Holman 31080C Manual de usuario
Holman
Rancho Cordova, CA 95742
800-343-7486
InstallationSupport@Holman.com
20221104R1 DATE: ________________
Instruction Guide
31080C
Instructions –31080C
For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST) Page 1
PLEASE READ ALL INSTRUCTIONS AND WARNINGS PRIOR TO ASSEMBLING,
INSTALLING, AND USING THIS PRODUCT.
Warning
Always check for wires, fuel tanks and lines, brake lines and other important
vehicle functionality items prior to drilling and installing all products.
Tools Needed
1/2” Socket and Socket Wrench
1/2” Box Wrench
Table of Contents
Before You Begin.................................................................................................................................1
Parts .....................................................................................................................................................1
Hardware..............................................................................................................................................2
Step 1 –Prepare Tube Clamps (1-5/8” Tube Rack Only) ..................................................................2
Step 2 –Install Window Guard............................................................................................................3
Before You Begin
Read all instructions prior to assembling or installing any Holman product.
Always locate your installation locations prior to performing any work.
Parts
Instructions –31080C
For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST) Page 2
Hardware
Step 1 –Prepare Tube Clamps (1-5/8” Diameter Tubing Only)
If using 1-5/8” Diameter Tubing, the spacer strips must be applied to ensure a snug fit to rack.
Dry wipe clean inside diameter of tube clamps.
Remove backing from a spacer strip.
Stick backing to inside of tube clamp.
Repeat for remaining tube clamps.
Instructions –31080C
For Technical Support Call: 800-343-7486, Monday-Friday, 7AM - 4 PM (PST) Page 3
Step 2 –Install Window Guard
Place tube clamps around the front legs of rack with flat end of flange towards the rear.
Put and hold window guard into position with flat face facing towards the rear.
For each tube clamp, use a 5/16” x 3/4” hex bolts, two 5/16” flat washers, and a 5/16”lock nut to
loosely bolt through the tube clamp, then the window guard.
Snug tighten hardware but allow for movement of the window guard.
Holding the window guard level and centered to vehicle, tighten hardware.
GO BACK AND TIGHTEN ALL HARDWARE.
INSTALLATION AND ASSEMBLY ARE COMPLETE.
View from front of
vehicle for clarity.
View from front of
vehicle for clarity.
1-5/8” Diameter Tubing Rack
Installation Shown Here.
Tabla de contenidos
Otros manuales de Accesorios para automóviles de Holman
Holman
Holman 4A822 Manual
Holman
Holman 12006 Manual de usuario
Holman
Holman 40983 Manual
Holman
Holman 48401 Manual de usuario
Holman
Holman 4097M Manual
Holman
Holman 40913 Manual de usuario
Holman
Holman 31110 Manual de usuario
Holman
Holman 4A80L Manual de usuario
Holman
Holman 8012A Manual
Holman
Holman 4A91H Manual
