Honeywell 3800 Linear Series Manual de usuario

™

3800/3900

Handheld Linear Imager

User’s Guide

Disclaimer

Honeywell International Inc. (“Honeywell”) reserves the right to make changes

in specifications and other information contained in this document without prior

notice, and the reader should in all cases consult Honeywell to determine

whether any such changes have been made. The information in this publication

does not represent a commitment on the part of Honeywell.

Honeywell shall not be liable for technical or editorial errors or omissions con-

tained herein; nor for incidental or consequential damages resulting from the

furnishing, performance, or use of this material.

This document contains proprietary information that is protected by copyright.

All rights are reserved. No part of this document may be photocopied, repro-

duced, or translated into another language without the prior written consent of

Honeywell.

Other product names or marks mentioned in this document may be trademarks

or registered trademarks of other companies and are the property of their

respective owners.

Web Address: www.honeywell.com/aidc

FCC Part 15 Subpart B Class B

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference

that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class

B digital device pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a res-

idential installation. This equipment generates, uses, and can radiate radio fre-

quency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. How-

ever, there is no guarantee that interference will not occur in a particular installa-

tion. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the fol-

lowing measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

• Consult the dealer or an experienced radio or television technician for help.

If necessary, the user should consult the dealer or an experienced radio/televi-

sion technician for additional suggestions. The user may find the following

booklet helpful: “Something About Interference.” This is available at FCC local

regional offices. Honeywell is not responsible for any radio or television interfer-

ence caused by unauthorized modifications of this equipment or the substitution

or attachment of connecting cables and equipment other than those specified

by Honeywell. The correction is the responsibility of the user. Use only

shielded data cables with this system.

Caution: Any changes or modifications made to this equipment not expressly

approved by Honeywell may void the FCC authorization to operate this equip-

ment.

Canadian Compliance

This Class B digital apparatus complies with Canadian ICES-003. Operation is

subject to the following conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference

that may cause undesired operation.

Conformité à la règlementation canadienne

Cet appareil numérique de la Classe B est conforme à la norme NMB-003 du

Canada. Son fonctionnement est assujetti aux conditions suivantes :

1. Cet appareil ne doit pas causer de brouillage préjudiciable.

2. Cet appareil doit pouvoir accepter tout brouillage reçu, y compris le

brouillage pouvant causer un fonctionnement indésirable.

CE Mark

The CE mark indicates compliance to 2004/108/EC EMC Directive with

Standards EN55022 CLASS B, EN55024, EN61000-3-2, EN61000-3-3.

In addition, complies to 2006/95/EC Low Voltage Directive, when

shipped with recommended power supply. For further information please con-

tact:

Honeywell Imaging & Mobility Europe BV

Nijverheidsweg 9-13

5627 BT Eindhoven

The Netherlands

Honeywell shall not be liable for use of our product with equipment (i.e., power

supplies, personal computers, etc.) that is not CE marked and does not comply

with the Low Voltage Directive.

LED Safety Statement

This device has been tested in accordance with IEC60825-1: 1993+A1+A2 LED

safety, and has been certified to be a Class 1 LED device.

For European Community Users

Honeywell complies with Directive 2002/96/EC OF THE EUROPEAN PARLIA-

MENT AND OF THE COUNCIL of 27 January 2003 on waste electrical and

electronic equipment (WEEE).

Waste Electrical and Electronic Equipment Information

This product has required the extraction and use of natural resources for its pro-

duction. It may contain hazardous substances that could impact health and the

environment, if not properly disposed. In order to avoid the dissemination of

those substances in our environment and to diminish the pressure on the natu-

ral resources, we encourage you to use the appropriate take-back systems for

product disposal. Those systems will reuse or recycle most of the materials of

the product you are disposing in a sound way.

The crossed out wheeled bin symbol informs you that the product should

not be disposed of along with municipal waste and invites you to use the

appropriate separate take-back systems for product disposal.

If you need more information on the collection, reuse, and recycling systems,

please contact your local or regional waste administration.

You may also contact your supplier for more information on the environmental

performances of this product.

UL and cUL Statement

UL and cUL listed: UL60950-1 and CSA C22.2 No.60950-1-03.

C-Tick Statement

Conforms to AS/NZS 3548.

Patents

Please refer to the product packaging for patent information.

