Honeywell TH9320WFV Manual de usuario

Installation Guide

Voice Controlled Thermostat

TH9320WFV

Voice Controlled Thermostat

1Home: Touch to display Home Screen.

2System: Touch to switch heating system on or off.

3Menu: Touch to display options. Start

here to set a programme schedule.

4Current Schedule: Change temperature setting

and select temporary or permanent hold.

5Indoor Conditions: Shows indoor temperature.

6Current Date and Time.

7Outdoor Conditions: Outdoor temperature

and humidity appears after registration.

8Current Status: Shows system

mode (heat on or off).

123

This document is intended to help you make a fast,

safe and trouble-free installation of the Honeywell

Voice Controlled Thermostat. The thermostat works as

a normal programmable thermostat, but when

connected to a Wi-Fi network it accepts a whole range

of voice commands, which is constantly being

expanded and improved.

Registering the thermostat with Honeywell and

downloading the ‘Total Connect Comfort Europe’

smartphone or tablet app allows access to the

thermostat from anywhere. A Wi-Fi connection is

required for voice control, so the thermostat should be

installed in a location with a good Wi-Fi signal. If signal

strength is poor, a Wi-Fi range extender may be

required.

Introduction

MAC ID:

MAC CRC:

Before you begin you will need:

• Toolkitwithscrewdriversandwire-strippers.

• ThehomeWi-Finetworkpassword.

• Dependingonthetypeofinstallation,alength

of mains cable may also be required.

• ThethermostatMACIDandMACCRCnumber,

which can be found on either:

– a label on the back of the thermostat

– the Register Online screen on the thermostat

during the registration process

– the screen at Menu > Wi-Fi Setup

after the thermostat has been

connected to your Wi-Fi system.

• For mounting on a ush wallbox of depth greater than 25mm.

• Wiring to terminals must be done before wallplate is screwed to wallbox.

• Product requires a permanent 230Vac mains power supply to operate

• Switch output is potential-free 24V … 230Vac

• Installation should be carried out by a competent person.

• All wiring must be in accordance with IEE regulations.

• This unit is for xed wiring only.

• A switch, having contact separation of at least 3mm in all poles must be incorporated in the

xed wiring as a means of disconnecting the supply.

• The system must be appropriately fused. A fuse rating of no more than 5Amps should be installed.

• The unit is Class II (double insulated ) so device earthing is not required. A hook is provided for

parking an earth wire.

Installation notes— read these prior to installation

1.1 Switch off power to your

heating system.

Isolate power supply at fused spur

and make safe before wiring.

For replacing an existing

room thermostat

1.2 Remove old thermostat, taking care

to note the function of each wire.

1.2a Your Voice Controlled Thermostat

requires a 4 wire connection. Live

and Neutral power supply from the

fused spur and a 2 wire contact

closure output to operate the boiler.

1.2b If insufficient wires are present

an extra cable will have to be run

to the thermostat. This should be

rated for 230Vac operation. Use of a

junction box in the system wiring is

recommended to avoid confusion.

Now go to Step 1.5 Connect wires.

Step 1: Wallplate installation and wiring

For new thermostat

installation

1.3 Install wallbox at proposed

thermostat location.

1.3a Identify a suitable thermostat location.

This should be on an internal wall

1.2 to 1.5m from the oor away from

any sources of heat or draughts.

1.3b Install a plastic ush wallbox of depth

greater than 25mm at this location.

1.4 Run wiring from fused spur to

new thermostat location.

1.4a Your Voice Controlled Thermostat

requires a 4 wire connection. Live

and Neutral power supply from the

fused spur and a 2 wire contact

closure output to operate the boiler.

1.4b Run cables to new thermostat

location. These should be rated

for 230Vac operation. Use of a

junction box in the system wiring is

recommended to avoid confusion.

Now go to Step 1.5 Connect wires.

Note: Further information and advice on locating

your thermostat can be found on Page 29.

1.5 Connect wires.

1.5a Strip back insulation from conductors

by 8mm.

1.5b Connect wires to terminals as shown by

pushing bare end of conductor into holes

in wiring terminals. The wires will be

gripped by the internal mechanism.

