Honeywell HD3C Manual de usuario
Document 800-00788 – Rev C – 07/08
User Guide
3 Inch Dome Camera
NTSC / PAL
HD3C, HD3CB HD3CX, HD3CBX
HD3D, HD3DB HD3DX, HD3DBX
HD3CH, HD3CHB HD3CHX, HD3CHBX
Document 800-00788 Rev C 3
07/08
Warnings
Installation and servicing should be performed only by qualified and experienced
technicians to conform to all local codes and to maintain your warranty.
WARNING! The Use of CSA Certified/UL Listed Class 2 power adapters is
required to ensure compliance with electrical safety standards.
WEEE (Waste Electrical and Electronic Equipment). Correct disposal of this
product (applicable in the European Union and other European countries with
separate collection systems). This product should be disposed of, at the end of its
useful life, as per applicable local laws, regulations, and procedures.
Explanation of Graphical Symbols
RISK OF ELECTRIC
SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE THE COVER.
NO USER-SERVICEABLE PARTS INSIDE
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL
THIS SYMBOL INDICATES THAT
DANGEROUS VOLTAGE
CONSTITUTING A RISK OF
ELECTRIC SHOCK IS PRESENT
WITHIN THE UNIT.
THIS SYMBOL INDICATES THAT
IMPORTANT OPERATING AND
MAINTENANCE INSTRUCTIONS
ACCOMPANY THIS UNIT.
CAUTION
4
FCC Compliance Statement
Information to the User: This equipment has been tested and found to comply with
the limits for a Class B digital device. Pursuant to Part 15 of the FCC Rules, these
limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected
• Consult the dealer or a radio/TV technician for help.
Caution Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la Classe B est conforme à la norme NMB-003 du Canada.
Manufacturer’s Declaration of Conformance
The manufacturer declares that the equipment supplied with this guide is compliant
with the essential protection requirements of the EMA directive 89/336/EEC and the
Low Voltage Directive LVD 73/23 EEC, conforming to the requirements of standards
EN 55022 for emissions.
Document 800-00788 Rev C 5
07/08
Contents
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Before You Begin . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Unpack Everything . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Cautions and Operating Notes . . . . . . . . . . . . . . . . . . . . . . . 7
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Removing the Dome Cover . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Mounting the Camera. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Preparing the Mounting Surface
(Surface or Flush Mount) . . . . . . . . . . . . . . . . . . . . 10
Connecting the Wiring . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
4S Electrical Junction Box . . . . . . . . . . . . . . . . . . . 12
Surface Mount . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
Flush Mount . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Adjusting the Camera Position. . . . . . . . . . . . . . . . . . . . . . . 15
Optional Camera Settings . . . . . . . . . . . . . . . . . . . 16
Attaching the Dome Cover. . . . . . . . . . . . . . . . . . . . . . . . . . 18
Routine Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
Product Dimensions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
Warranty and Service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22
Cable Guidelines. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24
6
Document 800-00788 Rev C 7
07/08
Introduction
The unobtrusive, compact design of the HD3 Series 3 Inch Dome Camera
(HD3) is ideal for indoor installations in commercial and residential
environments.
Before You Begin
Unpack Everything
Check that the items received match those listed on the order form and
packing slip. The HD3 packing box should include, in addition to this Install
Guide:
• One fully assembled camera
• One hardware kit
• One 2nd video monitor output cable
• One mounting template
If any parts are missing or damaged, contact the dealer you purchased the
camera from or call Honeywell Customer Service (see p. 27 for contact
information).
Please read this guide carefully before you
install the HD3 Series 3 Inch Dome Camera.
Keep this guide for future reference.
8
Cautions and Operating Notes
Power Supply This dome camera can operate on 24 VAC or 12 VDC.
Operating Conditions Avoid:
• Viewing bright objects (example, light fixtures) for extended periods.
• Operating or storing the unit in the following locations:
• Extremely humid, dusty, hot/cold environments (where the
operating temperature is outside the recommended range of
14°F to 122°F [-10°C to +50°C])
• Close to sources of powerful electromagnetic radiation, such as
radio or TV transmitters
• Close to fluorescent lamps or objects reflecting light
• Under unstable light sources (may cause flickering)
10
Removing the Dome Cover
1. Gently turn the dome cover counter-clockwise (#5 on Figure 1) to
unlock, and pull free of the housing. If required, loosen the security
screw (#2) first.
2. Remove the inner liner (#4) by gently pulling it free of the two notches
(#3) in the housing (#1). Set the dome (and liner) aside.
Figure 1 Dome Cover Removal
1
5
4Legend
1Camera housing
2Security screw
3Notches (x2)
4Inner liner
5Dome cover
3
2
Otros manuales para HD3C
1
Este manual sirve para los siguientes modelos
11
Tabla de contenidos
Otros manuales de Cámara de seguridad de Honeywell
Honeywell
Honeywell PrimaView HD16 Manual de usuario
Honeywell
Honeywell HCU484 Manual de usuario
Honeywell
Honeywell H34S-IC Manual de usuario
Honeywell
Honeywell HD3DS Manual de usuario
Honeywell
Honeywell HD262 Manual de usuario
Honeywell
Honeywell HD41 Manual de usuario
Honeywell
Honeywell HD273H Manual de usuario
Honeywell
Honeywell 2450Cm Series Manual de usuario
Honeywell
Honeywell HCD95534 Manual de usuario
Honeywell
Honeywell HD4DIR Manual de usuario
Honeywell
Honeywell NightHawk HCD80484 Manual de usuario
Honeywell
Honeywell HED2PER3 Manual de usuario
Honeywell
Honeywell HD61X Manual de usuario
Honeywell
Honeywell HCCM474M Manual de usuario
Honeywell
Honeywell HB273H Manual de usuario
Honeywell
Honeywell 35 Series Manual de usuario
Honeywell
Honeywell VSD-261P Manual de usuario
Honeywell
Honeywell Ultrak CSC100 U Series Manual de usuario
Honeywell
Honeywell HSGN502 Manual de usuario
Honeywell
Honeywell HBW2PR2 Manual de usuario
