Honeywell ADEMCO 5811 Manual de usuario

ADEMCO 5811

One Zone Door/Window Transmitter

Installation Instructions

Model 5811 is a single zone Door/Window

Transmitter, compatible with alarm systems

that support 5800 series wireless devices.

5811 has a unique serial number permanently

assigned during manufacture, which must be

entered into the control panel upon

installation. Refer to the panel’s installation

instructions for programming details.

NOTE: During programming of the control

unit, 5811 transmitters should be treated as

“RF” (i.e. supervised RF) Type.

MOUNTING

Choose a mounting location for 5811 where

the device is stationary and the magnet is

mounted to the moving part of the door or

window. To verify adequate signal strength

conduct Go/No Go tests (see control’s

instructions) on 5811 before mounting

permanently.

1. Install Battery by inserting one edge

under one of the two plastic battery

retainer clips, then pressing down firmly

to snap it beneath both clips; see

diagram.

2. Mount 5811 using double-faced tape

(supplied) by affixing it to the back of the

unit and mounting the unit in place. Use

screws (optional) if desired; see diagram.

Mount the magnet (supplied) near the

alignment marks on the case (see

Diagram).

3. Engage the case tabs (see diagram), then

rotate the housing to close. Engage latch

with firm pressure to close and lock.

BATTERY REMOVAL

1. Open housing by inserting a flat blade

screwdriver into latch and twisting gently.

2. Remove old battery cell using a small flat

screwdriver blade, as shown in the

diagram.

5811-005-V1

BATTERY

(+ SIDE UP)

REED

SWITCH

PRESS DOWN FIRMLY TO

SNAP BATTERY UNDER

BOTH CLIPS

MAGNET

ALIGNMENT

MARKS

INSERT BATTERY

EDGE UNDER ONE CLIP

BATTERY

RETAINER

CLIPS

5811-003-V2

REED

LATCH

MAGNET

MOUNTING

HOLES

MAX GAP

3/4"

CASE 

TABS

SCREWDRIVER

(NO)

5811-006-V1

SCREWDRIVER

(CORRECT)

SCREWDRIVER

(NO)

PLACE TIP OF FLAT SCREW

DRIVER BETWEEN EDGE OF

BATTERY AND PLASTIC CASE

AS SHOWN. POSITIONING

SCREWDRIVER AT ANY OTHER

CORNER MAY CAUSE DAMAGE

TO DEVICE.



CAREFULLY PRY UP WHILE

TWISTING TO REMOVE

BATTERY.

FEDERAL COMMUNICATIONS

COMMISSION STATEMENT: The user shall

not make any changes or modifications to the

equipment unless authorized by the

Installation Instructions or User Manual.

Unauthorized changes or modifications could

void the user's authority to operate the

equipment.

FCC / IC STATEMENT: This device

complies with Part 15 of the FCC Rules, and

RSS 210 of Industry Canada (IC). Operation

is subject to the following two conditions: (1)

This device may not cause harmful

interference (2) This device must accept any

interference received, including interference

that may cause undesired operation.

Cet appareil est conforme à la partie 15 des

règles de la FCC & de RSS 210 des

Industries Canada. Son fonctionnement est

soumis aux conditions suivantes: (1) Cet

appareil ne doit pas causer d' interferences

nuisibles. (2) Cet appareil doit accepter toute

interference reçue y compris les

interferences causant une reception

indésirable.

SPECIFICATIONS

Dimensions

2-1/8” (55mm) x 1-3/16” (30mm) x 1/4”

(7mm)

Operating Conditions

23°F (-5°C) to 120°F (50°C).

Relative Humidity 95%, (non-condensing)

Replacement Battery

CR2032 Renata/Panasonic/Sener.

WARRANTY INFORMATION

For the latest warranty information, please

visit:

www.honeywell.com/security/hsc/resources/

REFER TO THE INSTALLATION INSTRUCTIONS

FOR THE RECEIVER/CONTROL WITH WHICH

THIS DEVICE IS USED FOR DETAILS

REGARDING LIMITATIONS OF THE ENTIRE

ALARM SYSTEM.

Ê800-03928V1dŠ

800-03928V1 8/11 Rev. C

2 Corporate Center Drive, Suite 100

P.O. Box 9040, Melville, NY 11747

Tabla de contenidos

Otros manuales de Transmisor de Honeywell

Honeywell

Honeywell SMV 3000 Manual de usuario

Honeywell

Honeywell 5800MICRA Manual de usuario

Honeywell

Honeywell XNX Manual de usuario

Honeywell

Honeywell STD110 Manual de usuario

Honeywell

Honeywell ST 3000 Manual de usuario

Honeywell

Honeywell oneWireless XYR 6000 Manual de usuario

Honeywell

Honeywell oneWireless XYR 6000 Manual de usuario

Honeywell

Honeywell oneWireless XYR 6000 Manual de usuario

Honeywell

Honeywell 5878 Instrucciones de montaje

Honeywell

Honeywell ADEMCO 5869 Instrucciones de montaje

Honeywell

Honeywell STT850 Series Manual de usuario

Honeywell

Honeywell STT700 SmartLine Guía del usuario

Honeywell

Honeywell OELD Manual de usuario

Honeywell

Honeywell PEHA 450 FU-HS128 Manual de usuario

Honeywell

Honeywell APT2000 Series Manual de usuario

Honeywell

Honeywell ST 800 Series Manual de instrucciones

Honeywell

Honeywell PWTA40 Series Manual de usuario

Honeywell

Honeywell oneWireless XYR 6000 Manual de usuario

Honeywell

Honeywell SLN 700 Manual de usuario

Honeywell

Honeywell SMV800 Manual de usuario

Honeywell

Honeywell DACT-E3 Manual técnico

Honeywell

Honeywell STT850 SMARTLINE Manual de usuario

Honeywell

Honeywell ADEMCO 5878 Instrucciones de montaje

Honeywell

Honeywell SmartLine STIW400 Manual de usuario

Manuales populares de Transmisor de otras marcas

NIVELCO

NIVELCO EasyTREK SCA-300 Series Manual del propietario

Kamstrup

Kamstrup READy MTU Instrucciones de funcionamiento

Omega

Omega ZW Series Manual de usuario

ABB

ABB Field 264H Guía

Alinco

Alinco DJ-V17T Manual de usuario

Dejero

Dejero EnGo 3x Manual de usuario

Rosemount

Rosemount 4600 Manual de usuario

Speaka Professional

Speaka Professional 2342740 Manual de usuario

trubomat

trubomat GAB 1000 Manual de usuario

Teledyne Analytical Instruments

Teledyne Analytical Instruments LXT-380 Manual de usuario

Rondish

Rondish UT-11 Manual de usuario

MG 10JRE Manual de usuario

Burkert

Burkert 8177 Manual de usuario

Firetide

Firetide HotPort 3203 Manual

Tele Radio

Tele Radio T9-02 Manual de usuario

Rotronic

Rotronic HygroFlex HF3 Series Manual de usuario

Jamara

Jamara FCX6 Pro Tel Manual de usuario

Excalibur

Excalibur SoundMaster FM Transmitter 144 Manual de usuario