Hanna Instruments AquaDip Manual de usuario

InstructionManual

AquaDip

Rugged Waterproof

TDS / °C meter

www.hannainst.com

SPECIFICATIONS

Range

0 to 1999 ppm

0.0 to 60.0 °C

Resolution

1 ppm / 0.1°C

Accuracy

±2% f.s. (ppm) / ±0.5°C

Typical EMC

±2% f.s. (ppm) / ±0.5°C

Deviation

TDS Factor

0.5

Calibration

Factory-calibrated

Temperature

Automatic from 0 to 60°C

Compensation

β=2%/°C, T(ref.)=25°C

Battery Type

2 x 1.5V AAA alkaline

Battery Life

1000 hours of continuous use

Auto-off

After 5 minutes of non-use

Environment

0 to 50°C; 100% RH

Dimensions

94 x 38 x 440 mm (3.7 x 1.5 x 17.3’’)

Weight

200 g (7.8 oz.)

Warranty

All Hanna Instruments meters are warranted for two years against defects in

workmanship and materials when used for their intended purpose and main-

tained according to instructions. This warranty is limited to repair or replacement

free of charge. Damages due to accident, misuse, tampering or lack of pre-

scribed maintenance are not covered. If service is required, contact the dealer

from whom you purchased the instrument. If under warranty, report the model

number, date of purchase, serial number and the nature of the failure. If the

repair is not covered by the warranty, you will be notified of the charges in-

curred. If the instrument is to be returned to Hanna Instruments, first obtain a

Returned Goods Authorization number from the Customer Service department

and then send it with shipping costs prepaid. When shipping any instrument,

make sure it is properly packaged for complete protection.

Recommendations for Users

Before using this product, make sure that it is entirely suitable for the environ-

ment in which it is used. Operation of this instrument in residential areas could

cause interference to radio and TV equipment. Any variation introduced by the

user to the supplied equipment may degrade the instrument EMC performance.

To avoid electrical shocks, do not use this instrument when voltage at the

measurement surface exceeds 24 Vac or 60 Vdc. To avoid damage or burns,

do not perform any measurement in microwave ovens.

ISTAQUADIPR2 05/05

Dear Customer,

Thank you for choosing a Hanna product.

Please read this instruction manual carefully before

using the instrument.

If you need additional technical information, do not hesi-

tate to e-mail us at [email protected].

This instrument is in compliance with directives.

TAKING MEASUREMENTS

The meter is factory calibrated for ppm and temeprature.

Press the ON/OFF key to turn

the meter on.

Immerse the probe into the so-

lution to be tested. The minimum

water level must be approx.

of 4½ cm, while the maximum

level has not to exceed the

indicated hole. If possible, tap

the probe to remove any air

bubbles that may be trapped

inside.

Allow for the reading to stabi-

lize. The LCD displays the

ppm reading.

Press the RANGE key to view

the temperature reading.

Press RANGE again to return

to ppm reading.

If the ppm reading is out of range, the “

---

” indication

is displayed. If the temperature reading is out of range,

the “°C” symbol blinks.

HOLD FUNCTION

To freeze the current measure-

ment on the LCD, press and

hold the RANGE/HOLD key for

about 3 seconds.

When the hold function is active, the LCD displays

alternatively the

“HLd”

indication and the frozen read-

ing.

Press RANGE to switch from ppm to temperature

reading.

Press the ON/OFF key to exit the hold mode and

return to normal operation.

BATTERY REPLACEMENT

To prolong the battery life, the meter switches itself

off after 5 minutes of non-use.

Variations in readings or fading display can indicate

weak batteries.

If the batteries are too weak to support proper opera-

tions, the LCD displays the message “Eb” and then the

meter switches itself off.

Battery replacement must only take place in a non-

hazardous area using 1.5V AAA alkaline batteries.

In order to replace run down

batteries, simply remove the

two screws on the bottom

cover and replace the two

1.5V AAA batteries with new

ones, while paying attention

to the correct polarity.

Otros manuales de Instrumento de medición de Hanna Instruments

Hanna Instruments

Hanna Instruments HI 93754G-25 MR Manual de usuario

Hanna Instruments

Hanna Instruments HI770 Manual de usuario

Hanna Instruments

Hanna Instruments HI96727 Manual de usuario

Hanna Instruments

Hanna Instruments HI 931100 Manual de usuario

Hanna Instruments

Hanna Instruments HI 96753C Manual de usuario

Hanna Instruments

Hanna Instruments HI 720 Manual de usuario

Hanna Instruments

Hanna Instruments HI 93750 Manual de usuario

Hanna Instruments

Hanna Instruments HI97747 Manual de usuario

Hanna Instruments

Hanna Instruments HI 9835 Manual de usuario

Hanna Instruments

Hanna Instruments HI 98191 Manual de usuario

Hanna Instruments

Hanna Instruments HI97746 Manual de usuario

Hanna Instruments

Hanna Instruments pH 21 Manual de usuario

Hanna Instruments

Hanna Instruments HI 729 Manual de usuario

Hanna Instruments

Hanna Instruments HI 95759 Manual de usuario

Hanna Instruments

Hanna Instruments HI 8010 Manual de usuario

Hanna Instruments

Hanna Instruments HI98198 OPDO Manual de usuario

Hanna Instruments

Hanna Instruments HI96708C Manual de usuario

Hanna Instruments

Hanna Instruments HI97720 Manual de usuario

Hanna Instruments

Hanna Instruments HI 96104C Manual de usuario

Hanna Instruments

Hanna Instruments HI 755 Manual de usuario

Hanna Instruments

Hanna Instruments HI 9126 Manual de usuario

Hanna Instruments

Hanna Instruments pHep HI 98107 Manual de usuario

Hanna Instruments

Hanna Instruments HI 84429 Manual de usuario

Hanna Instruments

Hanna Instruments HI981400 Manual de usuario

Manuales populares de Instrumento de medición de otras marcas

Suaoki

Suaoki D40 Manual de usuario

Elster

Elster BK-G1.6 Manual de usuario

Endress+Hauser

Endress+Hauser Deltabar FMD71 Manual

Duratool

Duratool D03128 Manual de usuario

Vega

Vega VEGAPULS 65 Manual de usuario

Tonghui

Tonghui TH2618B Manual de usuario

Tenmars

Tenmars TM-801 Manual de usuario

MSR

MSR 145 Manual de usuario

TPS

TPS WP-82 Manual de usuario

ELMETRON

ELMETRON CP-511 Manual de usuario

PCB Piezotronics

PCB Piezotronics 003C30 Manual de usuario

Tenma

Tenma 72-10465 Manual de usuario

Endress+Hauser

Endress+Hauser Proline Promag 50 Especificaciones técnicas

Siemens

Siemens SITRANS F Coriolis FCT030 Manual de lista de piezas

KLINGER

KLINGER CMF V Series Manual de usuario

EXFO

EXFO FTB-2 Manual de operación y mantenimiento

Keysight

Keysight M8290A Manual de usuario

ADTEK

ADTEK MW-5 Manual de usuario