Huawei EchoLife HG520 Manual de usuario
Copyright © 2005 Huawei Technologies Co., Ltd.
All Rights Reserved
No part of this manual may be reproduced or transmitted in any
form or by any means without prior written consent of Huawei
Technologies Co., Ltd.
Trademarks
, HUAWEI are trademarks of Huawei Technologies Co.,
Ltd.
All other trademarks and trade names mentioned in this
manual are the property of their respective holders.
Notice
The information in this manual is subject to change without
notice. Every effort has been made in the preparation of this manual
to ensure accuracy of the contents, but all statements, information,
and recommendations in this manual do not constitute the warranty
of any kind, express or implied.
1
EchoLife HG520 Home Gateway
Quick Guide
Welcome to purchase the EchoLife HG520 Home Gateway device(the
HG520 for short). With your HG520, you can access the Internet using
your high-speed ADSL AP router.
This manual shows how to install your HG520.
Getting to Know
The HG520 is a kind of Internal ADSL AP router for high speed
internet access.It has a 10/100Base-T Ethernet router to provide
Internet connectivity to all computers on your LAN. It also support
IEEE 802.11g 54Mbit/s Access Point.
Rear Panel
The rear panel provides ports for the HG520 to receive/send data and
get power supply..
Label Function
SW Power Button. Switches the device on and off
DC-IN Connects to the power adapter cable
RST Press the reset button for 2 seconds the HG520
will be restarted (rebooted). To reset to default
settings, turn off the device first. Hold the Reset
button and then turn on the device; wait for 5~8
seconds and then release the button. Resets
device’s configuration to factory default
LAN1-4 RJ-45 connector: connects the device to your
computer's Ethernet port, or to the uplink port on
your LAN's hub, using the cable provided.
DSL RJ-11 connector: connects the device to a
telephone jack using the supplied cable
Front Panel
The front panel provides LED indicators to indicate the device status.
Label Color Function
PWR Green On: The device is powered on
Off: The device is powered off
2
Label Color Function
LAN1-4 Green On: The LAN link established and active
Off: No LAN link
Flashes during data transfer
DSL Green Flashes during the ADSL training mode
On: ADSL link established and active
Tx/Rx Green On: The device is active
Flashes during data transfer through ADSL
line
WLAN Green On: The WLAN enabled
Off: The WLAN disabled
Flashes during data transfer
Before Installation
The HG520 is used indoors only. Pay attention to the following when
installing and using the HG520.
Environment
3
Cleaning
Before cleaning the HG520, cut off the power supply.
Clean it using a piece of soft cloth. Do not use liquid or gas solution.
Power supply
•Use the power adapter delivered with the HG520.
•The voltage of the power supply shall meet the requirement of the
input voltage of the power adapter.
•In the case of thundering, unplug the power adapter;If the HG520
is not in use for a long time, unplug the power adapter.
•Do not open the cover of the HG520.
Connecting the HG520
You need to connect the device to the phone jack, the power outlet,
and your computer or network.
Before cable connection, turn off power of your
computer(s),LAN/hub/switch (if applicable),and the HG520.
Cable connection:
4
Follow the steps listed below to install it.
Stage Description See in
1 Connect the ADSL line. Step1
2 Connect the Ethernet cable. Step2
3 Attach the power connector. Step3
4 Turn on the HG520 and power up your system Step4
Step1 Connect the ADSL line
Method one: Plug one end of the twisted-pair ADSL cable into the
ADSL port on the rear panel of HG520 and insert the other end into the
wall socket.
Method two: You can use a separate splitter. External splitter can
divide the data and voice, then you can access the Internet and make
calls at the same time.The external splitter has three ports:
•LINE: connect to the wall jack
•PHONE: connect to the phone sets
•MODEM: connect the ADSL port of HG520
Plug one end of the twisted-pair ADSL cable into the ADSL port on the
rear panel of HG520. Connect the other end to the MODEM port of the
external splitter.
5
Note: Although you use the same type of cable, ADSL and
PHONE ports are not interchangeable. Do not route
the ADSL connection through the PHONE port.
