Honeywell Hyperion 1300G Manual de usuario

™

Hyperion 1300g

General Purpose Handheld Linear Scanner

User’s Guide

Disclaimer

Honeywell International Inc. (“HII”) reserves the right to make changes in speci-

fications and other information contained in this document without prior notice,

and the reader should in all cases consult HII to determine whether any such

changes have been made. The information in this publication does not repre-

sent a commitment on the part of HII.

HII shall not be liable for technical or editorial errors or omissions contained

herein; nor for incidental or consequential damages resulting from the furnish-

ing, performance, or use of this material.

This document contains proprietary information that is protected by copyright.

All rights are reserved. No part of this document may be photocopied, repro-

duced, or translated into another language without the prior written consent of

HII.

Other product names or marks mentioned in this document may be trademarks

or registered trademarks of other companies and are the property of their

respective owners.

Web Address: www.honeywellaidc.com

Chapter 1 - Getting Started

About This Manual ...................................................... 1-1

Unpacking the Scanner............................................... 1-1

Connecting with USB .................................................. 1-1

Connecting with Keyboard Wedge.............................. 1-2

Connecting with RS-232 Serial Port............................ 1-3

Connecting with RS485............................................... 1-3

Reading Techniques ................................................... 1-4

Menu Bar Code Security Settings ............................... 1-5

Chapter 2 - Programming the Interface

Introduction ................................................................. 2-1

Programming the Interface - Plug and Play ................ 2-1

Keyboard Wedge................................................... 2-1

Laptop Direct Connect........................................... 2-1

RS232 Serial Port.................................................. 2-2

RS485 ................................................................... 2-2

OPOS Mode.......................................................... 2-3

USB IBM SurePos................................................. 2-4

USB PC or Macintosh Keyboard........................... 2-5

USB HID POS ....................................................... 2-5

USB Serial Commands ............................................... 2-5

USB Serial Emulation............................................ 2-5

CTS/RTS Emulation.............................................. 2-6

ACK/NAK Mode..................................................... 2-6

Honeywell Bioptic Aux Port Configuration................... 2-6

Datalogic™ Magellan®Bioptic Aux Port

Configuration............................................................... 2-7

Wincor Mode A............................................................ 2-7

Keyboard Country Layout ........................................... 2-8

Keyboard Mode Options ........................................... 2-14

ALT Mode............................................................ 2-14

Keyboard Style.................................................... 2-15

Keyboard Modifiers ............................................. 2-16

Table of Contents

RS232 Modifiers ........................................................2-19

RS-232 Baud Rate...............................................2-19

RS-232 Word Length: Data Bits, Stop Bits, and

Parity....................................................................2-20

RS-232 Handshaking.................................................2-22

RTS/CTS .............................................................2-22

XON/XOFF ..........................................................2-22

ACK/NAK .............................................................2-22

Chapter 3 - Input/Output Settings

Good Read Indicators..................................................3-1

Beeper – Good Read.............................................3-1

Beeper Volume – Good Read................................3-1

Beeper Pitch – Good Read....................................3-2

Beeper Duration – Good Read ..............................3-2

Beeper Pitch – Error ..............................................3-3

LED – Good Read .................................................3-3

Number of Beeps – Good Read ............................3-3

Good Read Delay ........................................................3-4

User-Specified Good Read Delay..........................3-4

Trigger Modes..............................................................3-5

Manual/Serial Trigger ............................................3-5

Automatic Trigger ..................................................3-5

Presentation Mode.................................................3-6

Continuous Illumination Mode (Manual

Trigger only)...........................................................3-6

Hands Free Time-Out..................................................3-6

Reread Delay...............................................................3-7

User-Specified Reread Delay ................................3-8

Centering .....................................................................3-8

iii

Output Sequence Overview ...................................... 3-10

To Add an Output Sequence............................... 3-10

Other Programming Selections ........................... 3-11

Output Sequence Editor...................................... 3-11

Require Output Sequence................................... 3-11

Output Sequence Editor...................................... 3-13

Require Output Sequence................................... 3-13

Multiple Symbols ....................................................... 3-14

No Read .................................................................... 3-15

Video Reverse........................................................... 3-15

Chapter 4 - Data Editing

Prefix/Suffix Overview ................................................. 4-1

To Add a Prefix or Suffix ....................................... 4-1

To Clear One or All Prefixes or Suffixes................ 4-2

To Add a Carriage Return Suffix to All

Symbologies.......................................................... 4-3

Prefix Selections.................................................... 4-3

Suffix Selections.................................................... 4-4

Function Code Transmit........................................ 4-6

Intercharacter, Interfunction, and Intermessage

Delays ......................................................................... 4-6

