Heritage Bathrooms TSBC00 Instrucciones de montaje

Models covered:

TSBC00 Basin Taps

TSBC01 Bath Taps

Please keep this booklet for future reference.

Installer: when you have read these

instructions please ensure you leave them

with the user.

Somersby Tap Range

Installation Instructions

and User Guide

www.divapor.com

Contents

When you buy a Heritage product, you can be confident that it not only features a beautiful,

distinctive, classic design, but that it has also been made to the very highest quality standards.

To ensure that it works to its full potential, it needs to be fitted correctly.

These fitting instructions have been created to give you all of the information you need and,

if you need any further help, please do not hesitate to give us a call on 0844 701 8503.

Important Safety Information 02

General Specifications 02

Dimensions 03

Installation 04

Maintenance 05-06

Map of Hard Water Regions 07

Troubleshooting 08

Guarantee 09-10

www.divapor.com

Before starting any installation project please consider the following:

•Prior to drilling into walls, check there are no hidden electrical wires or cables or water supply

pipes with the aid of an electrical detector.

•If you use power tools do not forget:

- Wear eye protection.

- Unplug equipment after use.

•This product must not be modified in any way as this will invalidate the guarantee.

•These fittings need to be installed in accordance with and meet the requirements of the Water

Supply (Water Fittings) Regulations 1999 and Scottish Byelaws 2004.

Safety Note

•Please read these instructions & retain for future use. All products manufactured & supplied

by Heritage are safe, provided they are installed correctly, used correctly, and receive regular

maintenance in accordance with these instructions.

•If you are in any doubt about your ability to install this product safely you must employ

the services of an experienced, qualified plumber.

General Specifications

Operating pressure range (bar) Min Max

Basin Taps 0.2 5.0

Bath Taps 0.2 5.0

Maximum static pressure – 10.0 bar

NOTE:- Nominally equal (balanced) inlet supply pressures are recommended for optimum

Performance of mixer taps.

Designed to comply with BS EN 200 for single taps / combination taps for water systems of type 1 and

2 general technical specifications; and to be used within systems designed to BS 6700.

BS 6700 recommends the temperature of stored water should never exceed 65°C.A stored water

temperature of 60°C is considered sufficient to meet all nominal requirements and will minimise

the build up of lime scale in hard water areas.

www.divapor.com

Dimensions

Basin Taps (TBC00)

Bath Taps (TBC01)

100

G1/2”

116

103

153

112

G3/4”

www.divapor.com

Installation

1. Indice x2

2. Handle Screw x2

3. Lever Handle x2

4. Spline Adapter x2

5. Valve x2

6. Tap Body x2

7. Plinth x3

8. Rubber ‘O’ Ring x3

9. Rubber Washer x3

10. Backnut x2

11. Locking Pin x2

12. Anti-Splash x2

1. Identify all components are present prior to starting installation.

2. Ensure that the rubber ‘O’ ring (8) is fitted to the underside of the plinth (7); slide onto the

threaded tail and install the taps to the basin.

3. Using the washer (9) and backnut (10) secure the taps to the basin by tightening the backnut on

the underside of the basin.A suitable spanner may be required to fully tighten the backnut (10)

and secure the tap into the desired position.

4. Connect the hot and cold water supplies to the taps.

5. Turn on the water supplies and open both taps letting the water flow for a few minutes to

check all joints and connections for any leaks.

www.divapor.com

General Cleaning

Your fitting has a high quality finish and should be treated with care to preserve the visible

surfaces.All finishes will wear if not cleaned correctly.The only safe way to clean your product is

to wipe with a soft damp cloth. Stains can be removed using washing up liquid.All bathroom

cleaning products (powders and liquids) will damage the surface of your fitting, even the non-

scratch cleaners.

Note: Never use abrasive detergents or disinfectants or those containing alcohol, hydrochloric

acid or phosphoric acid.

See map of Hard Water Regions on page 07 to see the water type in your area

Maintenance

www.divapor.com

Maintenance cont.

We advise that your fitting is regularly serviced in

hard water areas to maintain optimum

performance; see map of Hard Water Regions on

page 07.

If your fitting begins to leak the following should

be carried out;

Isolate both hot and cold water supplies to the

tap by either:

•Turning the water supply off at the mains

stopcock or

•Turning off the isolation valves to the tap.

1. Remove the indice at the top of the handle

to reveal the concealed screw.

2. Remove the screw and pull the handle

upwards from the spline adapter and valve.

3. Using a suitable spanner remove the valve

from the tap body.

4. Clean the valve and the seating inside the tap

body.

5. If necessary replace the valve.

Please visit www.heritagebathrooms.com in

order to find spare parts for this product.

6. Replace the valve into the tap body and

tighten fully using a suitable spanner.

7. Re-connect handle assembly.

8. Turn on water supply and check for leaks.

9. Contact our helpline should if problem

persists.

Cleaning the Valves Within The Side Bodies

Spline Adapter

Valve

Ta p B o d y

Handle

Indice

Screw

www.divapor.com

Hard to very hard

Above 200mg/l as

calcium carbonate

equivalent

Soft to

moderately soft

0 - 100mg/l as

calcium carbonate

equivalent

Slightly hard to

moderately hard

100 - 200mg/l as

calcium carbonate

equivalent

Map of Hard Water Regions

www.divapor.com

Symptom Cause Remedy

No flow or poor flow rate. Partially closed stop or service valve in

water supply pipework to the tap.

Open stop or service valve.

Head of water is below the minimum

distance required.

Refer to the Specification section for

minimum pressures required.

Possible airlock / blockage in supply

pipework

Remove water supplies from the fitting

and flush the system to remove any

airlocks / debris.

Cartridge / Valve not opening fully. Service fitting. Refer to maintenance

section on page 5-6.

