Heath Zenith 598-1215-01 Manual de usuario

Bowling Green, KY 42101

Premium Hardwired

Electronic Chime

Owner’s Manual

-2- 598-1215-01

PREMIUM ELECTRONIC CHIME

PACKAGE CONTENTS

• 1 - Cover with Base Enclosed

• 3 - 45" (114 cm) Brass Chime Tubes

Hardware Kit

• 3 - Tube Spring Hangers

• 2 - #8 x 1.5" Screws

• 2 - #8 Wall Anchors

IMPORTANT: Front is hinged

on left side. Be careful when

opening.DONOT overextend

the front door when opening

or damage to hinges may

occur.

Pull From Here to Open

-3- 598-1215-01

CHIME INSTALLATION

IMPORTANT: Proper installation requires a diode on the front

door push button. See Diode Installation Instructions (page 5)

after completing steps 1 through 10 below.

Note: Electrical work must be in accordance with national and local

electrical codes. If in doubt, consult a qualiﬁed electrician.

1. Verify transformer power rating. Power must be supplied from

a 16 Volt AC, 10 Watt or a 16 Volt AC, 15 Watt transformer

(Heath®/Zenith models 122C, 121AC, or 125C).

2. Remove cover from existing chime.

3. Labelall wiresbefore disconnecting.Using maskingtape, mark

each wire according to existing chime terminal markings.

• “F” – Front Push Button Wire

• “T” – Transformer Wire

• “R” – Rear Push Button Wire*

4. Disconnect all wires from existing chime.

5. Remove existing chime base from wall.

6. Determinechimemountinglocation. IMPORTANT:Thischime

requires more mounting surface than most other chimes. Use

the dimensions in Figure 1 to help determine the proper loca-

tion of the chime. If chime will not ﬁt in the same location as

the existing chime, then contact a licensed electrician to move

the existing wiring to a more suitable location.

Illustrations may vary from actual chime unit.

Figure 1 - Chime Dimensions

Continued

51 3/8"

58 1/2"

12 11/16"

Wire Entrance Hole

Mounting

Hole (x2)

-4- 598-1215-01

7. Mount chime cover with base to wall using screws and anchors

provided.

• Use the dimensions shown in Figure 2 to properly locate

mounting holes.

• Drill 1/4" (6.4 mm) diameter pilot hole and insert wall an-

chors.

• Insertmountingscrewsintowallanchors(leaveapproximately

5/8" (15.9 mm) of the screw threads exposed).

• Route wires through wire entrance hole in new chime base.

• Align mounting keyholes on rear of chime with screws and

place cover on screws.

• Tighten screws securely.

8. Remove 3/8" (9.5 mm) of insulation from each wire and push

wires into the chime quick connects (See Figure 3).

• Push wire “F” into ﬁrst quick connect terminal.

• Push wire “T” into second quick connect terminal.

• Push wire “R” into third quick connect terminal.

9. Connect diode to front push button (see page 5).

10. Press push button to verify chime works properly. If chime does

not complete eight-note melody, see Troubleshooting, page 8.

* Note: Some installations may not include rear door push button.

Figure 2 - Mounting Screw Location Dimensions

Figure 3 - Connecting Wires to Chime

3/8"

FTR

Chime Wire

Quick Connects

To Remove Wires,

Depress Orange Tab

While Pulling Wire Out

of Quick Connect

-5- 598-1215-01

DIODE INSTALLATION INSTRUCTIONS

A small electrical component called a “diode” is required for this chime to play the entire eight-note tune.This diode

must be installed on the terminal screws of the front door push button (see Figure 4). If not already installed on push

button, attach supplied diode as shown below. If, with the diode in place, the chime does not play the complete eight-note melody, see

Troubleshooting, page 8.

Figure 4 - Attaching Diode to Front Door Push Button

Diode

Front Door Push Button

(Styles May Vary)

-6- 598-1215-01

ATTACHING TUBES TO CHIME

Attach Spring Hangers to Brass Tubes

1. Locate the drilled holes in one end of each tube (see Figure 5).

2. Insert one end of spring hanger into one hole.

3. Compress the hanger just enough to insert the other end into

the second hole.

Hang Brass Tubes in Chime

1. Insert tubes through opening in the bottom of the chime (see

Figure 6).