Chapter 1 - Getting Started

Typical Applications for the 3900 ................................ 1-1

About This Manual ...................................................... 1-1

Unpacking the Scanner............................................... 1-1

3800 Scanner Identification......................................... 1-2

3900 Scanner Identification......................................... 1-2

Connecting the Scanner with Keyboard Wedge ......... 1-3

Mounting Information for the 3900 .............................. 1-4

Specular Zone....................................................... 1-5

Plug and Play .............................................................. 1-5

IBM 4683 Ports 5B, 9B, and 17 Interface.................... 1-7

USB Interface.............................................................. 1-8

OCIA Interface .......................................................... 1-10

NCR OCIA Short Format (8 Bit) Interface ................. 1-11

NCR OCIA Long Format (9 Bit) Interface.................. 1-11

Nixdorf OCIA Interface .............................................. 1-12

Serial Wedge............................................................. 1-12

Chapter 2 - Terminal Interfaces

Keyboard Wedge Connection ..................................... 2-1

Terminal ID.................................................................. 2-1

Supported Terminals................................................... 2-2

Keyboard Country ....................................................... 2-4

Keyboard Style............................................................ 2-4

Keyboard Modifiers ..................................................... 2-5

Serial Port Connection ................................................ 2-7

Baud Rate ............................................................. 2-8

RS-232 Word Length: Data Bits, Stop Bits,

and Parity......................................................... 2-8

RS-232 Handshaking .......................................... 2-11

Wand Emulation Connection............................... 2-11

Wand Emulation Transmission Rate................... 2-12

Wand Emulation Polarity..................................... 2-13

Wand Emulation Idle ........................................... 2-13

Table of Contents

PDF417 Wand Emulation ..........................................2-13

Data Block Size ...................................................2-14

Delay Between Blocks .........................................2-14

Overall Checksum ...............................................2-15

Chapter 3 - Output

Scan Rate....................................................................3-1

Beeper Volume............................................................3-1

Beeper Tone................................................................3-2

Scan Voting .................................................................3-2

Reduce Quiet Zone......................................................3-2

Reread Delay...............................................................3-3

Good Read Delay ........................................................3-4

Trigger Mode ...............................................................3-4

Chapter 4 - Data Editing

Prefix/Suffix Overview..................................................4-1

To Add a Prefix or Suffix:.......................................4-1

To Clear One or All Prefixes or Suffixes: ...............4-2

To Add a Carriage Return Suffix

to all Symbologies ............................................4-3

Prefix Selections ....................................................4-3

Suffix Selections ....................................................4-3

Symbology Chart .........................................................4-4

ASCII Conversion Chart (Code Page 1252)................4-5

Function Code Transmit ........................................4-6

Intercharacter, Interfunction,

and Intermessage Delays..........................................4-6

Intercharacter Delay ..............................................4-7

User Specified Intercharacter Delay ......................4-7

Interfunction Delay.................................................4-8

Intermessage Delay...............................................4-8

iii

Chapter 5 - Data Formatting

Data Format Editor Introduction .................................. 5-1

To Add a Data Format........................................... 5-1

Other Programming Selections ............................. 5-2

Data Format Editor Commands............................. 5-2

Data Format Editor................................................ 5-4

Data Formatter ...................................................... 5-5

Alternate Data Formats ......................................... 5-5

Chapter 6 - Secondary Interface

Secondary Code 39 Wand Emulation ......................... 6-1

Secondary RS-232 Connection................................... 6-1

Secondary Non Decoded Output Laser Emulation ..... 6-2

Non Decoded Output Laser Emulation

Transmission Rate.................................................... 6-2

Non Decoded Output Laser Emulation Polarity .......... 6-2

Non Decoded Laser Emulation Idle ............................ 6-3

Disabling the Secondary Interface .............................. 6-3

Secondary Trigger Mode............................................. 6-3

Chapter 7 - Symbologies

Introduction ................................................................. 7-1

All Symbologies........................................................... 7-1

Message Length Description....................................... 7-2

Codabar ...................................................................... 7-3

Start/Stop Characters ........................................... 7-3

Check Character ................................................... 7-3

Concatenation ....................................................... 7-4

Codabar Message Length..................................... 7-5

Code 39 .......................................................................7-6

