HP NetStorage 6000 Manual de usuario

Otros manuales para NetStorage 6000

12

Otros manuales de Almacenamiento de HP

HP

HP LTO-4 HH Manual de usuario

HP

HP StorageWorks 1000 - Modular Smart Array Manual de servicio

HP

HP P6080-63001 - Maxtor DiamondMax Plus 40 GB Hard... Manual de usuario

HP

HP StorageWorks 4000/6000/8000 - Enterprise Virtual... Manual de instrucciones

HP

HP C4405A - Colorado 14GB Tape Drive Manual de usuario

HP

HP NetStorage 6000 Manual de instalación y operación

HP

HP StorageWorks 3800ux Instrucciones de uso

HP

HP Compaq Presario,Presario 4400 Guía

HP

HP LTO-4 Ultrium 1760 Manual del producto

HP

HP Invent Q1575 Series Instrucciones de montaje

HP

HP StorageWorks 1000 - Modular Smart Array Manual de usuario

HP

HP D2D Manual de usuario

HP

HP StorageWorks 4000/6000/8000 - Enterprise Virtual... Manual de instrucciones

HP

HP surestore t20xe Manual de usuario

HP

HP StorageWorks MSL2024 Manual

HP

HP StorageWorks 2000s Manual de usuario

HP

HP F2B56AA Manual de usuario

HP

HP Storevirtual 4000 Guía de referencia rápida

HP

HP 705 Workstation Manual de usuario

HP

HP HPE StoreOnce 3100 Series Manual

HP

HP Storevirtual 4000 Guía de referencia rápida

HP

HP 705 Guía de inicio rápido

HP

HP Surestore Disk Array 12h - And FC60 Manual de usuario

HP

HP 6100 Guía de inicio rápido

Manuales populares de Almacenamiento de otras marcas

QNAP

QNAP TS 32PXU Series Manual de usuario

LaCie

LaCie RUGGED RAID Manual de usuario

Freecom

Freecom CLS DOCK Manual de usuario

PNY

PNY Attache P-FD64MBATT3 Manual de usuario

OLT

OLT 6x6 Maximizer Manual de usuario

Transcend

Transcend JetFlash 160 Manual de usuario

LaCie

LaCie RUGGED MINI Manual de usuario

Thunderbolt

Thunderbolt 600 Manual de usuario

Panasonic

Panasonic LB-DH8 series Manual

Intel

Intel RAID High Availability Manual de usuario

LaCie

LaCie 12big Thunderbolt 3 Manual de usuario

Spectra Logic

Spectra Logic T-Series Spectra T50e Manual de usuario

Panasonic

Panasonic LKM-F931-1 Manual de usuario

Tabernus

Tabernus Enterprise Erase E2400 Manual de usuario

Rocstor

Rocstor COMMANDER 3F series Manual de usuario

Western Digital

Western Digital Ultrastar Data60 Manual de usuario

Dell

Dell PowerVault MD3600f Series Manual de usuario

CFI

CFI TERA STOR SATA RAID IV Manual de usuario

Network Interface Upgrade

HP NETSTORAGE 6000

Configurations supported:

Any combination of one or two of the following

HP NICs is supported:

•10/100 b

•Dual 10/100 b

•Gigabit 1000 Base SX

Each NIC port must be attached to a different subnet.

runking is not supported.

Parts required:

•New NIC card

Tools required:

•Phillips screwdriver

•Electrostatic protection device

NOTES:

•Use only HP NetStorage 6000 Network Interface Cards for upgrades.

•For this upgrade, you should choose a time when end-user access is not required for the unit.

Shut own the System

Open the Case

A. Remove the two screws on the back of the unit that hold

the top in place.

B. Slide the top backwards, and lift to remove.

A. Shut down the unit using either the front panel interface

or the HP NetStorage web interface.

B. After system shutdown is complete, turn off the power

switch on the back panel of the unit.

C. Disconnect both power cords from the back panel of the

unit.

All manuals and user guides at all-guides.com

all-guides.com

A. Unplug the network cable.

B. Unscrew the existing NIC and gently remove it.

NOTE: If you are installing the NIC in an unused PCI slot,

remove the expansion slot access panel.

A. Select an open PCI slot.

B. Gently place the new card in the slot, and screw it into

place.

A. Slide the top back into place.

B. Using the screwdriver, secure the top to the unit.

Add or Remove a NIC Card

Insert the New Card

Close the Case

A.

B.

All manuals and user guides at all-guides.com

Connect the Unit

A. Connect a network cable to the new port(s).

B. Reconnect the two power cords on the back panel of the

HP NetStorage unit, and plug them into your power source.

C. urn on the unit.

. Press the alarm-reset button on the front panel to turn off

the alarm. he alarm sounds whenever the unit is powered on.

A. Follow one set of the directions below:

•If your system uses DHCP, the LCD panel will display the

IP address of the first NIC port. Move to Step 8.

•If your system does not use DHCP, use the LCD panel and

arrows to configure the IP address, Subnet mask, Broadcast

address, and Gateway address (if needed) for the newly installed

NIC. Move to Step 8.

NOTE: Only one Gateway address is supported, regardless of the

number of NIC ports installed.

Enter Network Information

A.

B.

.

A. Using a computer on the network, open a web browser and enter

the unit's IP address in the browser's address or location field.

B. Select Configuration > Network Settings.

C. ype in or verify the IP address and Subnet Mask for each new NIC

you installed.

. Click Apply.

Use a Web Browser to Enter Network Settings

All manuals and user guides at all-guides.com

*C4480-90101*

C4480-90101

All manuals and user guides at all-guides.com