2. Hangthe tubes on the hangingbrackets using the springhangers

installed above.

Note: Make sure the spring hanger is securely seated in the notch

on the hanging bracket.

Figure 5 - Attaching Spring Hangers to Brass Tubes

Figure 6 - Hanging Brass Tubes in Chime

Hanging Bracket

Spring Hanger

Brass Chime Tube

Spring Hanger

Compress

-7- 598-1215-01

CHIME CONTROLS AND FEATURES

• Volume Control - Rotate volume control to set chime volume as

desired.

• Power “ON” LED - The red LED (Light Emitting Diode) is on

when the unit is properly wired. See Troubleshooting, page 8, if

LED is not on.

• Front Door Tune Selector - This switch allows you to choose

one of four different front door tunes.

• Rear DoorTune Selector - This switch allows you to choose one

of two different rear door tunes.

Door/Trans Input

(16 V AC, 10 VA)

F T R

Use Diode On

Front Door Button

Rear Tune

Selector

TR-0055

390-0055XX-TR1A

READ

OWNER’S MANUAL

A B

Front Tune

Selector

Chime Controls

Located On Side

1 2 3 4 Power

LED

Volume

Control

FTR

Figure 7 - Chime Controls

Volume Control

Rear Door

Tune Selector

Front Door

Tune Selector

Instruction Label

Located On Side

of Control Module

-8- 598-1215-01

TROUBLESHOOTING

Chime does not sound:

• Check Chime: Disconnect wire from terminal marked “T”. Have someone operate push button at front door while you momentarily

touch the “T” wire to terminal marked “F”. You will see a small spark if push button, wiring, and transformer are operating properly.

Repeat the steps for “R” terminal and rear push button. If wiring between transformer and push button(s) check out properly, replace

chime.

• Check Transformer: Test transformer voltage output with a volt meter. If a volt meter is not available, momentarily touch the two

low-voltage terminals with a screwdriver.You will see a small spark if transformer is operating properly. If no spark is evident, replace

transformer.

• Check Push Button(s): Remove suspected push button from door frame, disconnect wire from terminals and touch bare wires

together. If chime operates, push button is defective. Replace push button.

Chime sounds but does not complete Westminster or Whittington (if applicable) tune:

• Check Diode on Front Push Button: Verify diode is attached securely to push button (see page 5). Chime may not function

properly if a diode is installed on more than one push button. Note: Some push buttons have pre-installed diodes. An additional diode

should not be added if the push button has a pre-installed diode. If eight-note tune still does not sound completely, replace diode (Type

1N4001-50V-1A, available at local electrical component supplier).

-9- 598-1215-01

FIVE YEAR LIMITED WARRANTY

This is a “Limited Warranty” which gives you speciﬁc legal rights. You may also have other rights which vary from state to state or province to province.

For a period of ﬁve years from the date of purchase, any malfunction caused by factory defective parts or workmanship will be corrected at no charge to

you.

Not Covered - Repair service, adjustment and calibration due to misuse, abuse or negligence, light bulbs, batteries, and other expendable items are not

covered by this warranty. Unauthorized service or modiﬁcation of the product or of any furnished component will void this warranty in its entirety. This war-

ranty does not include reimbursement for inconvenience, installation, setup time, loss of use, unauthorized service, or return shipping charges.

This warranty covers only HeathCo LLC assembled products and is not extended to other equipment and components that a customer uses in conjunction

with our products.

THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTY, REPRESENTATION

OR CONDITION OF MERCHANT ABILITY OR THAT THE PRODUCTS ARE FIT FOR ANY PARTICULAR PURPOSE OR USE, AND SPECIFICALLY IN

LIEU OF ALL SPECIAL, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES.

REPAIR OR REPLACEMENT SHALL BETHE SOLE REMEDY OF THE CUSTOMER AND THERE SHALL BE NO LIABILITY ON THE PART OF HEATHCO

LLC FOR ANY SPECIAL, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO ANY LOSS OF BUSINESS

OR PROFITS, WHETHER OR NOT FORESEEABLE. Some states or provinces do not allow the exclusion or limitation of incidental or consequential dam-

ages, so the above limitation or exclusion may not apply to you. Please keep your dated sales receipt, it is required for all warranty requests.