Start/Stop Characters............................................7-6

Check Character....................................................7-6

Code 39 Message Length......................................7-7

Code 39 Append....................................................7-7

Code 32 Pharmaceutical (PARAF) ........................7-8

Full ASCII...............................................................7-9

Interleaved 2 of 5.......................................................7-10

Check Digit ..........................................................7-10

Interleaved 2 of 5 Message Length .....................7-11

Strict Decoding ....................................................7-11

Code 93 .....................................................................7-12

Code 93 Message Length....................................7-12

Straight 2 of 5 Industrial.............................................7-13

Straight 2 of 5 Industrial Message Length ...........7-13

Straight 2 of 5 IATA ...................................................7-14

Straight 2 of 5 IATA Message Length..................7-14

Matrix 2 of 5...............................................................7-15

Matrix 2 of 5 Message Length .............................7-15

Code 11 .....................................................................7-16

Check Digits Required .........................................7-16

Code 11 Message Length....................................7-17

Code 128 ...................................................................7-18

<GS> Substitution................................................7-18

Code 128 Message Length..................................7-19

Telepen......................................................................7-20

Telepen Output ....................................................7-20

Telepen Message Length ....................................7-21

UPC A........................................................................7-22

Check Digit ..........................................................7-22

Number System ...................................................7-22

Addenda ..............................................................7-23

Addenda Required...............................................7-23

Addenda Separator..............................................7-24

UPC Strict Decoding............................................7-24

Otros manuales para 3800 Linear Series

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Lector de código de barras de Honeywell

Honeywell

Honeywell MK7580-30A38-00-A - MS7580 Genesis - Wired Barcode... Manual de usuario

Honeywell

Honeywell VOYAGER 1202G BF Manual de usuario

Honeywell

Honeywell Quantum T 3580 Manual de usuario

Honeywell

Honeywell Xenon XP 195 Series Manual de usuario

Honeywell

Honeywell Fusion MS3780 Manual de usuario

Honeywell

Honeywell Solaris MS7820 Manual de usuario

Honeywell

Honeywell Granit XP 199 i Series Manual de usuario

Honeywell

Honeywell HF800 Series Manual de usuario

Honeywell

Honeywell MS4980 Manual de usuario

Honeywell

Honeywell 4600g Manual de usuario

Honeywell

Honeywell I-Class Mark II Manual de usuario

Honeywell

Honeywell 3820 Manual de usuario

Honeywell

Honeywell Xenon CCB01-010BT-BF Manual de usuario

Honeywell

Honeywell XL 800 Series Manual de usuario

Honeywell

Honeywell 1900GHD-2 Manual de usuario

Honeywell

Honeywell VOYAGER 1250G Manual de usuario

Honeywell

Honeywell XENON 1900 Manual de usuario

Honeywell

Honeywell 4600g Manual de usuario

Honeywell

Honeywell MS5145 - 00 Manual de usuario

Honeywell

Honeywell Granit 1920i Manual de usuario

Honeywell

Honeywell Eclipse MS5100 Series Manual de usuario

Honeywell

Honeywell Xenon 1900H Manual de usuario

Honeywell

Honeywell Voyager 1202G Manual de usuario

Honeywell

Honeywell 3820SR0C0B-0FA0E Manual de usuario

Manuales populares de Lector de código de barras de otras marcas

POSMicro

POSMicro Datalogic PowerScan D7100 Manual de usuario

Marson

Marson MT780 Guía de configuración rápida

NCR

NCR RealPOS Manual de usuario

Motorola

Motorola SE3300 Guía de configuración rápida

Element

Element P130BT Manual de usuario

Motorola

Motorola Symbol LS3008 Manual de instalación y operación

Meec tools

Meec tools OBD-II / VAG Manual de usuario

SICK

SICK CLP 100 Manual de usuario

Royal Tag SA

Royal Tag SA I-Read Manual de usuario

Welch Allyn

Welch Allyn IMAGETEAM 3800 Manual de usuario

Meteor

Meteor 8310 Manual de usuario

Denso

Denso BHT-500B Manual de usuario

Datalogic

Datalogic Heron HD3130 Manual de usuario

Motorola

Motorola MP6000 Instrucciones de montaje

Newland

Newland NLS-HR15-BT Manual de usuario

ARTDEV

ARTDEV AS-1310 Manual de usuario

Aopos

Aopos AS290 Manual de usuario

ENS

ENS 367-5455 Manual de usuario