Intercharacter Delay.............................................. 4-7

User Specified Intercharacter Delay...................... 4-7

Interfunction Delay ................................................ 4-8

Intermessage Delay .............................................. 4-8

Chapter 5 - Data Formatting

Data Format Editor Introduction .................................. 5-1

To Add a Data Format........................................... 5-1

Other Programming Selections ............................. 5-2

Interface / Terminal ID Table....................................... 5-4

Data Format Editor Commands...................................5-4

Send Commands ...................................................5-4

Move Commands...................................................5-7

Search Commands ................................................5-8

Miscellaneous Commands...................................5-10

Data Format Editor ..............................................5-14

Data Formatter.....................................................5-14

Chapter 6 - Symbologies

Introduction..................................................................6-1

All Symbologies ...........................................................6-2

Message Length ..........................................................6-2

Codabar.......................................................................6-3

Codabar Start/Stop Characters.............................6-3

Codabar Check Character .....................................6-4

Codabar Concatenation.........................................6-5

Codabar Message Length .....................................6-6

Code 39 .......................................................................6-7

Code 39 Start/Stop Characters .............................6-7

Code 39 Check Character .....................................6-7

Code 39 Message Length......................................6-8

Code 39 Append....................................................6-8

Code 32 Pharmaceutical (PARAF)..............................6-9

Full ASCII.............................................................6-10

Code 39 Code Page ............................................6-10

Interleaved 2 of 5.......................................................6-11

Check Digit ..........................................................6-11

Interleaved 2 of 5 Message Length .....................6-12

Code 93 .....................................................................6-13

Code 93 Message Length....................................6-13

Code 93 Code Page ............................................6-13

Straight 2 of 5 Industrial (three-bar start/stop)...........6-15

Straight 2 of 5 Industrial Message Length ...........6-15

Straight 2 of 5 IATA (two-bar start/stop) ....................6-16

Straight 2 of 5 IATA Message Length..................6-16

Matrix 2 of 5 .............................................................. 6-17

Matrix 2 of 5 Message Length............................. 6-17

Code 11..................................................................... 6-18

Check Digits Required......................................... 6-18

Code 11 Message Length ................................... 6-19

Code 128................................................................... 6-19

ISBT 128 Concatenation ..................................... 6-19

Code 128 Message Length ................................. 6-20

Code 128 Code Page.......................................... 6-20

Code 128 Function Code Transmit ..................... 6-21

Telepen ..................................................................... 6-21

Telepen Output.................................................... 6-22

Telepen Message Length.................................... 6-23

UPC A ....................................................................... 6-24

UPC A Check Digit.............................................. 6-24

UPC A Number System....................................... 6-25

UPC A Addenda.................................................. 6-25

UPC A Addenda Required .................................. 6-26

UPC A Addenda Separator ................................. 6-26

UPC-A/EAN-13

with Extended Coupon Code .................................. 6-27

UPC E ....................................................................... 6-28

UPC E0 and UPC E1 .......................................... 6-28

UPC E0 and UPC E1 Expand ............................. 6-29

UPC E0 and UPC E1 Addenda Required ........... 6-29

UPC E0 and UPC E1 Addenda Separator .......... 6-30

UPC E0 Check Digit............................................ 6-30

UPC E0 Number System..................................... 6-31

UPC E0 Addenda................................................ 6-31

EAN/JAN 13 .............................................................. 6-32

EAN/JAN 13 Check Digit..................................... 6-32

EAN/JAN 13 Addenda......................................... 6-33

EAN/JAN 13 Addenda Required ......................... 6-33

EAN/JAN 13 Addenda Separator........................ 6-34

ISBN Translate.................................................... 6-34

EAN/JAN 8.................................................................6-34

EAN/JAN 8 Check Digit .......................................6-35

EAN/JAN 8 Addenda ...........................................6-36

EAN/JAN 8 Addenda Required............................6-36

EAN/JAN 8 Addenda Separator ..........................6-37

MSI ............................................................................6-37

MSI Check Character ..........................................6-37

MSI Message Length...........................................6-38

Plessey Code.............................................................6-38

Plessey Message Length.....................................6-39

GS1 DataBar Omnidirectional ...................................6-39

GS1 DataBar Limited.................................................6-40

GS1 DataBar Expanded ............................................6-40

GS1 DataBar Expanded Message Length...........6-41

China Post Code........................................................6-41

Korea Post Code .......................................................6-43

Korea Post Message Length ...............................6-43

Codablock F...............................................................6-44

Codablock F Message Length .............................6-44

Code 49 .....................................................................6-45