HeathCo LLC reserves the right to discontinue and to change speciﬁcations at any time without notice without incurring any obligation to incorporate new features in

previously sold products.

TECHNICAL SERVICE

Please call 1-800-858-8501 (English speaking only) for assistance before returning product to store.

If you experience a problem, follow this guide. You may also want to visit our Web site at: www.hzsupport.com. If the problem per-

sists, call* for assistance at 1-800-858-8501, 7:30 AM to 4:30 PM CST (M-F). You may also write* to:

HeathCo LLC

P.O. Box 90004, Bowling Green, KY 42102-9004

ATTN: Technical Service

* If contacting Technical Service, please have the following information available: Model Number, Date of Purchase, and Place of Pur-

chase.

No Service Parts Available for this Product

-10- 598-1215-01

Chime System Wiring Diagram

FRONT TRANS REAR

Transformer

Front Door

Push Button

With Diode

Chime

Rear Door

Push Button

(If Applicable) Illustration may vary from actual chime unit.

Tabla de contenidos

Idiomas:

Otros manuales de Accesorios de Heath Zenith

Heath Zenith

Heath Zenith 6180 Series Manual de usuario

Heath Zenith

Heath Zenith Wireless Strobe Chime 6144 Manual de usuario

Heath Zenith

Heath Zenith Notifi elite Manual de usuario

Heath Zenith

Heath Zenith Notifi Elite Manual de usuario

Heath Zenith

Heath Zenith Wireless Christmas Chime 598-1127-03 Manual de usuario

Heath Zenith

Heath Zenith 121AC Manual de usuario

Heath Zenith

Heath Zenith 5610 Manual de usuario

Heath Zenith

Heath Zenith Wireless Push Button Accessory SL-6190... Manual de usuario

Heath Zenith

Heath Zenith 3106978 (AC-6196) Manual de usuario

Heath Zenith

Heath Zenith 598-1109-06 Manual de usuario

Heath Zenith

Heath Zenith 7309 Manual de usuario

Heath Zenith

Heath Zenith SL-7464-03 Manual de usuario

Heath Zenith

Heath Zenith DualBrite Replacement Sensor Head 2LBN3 Manual de servicio

Heath Zenith

Heath Zenith 7762 Manual de usuario

Heath Zenith

Heath Zenith Hardwired Electronic Chime 598-1113-05 Manual de usuario

Heath Zenith

Heath Zenith Wireless Push Button Accessory 598-1105-06 Manual de usuario

Heath Zenith

Heath Zenith DUAL BRITE SL-5597 Manual de usuario

Heath Zenith

Heath Zenith Weatherproof Long Range Wireless Chime with Chime Extender... Manual de usuario

Heath Zenith

Heath Zenith SL-6166 Manual de usuario

Heath Zenith

Heath Zenith Motion Sensing 3-Way Wall Switch 6107 Manual de usuario

Heath Zenith

Heath Zenith Notifi Elite Manual de usuario

Heath Zenith

Heath Zenith 7143 Manual de usuario

Heath Zenith

Heath Zenith 7750 Manual de usuario

Heath Zenith

Heath Zenith 29 Manual de usuario

Manuales populares de Accesorios de otras marcas

Hillco

Hillco 2810 Manual de usuario

Siemens

Siemens QSA2700D Manual del operador

Contours

Contours ZY024 Manual de usuario

Saivod

Saivod VS621 Manual de usuario

Virtuox

Virtuox VirtuCLEAN 2.0 Manual de usuario

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Manual de usuario

Z-Wave

Z-Wave HSD-200Z Manual de usuario

turck

turck FMX-IM-2UPLI63FX Manual de usuario

Decagon Devices

Decagon Devices 10HS Manual de usuario

UPPAbaby

UPPAbaby Cup Holder Manual de usuario

Elko

Elko SmartSensor Leakage Wireless Manual de usuario

Grizzly

Grizzly H8371 Manual de usuario

Panasonic

Panasonic HG-T Series Manual de usuario

IFM Electronic

IFM Electronic Efector 250 Series Guía de referencia

DigiDesign

DigiDesign 888/24 I/O Manual de usuario

PROZIS

PROZIS QUAY Manual de usuario

patagonia

patagonia PSI Vest Manual de usuario

SFC Energy

SFC Energy EFOY GO! Manual de usuario