrator Password of the HG520s .......26
4.3 Restoring the Default Factory Settings ...............................26
Chapter 5 Troubleshooting ...............................................................28
5.1 Quick Failure Location.........................................................28
5.2 FAQs ...................................................................................29
Chapter 6 Technical Specifications ..................................................31
Chapter 7 Appendix ..........................................................................33
7.1 Default Factory Settings ......................................................33
7.1.1 Common Default Parameters ...................................33
7.1.2 Default PVC Parameters ..........................................33
7.2 Abbreviations.......................................................................34
1
Chapter 1 Introduction
This chapter introduces functions and structure of the EchoLife
HG520s Home Gateway (hereinafter referred to as the HG520s).
1.1 Functions and Features
The HG520s is a type of Asymmetric Digital Subscriber Line
(ADSL) terminal. Data, video and audio are transmitted through the
common telephone line at a higher rate by the HG520s.
The features of the HG520s are:
High transmission rate: The maximum downstream transfer
rate is 24 Mbit/s; the maximum upstream transfer rate is
1.2 Mbit/s.
Strong network adaptability: The HG520s can be
interconnected with multiple Digital Subscriber Line Access
Multiplexes (DSLAMs).
Strong maintainability: The HG520s provides multiple
indicator status, which is convenient to locate failures.
Easy operation: The HG520s has a simple operation for the
configuration and management page.
1.2 Hardware Configuration
This section introduces the appearance and structure of the
HG520s.
2
Note:
Figures of the front panel and the rear panel are only for your reference.
1.2.1 Front Panel
Figure 1-1 shows the front panel of the HG520s.
WLAN LAN4 LAN3LAN2LAN1INTERNET ADSL POWER
Figure 1-1 Front panel of the HG520s
Table 1-1 shows indicator descriptions of the HG520s in the front
panel.
Table 1-1 Indicator descriptions[a1]
Indicator Color Status Description
On Power is on.
Power Green
Off Power is off.
On DSL connection is established.
Blinking The DSL link is in the activation
process.
ADSL Green
Off DSL connection is not
established.
On
A link is established and activated
in the routing mode, but no data is
being transmitted.
INTERNET Green
Blinking Data is being transmitted in the
routing mode.
3
Indicator Color Status Description
Off
The HG520s is in the bridging
mode; or it is in the routing mode
with no link established.
On LAN connection is established.
Blinking LAN data is being transmitted.
LAN1~4 Green
Off LAN connection is not
established.
On WLAN connection is established.
Blinking WLAN data is being transmitted.
WLAN Green
Off No WLAN connection is
established.
Note:
PPP = Point-to-Point Protocol
Note:
If the HG520s fails to activate, it tries again after an interval. The ADSL
LINK indicator is off during the interval, lasting for about 1 minute.
1.2.2 Rear Panel
Figure 1-2 shows the rear panel of the HG520s.
ADSL
LAN1 LAN2 LAN3 LAN4
ON/ OFF
POWER
RESET
Figure 1-2 Rear panel of the HG520s
4
Table 1-2shows descriptions of interfaces and buttons in the rear
panel of the HG520s.
Table 1-2 Descriptions of Interfaces and Buttons[a2]
Interface/Button Description
Antenna Antenna for wireless Internet access.
ADSL RJ-11 connector for connection with the telephone jack
or a splitter through a telephone line.
LAN1~4 RJ-45 connector for connection with the Ethernet port
of a computer or a LAN hub.
RESET
To make the equipment restored and restarted, press
the RESET button and release it within 3 seconds. To
make the equipment restore the default settings of the
HG520s, press the RESET button and release it after 3
seconds. Once you use this function, all your
customized settings will be lost. Therefore, please be
careful with it.
POWER Connect to the power adapter.
ON/OFF Switch on/off HG520s.
1.2.3 Splitter
The external splitter can efficiently reduce the signal disturbance
on the telephone line. When voice and data are transmitted through the
same telephone line at the same time, you need an external splitter to
separate the voice and data signals:
LINE: Connecting to the phone jack on the wall.
PHONE: Connecting to the telephone.
MODEM: Connecting to the ADSL interface of the HG520s.
Otros manuales para EchoLife HG520s
2
Tabla de contenidos
Otros manuales de Puerta de Huawei
Huawei
Huawei HG659 Manual de usuario
Huawei
Huawei HG655b Manual de usuario
Huawei
Huawei eA380 Manual de usuario
Huawei
Huawei HG622 Manual de usuario
Huawei
Huawei HG532e Manual de usuario
Huawei
Huawei B535-232a Manual de usuario
Huawei
Huawei EchoLife HG556 Manual de usuario
Huawei
Huawei RRU3808 V200 Manual de usuario
Huawei
Huawei USG6310 Manual de usuario
Huawei
Huawei EchoLife HG520s Manual de usuario
Huawei
Huawei HG255e Manual de usuario
Huawei
Huawei B260 Especificaciones técnicas
Huawei
Huawei EchoLife HG8245A Especificaciones técnicas
Huawei
Huawei HG630 Especificaciones técnicas
Huawei
Huawei EchoLife HG520 Manual de usuario
Huawei
Huawei HG655b Manual de usuario
Huawei
Huawei HG256s Manual de usuario
Huawei
Huawei ECHOLIFE HG520C Manual de usuario
Huawei
Huawei U-SYS IAD101H Manual de usuario
Huawei
Huawei B970b Manual de usuario
Manuales populares de Puerta de otras marcas
LST
LST M500RFE-AS Manual de usuario
Kinnex
Kinnex Media Gateway Manual de usuario
2N Telekomunikace
2N Telekomunikace 2N StarGate Manual de usuario
Mitsubishi Heavy Industries
Mitsubishi Heavy Industries Superlink SC-WBGW256 Manual de usuario
ZyXEL Communications
ZyXEL Communications ZYWALL2 ET 2WE Manual de usuario
Telsey
Telsey CPVA 500 - SIP Manual de usuario