1.5c Check each wire is securely connected

by giving it a gentle pull.

8mm

N L C B A

Note: to disconnect any wire, press on the tab next

to it then pull the wire out from the terminal hole.

See Step 2: Wiring schematics for details.

Earth

Step 1: Wallplate installation and wiring continued

1.6 Mount Voice Controlled Thermostat

wallplate to wallbox.

Mount wallplate to wallbox using the screws

provided, taking care not to damage any

of the wires or wiring connections.

1.7 Attach thermostat to wallplate.

Align the thermostat with wallplate

and snap into place.

1.8 Switch heating system on.

Switch heating system on at fused spur and

verify that the thermostat display lights up.

Now go to Step 3: Set initial

thermostat conguration options.

Thermostat Wallplate

Wallbox

Internal wiring

N L C B A

230V

50-60Hz

5(3)A

24...230V

TH9320WFV

HEATING

COM

<5A

Step 2: Wiring schematics

P10

Tabla de contenidos

Otros manuales de Termostato de Honeywell

Honeywell

Honeywell T8095A Manual de usuario

Honeywell

Honeywell MagicStat T8132 Manual de usuario

Honeywell

Honeywell MagicStat CT3300 Especificaciones técnicas

Honeywell

Honeywell CT50A, CT51A, CT53A Manual de usuario

Honeywell

Honeywell RLV450 Manual de usuario

Honeywell

Honeywell Chronotherm IV T8611G Manual de usuario

Honeywell

Honeywell Tradeline T8511G Manual de usuario

Honeywell

Honeywell Lyric T6 Pro Wi-Fi Manual de usuario

Honeywell

Honeywell T6360 Manual de usuario

Honeywell

Honeywell T8000C Manual de usuario

Honeywell

Honeywell RTH2300 series Manual de usuario

Honeywell

Honeywell CT410A Manual de usuario

Honeywell

Honeywell CPFILA Manual de usuario

Honeywell

Honeywell Chronotherm modulation Manual de usuario

Honeywell

Honeywell RTH6500WF Wi-Fi Series Manual de usuario

Honeywell

Honeywell T4398A1021 - Electric Heat Thermostat Manual de operación

Honeywell

Honeywell Z-Wave Series Manual de usuario

Honeywell

Honeywell PRO 4000 Series Manual de usuario

Honeywell

Honeywell RTH9585 Wi-Fi Manual de usuario

Honeywell

Honeywell Lyric T6 Manual de usuario

Honeywell

Honeywell T8601D Manual de usuario

Honeywell

Honeywell EnergyPro T8665C Manual de usuario

Honeywell

Honeywell VisionPRO TH8110U Manual de usuario

Honeywell

Honeywell CENTRA LINE WEB-HMI4/C Manual de usuario

Manuales populares de Termostato de otras marcas

EWELLY

EWELLY EW-181 Manual de usuario

Prolon

Prolon T1100 Instrucciones de instalación

Computherm

Computherm Q20 Manual de usuario

Heatmiser

Heatmiser neoStat Manual de usuario

Aube Technologies

Aube Technologies TH111GFCI-NP 240 VCA Manual de usuario

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Manual de usuario

Saswell

Saswell SAS920XWHB-7-S-RF Guía

Aircalo

Aircalo TFP1-ET85P2 Manual de usuario

Carrier

Carrier DEBONAIR 33CS Manual de usuario

Lennox

Lennox iHarmony Zone Thermostat Instrucciones de montaje

Gemtech

Gemtech GT7000 Manual de instrucciones

Rollei

Rollei Smartes 45000 Manual de usuario

Sinope

Sinope TH1300RF Manual de usuario

NuTone

NuTone NTBZ48 Instrucciones de funcionamiento originales

Stelpro

Stelpro MAESTRO ASMT402AD Manual de usuario

Aube Technologies

Aube Technologies TH305 Manual de usuario

Powtier Controls

Powtier Controls 505MST Manual de usuario

Kanmor

Kanmor Zone Control 369e Manual de usuario