Code 49 Message Length....................................6-45

Trioptic Code .............................................................6-46

GS1 Emulation...........................................................6-46

Label Code ................................................................6-47

Chapter 7 - Interface Keys

Keyboard Function Relationships................................7-1

Supported Interface Keys ............................................7-2

Chapter 8 - Utilities

To Add a Test Code I.D. Prefix to All Symbologies .....8-1

Show Software Revision..............................................8-1

Show Data Format.......................................................8-1

Resetting the Standard Product Defaults ....................8-2

vii

Chapter 9 - Serial Programming Commands

Conventions ................................................................ 9-1

Menu Command Syntax.............................................. 9-1

Query Commands ................................................. 9-2

Concatenation of Multiple Commands .................. 9-2

Responses ............................................................ 9-2

Examples of Query Commands ............................ 9-3

Trigger Commands ..................................................... 9-4

Resetting the Standard Product Defaults.................... 9-4

Menu Commands........................................................ 9-5

Chapter 10 - Product Specifications

Hyperion 1300g Product Specifications .................... 10-1

Standard Connector Pinouts ..................................... 10-2

Chapter 11 - Maintenance

Repairs...................................................................... 11-1

Maintenance.............................................................. 11-1

Cleaning the Device ............................................ 11-1

Inspecting Cords and Connectors....................... 11-1

Replacing the Interface Cable............................. 11-2

Troubleshooting ........................................................ 11-2

Chapter 12 - Customer Support

Product Service and Repair ...................................... 12-1

Limited Warranty ....................................................... 12-1

Appendix A

Symbology Chart.........................................................A-1

ASCII Conversion Chart (Code Page 1252) ...............A-2

Code Page Mapping of Printed Bar Codes .................A-5

viii

Otros manuales para Hyperion 1300G

Tabla de contenidos

Otros manuales de Lector de código de barras de Honeywell

Honeywell

Honeywell MK3480-30B104 - IS3480 QuantumE - Wired Desktop Barcode... Manual de usuario

Honeywell

Honeywell VoyagerGS 9590 Series Manual de usuario

Honeywell

Honeywell MK3780-71A38 Manual de usuario

Honeywell

Honeywell MS5145 - 00 Manual de usuario

Honeywell

Honeywell IS4921 Guía de configuración rápida

Honeywell

Honeywell Vuquest 3310g Manual de usuario

Honeywell

Honeywell HH1800 Manual de usuario

Honeywell

Honeywell ms2420 Manual de usuario

Honeywell

Honeywell DCS19W Manual de usuario

Honeywell

Honeywell Xenon XP 195 Series Manual de usuario

Honeywell

Honeywell YJ-HF5000 Manual de usuario

Honeywell

Honeywell 3800i Manual de usuario

Honeywell

Honeywell SF61 Manual de usuario

Honeywell

Honeywell 8680i Series Manual de usuario

Honeywell

Honeywell 1900GSR-2 Manual de usuario

Honeywell

Honeywell Solaris MS7820 Manual de usuario

Honeywell

Honeywell 5010 Manual de usuario

Honeywell

Honeywell MS9500 Voyager Series Manual de usuario

Honeywell

Honeywell Metrologic 3780 Manual de usuario

Honeywell

Honeywell Vuquest 3320g Manual de usuario

Honeywell

Honeywell Xenon 1900H Manual de usuario

Honeywell

Honeywell 2020 Manual de usuario

Honeywell

Honeywell ms2420 Manual de usuario

Honeywell

Honeywell MS9520 Voyager Manual de usuario

Manuales populares de Lector de código de barras de otras marcas

POSMicro

POSMicro Datalogic PowerScan D7100 Manual de usuario

Marson

Marson MT780 Guía de configuración rápida

NCR

NCR RealPOS Manual de usuario

Motorola

Motorola SE3300 Guía de configuración rápida

Element

Element P130BT Manual de usuario

Motorola

Motorola Symbol LS3008 Manual de instalación y operación

Meec tools

Meec tools OBD-II / VAG Manual de usuario

SICK

SICK CLP 100 Manual de usuario

Royal Tag SA

Royal Tag SA I-Read Manual de usuario

Welch Allyn

Welch Allyn IMAGETEAM 3800 Manual de usuario

Meteor

Meteor 8310 Manual de usuario

Denso

Denso BHT-500B Manual de usuario

Datalogic

Datalogic Heron HD3130 Manual de usuario

Motorola

Motorola MP6000 Instrucciones de montaje

Newland

Newland NLS-HR15-BT Manual de usuario

ARTDEV

ARTDEV AS-1310 Manual de usuario

Aopos

Aopos AS290 Manual de usuario

ENS

ENS 367-5455 Manual de usuario