Water dripping for a few

seconds after the tap has

been turned off.

This is caused by ‘capillary action’ and

residual water in the spout being

siphoned out. This should only last for a

couple of seconds.

Constant dripping / leaking

when the tap is not in use.

Cartridge / Valve not fully shutting off. Service fitting and replace cartridge /

valve. Refer to maintenance section on

page 5-6.

Fitting does not turn on. Water supplies not turned on. Check that the water supplies to the

fitting are turned on.

Closed stop or service valve. Open stop or service valve.

Water does not come out

of the showerhead when

using the bath shower

mixer.

Diverter mechanism not fully open. Open the diverter mechanism fully by

pulling the diverter knob up.

Insufficient water pressure / header

height.

Refer to the specification section for

minimum pressures required.

Troubleshooting

www.divapor.com

Heritage Bathrooms Guarantee

When you buy a Heritage product, you can be confident that it not only features distinctive design, but that

it has also been made to meet our rigorous quality standards.

We offer robust guarantees and an attentive aftercare service to ensure that if you do experience any

issues, we can deal with a problem quickly, and effectively.

Please note that guarantees are only valid with proof of purchase.

Our guarantees are as follows:

identify the product and give you the best advice. It also means that you won’t have to keep your proof of

purchase to validate your guarantee. To register, simply go online at www.heritagebathrooms.com/register

GuaranteeTerms and Conditions

This guarantee is in addition to your statutory and other legal rights and is subject to the following

conditions:

The product was purchased within the United Kingdom or Republic of Ireland

The product is used in domestic applications only

The guarantee applies solely to the original purchaser with proof of purchase

The installation must allow ready access to all products for the purpose of inspection, maintenance or

replacement

Repair under this guarantee does not extend the original expiry date. The guarantee on any

replacement parts or product ends at the original expiry date

Any part found to be defective during the guarantee period will be replaced without charge, providing that

the product has been installed in accordance with the instructions given in this guide and used as the

manufacturer intended. If the product is no longer available, Heritage will endeavour to provide the nearest

equivalent.

2 Years on

Mirrors &

WC Seats

5 Years on

Bath Screens,

Furniture,

Shower Valves,

Taps, Wastes

& Accessories

Lifetime Guarantee

on Acrylic &

Cast Iron Baths

And Sanitaryware

www.divapor.com

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Producto de plomería de Heritage Bathrooms

Heritage Bathrooms

Heritage Bathrooms THC15CI Manual de usuario

Heritage Bathrooms

Heritage Bathrooms TSBC04 Manual de usuario

Heritage Bathrooms

Heritage Bathrooms TSBC10 Manual de usuario

Heritage Bathrooms

Heritage Bathrooms PGRW02 Manual de usuario

Heritage Bathrooms

Heritage Bathrooms Clifton Manual de usuario

Heritage Bathrooms

Heritage Bathrooms Granley Deco PGDW02 Manual de usuario

Heritage Bathrooms

Heritage Bathrooms Granley Manual de usuario

Heritage Bathrooms

Heritage Bathrooms Hartlebury THRC01 Instrucciones de montaje

Heritage Bathrooms

Heritage Bathrooms TDCC00 Instrucciones de montaje

Heritage Bathrooms

Heritage Bathrooms Glastonbury TGRC00 Instrucciones de montaje

Heritage Bathrooms

Heritage Bathrooms THA21 Manual de usuario

Heritage Bathrooms

Heritage Bathrooms CC00 Manual de usuario

Heritage Bathrooms

Heritage Bathrooms Dartmouth SDABL01 Diagrama de cableado

Heritage Bathrooms

Heritage Bathrooms SSAC02 Diagrama de cableado

Heritage Bathrooms

Heritage Bathrooms TDCG00 Instrucciones de montaje

Heritage Bathrooms

Heritage Bathrooms CC01 Manual de usuario

Heritage Bathrooms

Heritage Bathrooms Dawlish TDCC04 Instrucciones de montaje

Heritage Bathrooms

Heritage Bathrooms TSBC06 Manual de usuario

Heritage Bathrooms

Heritage Bathrooms TGRDC00 Instrucciones de montaje

Heritage Bathrooms

Heritage Bathrooms THA16 Manual de usuario

Heritage Bathrooms

Heritage Bathrooms PGRW01L Manual de usuario

Heritage Bathrooms

Heritage Bathrooms Lymington TLYCG00 Manual de usuario

Heritage Bathrooms

Heritage Bathrooms Glastonbury TGRC04 Manual de usuario

Heritage Bathrooms

Heritage Bathrooms THA11 Manual de usuario

Manuales populares de Producto de plomería de otras marcas

Weka

Weka 506.2020.00E Instrucciones de funcionamiento

Kohler

Kohler K-6228 Instrucciones de montaje

UBERHAUS DESIGN

UBERHAUS DESIGN 75175017 Manual de usuario

American Standard

American Standard DetectLink 6072121 Manual de usuario

Uponor

Uponor Contec TS Manual de usuario

Pfister

Pfister Selia 49-SL Manual de usuario

Fortis

Fortis VITRINA 6068700 Manual de usuario

Fortis

Fortis MILANO 78211JS Manual de usuario

Kohler

Kohler K-12183 Instrucciones de montaje

Maxxus

Maxxus MX-M206-01 Manual de usuario

Moen

Moen 5922 Series Manual de usuario

Viega

Viega Prevista Pure 8512 Manual de usuario

Kohler

Kohler Centerset K-15240 Instrucciones de montaje

Viega

Viega Prevista Dry 8522.33 Manual de usuario

Sanela

Sanela Lema SLP 59RB Manual de usuario

Elkay

Elkay EDF15AC Manual de instalación

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Manual

baliv

baliv WT-140 Manual de usuario