Setp2 Connect the Ethernet cable
Attach one end of a provided network cable to a regular hub port and
the other to the Ethernet port on the HG520.
Step3 Attach the power adapter
Connect the AC power adapter to the PWR connector on the rear of
the device and plug in the adapter to a wall outlet or power extension.
Step4 Turn on the HG520 and power up computers and LAN
devices
Press the power switch on the rear panel of the device to the ON
position.
Turn on and boot up your computer(s) and any LAN devices such as
hubs or switches.
FAQs
Failure Instruction
Power
light is out.
•Ensure the power adapter is well connected
•Ensure the right power adapter is used
ADSL
LINK light
is out.
•Ensure the ADSL line is well connected
•Test with a phone to ensure the phone cable
before entering the house is valid
•Check that there is no junction box before
connecting HG520, which has such
components like capacitors or diodes that
could hinder back high frequency signals
•Ensure the router and phones are properly
connected.
LAN LINK
light is out
•Ensure you use the right cables from the
router to your computer
•Ensure the connection is secured;Check if the
NIC LED lights up;
•Ensure your NIC works normally by examining
whether the item of “Networking Device” is
labeled with “?” or “!”. If it is, you may delete it
6
Failure Instruction
and then click <Refresh> to reinstall.
•Otherwise you may try the NIC in another slot.
As a last resort, you have to replace the NIC.
Fail to
access the
Internet
Take the most common access mode as an
example, in which a dial-up application is
installed on your computer
•Ensure that any of the problems above is not
the reason
•Ensure that the dial-up application is correctly
installed and set on your computer
•Ensure that you have entered the right user
name and password
•Ensure “Use Proxy Server” is set properly for
IE, if the problem still remains even after you
have logged into successfully
•Try to access more than one Web sites, in
case of some Web server’s being in failure
Technical Specifications
Item Specification
Whole-system consumption 10W
Power supply 200V AC-240V AC
Frequency: 50Hz-60 Hz
Dimensions(L WH) 146mm 129mm 29mm
Operating temperature 0-40
Storage temperature -10 -65
Operating humidity 10% - 95% non-condensing
This product has been designed to comply with the requirements on
environmental protection. For the proper storage, use and disposal of
this product, national laws and regulations must be observed.
Otros manuales para EchoLife HG520
3
Tabla de contenidos
Otros manuales de Puerta de Huawei
Huawei
Huawei HA35 Manual de usuario
Huawei
Huawei eSpace EGW1530B Manual de usuario
Huawei
Huawei B260 Manual de usuario
Huawei
Huawei AR-Sc Series Manual de usuario
Huawei
Huawei E960 HSDPA Manual de usuario
Huawei
Huawei EchoLife HG8247 Manual de usuario
Huawei
Huawei U-SYS IAD101H Manual de usuario
Huawei
Huawei BC510 Manual de usuario
Huawei
Huawei B970b Manual de usuario
Huawei
Huawei HG655d Manual de usuario
Huawei
Huawei HG658 V2 Manual de usuario
Huawei
Huawei B2201H-201 Especificaciones técnicas
Huawei
Huawei HG659 Manual de usuario
Huawei
Huawei EchoLife HG532 Manual de usuario
Huawei
Huawei EchoLife HG553 Manual de usuario
Huawei
Huawei HG532t Manual de usuario
Huawei
Huawei B535-232a Manual de usuario
Huawei
Huawei ME60 Series Guía
Huawei
Huawei eSpace EGW1520A Manual de usuario
Huawei
Huawei HG530 Manual de usuario
Manuales populares de Puerta de otras marcas
LST
LST M500RFE-AS Manual de usuario
Kinnex
Kinnex Media Gateway Manual de usuario
2N Telekomunikace
2N Telekomunikace 2N StarGate Manual de usuario
Mitsubishi Heavy Industries
Mitsubishi Heavy Industries Superlink SC-WBGW256 Manual de usuario
ZyXEL Communications
ZyXEL Communications ZYWALL2 ET 2WE Manual de usuario
Telsey
Telsey CPVA 500 - SIP Manual de usuario
