Ground Zero RADIOACTIVE Series Manual de usuario

RADIOACTIVE-SERIES

AMPLIFIER

OWNER’S MANUAL

GZRA 1.1650DX

Features

•1 Ohm stable

•Linkable 2 Ohm

•Mosfet power supply

•Power and protection indicator

•Variable 12dB Bass boost (45Hz)

•Phaseshift 0 / 180° (Switch)

•Variable Subsonic

•Variable Lowpass

•Adjustable input sensitivity

•Soft delayed remote turn on

•Stereo RCA output

•Bass remote control

•Thermal / Short / Overload protection

- 2 -

Tools and materials you need

•Screwdriver

•Electric drill, 3 mm / 0.12” carbide drill bit

•Mounting screws

•Power wire min. 25 mm² / 4 AWG

•Ground wire min. 25 mm² / 4 AWG

•Speaker wire min. 2 x 2,5 mm²

Please note!

•As a precaution it is advisable to disconnect the vehicle’s battery before making connection to the +12 Volts supply wiring

(see owner’s manual of your car for further information).

•Please use great caution drilling your trunk. Your gas tank and brake lines can be damaged by puncturing with your drill bit –

this could cause damage or failure of your cars operating systems.

•Never pass wires over sharp angles. It is recommended to buffer the power supply of the amplifier with an additional

capacitor (power cap) min. 1 F to guarantee a stable operation voltage.

WARNING !

High powered audio systems in a vehicle are capable of generating "Live Concert" levels of sound pressure. Continued exposure to

excessively high volume sound levels may cause hearing loss or damage. Also, operation of a motor vehicle while listening to audio

equipment at high volume levels may impair your ability to hear external sounds such as; horns, warning signals, or emergency vehicles,

thus constituting to a potential traffic hazard. In the interest of safety, Consumer Electronics recommends listening at lower volume levels

while driving.

Planning your system

Before beginning the installation, consider the following:

a) If you plan to expand your system by adding other components sometime in the future, ensure adequate space is left, and

cooling requirements are met.

b) If your radio is equipped with preamplifier outputs (RCA), it is advisable to use them.

Mounting your amplifier

a) Select a suitable location that is convenient for mounting, is accessible for wiring and has ample room for air circulation and

cooling.

b) Use the amplifier as a template to mark the mounting holes, remove the amplifier and drill 4 holes. Then mount the amplifier

with the mounting screws.

- 3 -

Warning

Chose a mounting position where all electric wires are protected from being damaged by sharp edges, heat or other conditions. +12Volt

DC electrical connections must be fused on the battery side. Make sure your radio and all other devices will be turned off while connection

your system.

If you need to replace the power fuse, replace it only with a fuse identical to that supplied with the system. Using a fuse of different type or

rating may result in damage to this system which isn’t covered by the warranty.

Power connection

- 4 -

Controls and functions

- 5 -

Control and functions

Speaker terminals

For connection of the subwoofer

Power terminals

GND -> Ground connection

REM -> Remote antenna terminal

BATT -> +12 Volt

Satus indication

GREEN – OK

RED – Error

Cinch inputs

Terminal for connection of the RCA wires.

To avoid failure, please use high quality RCA wires.

Input level controller

With this controller you can adjust the input sensitivity.

Bass boost controller

For adjusting of the bass boost level in the range from 0 to +12 dB.

Low pass controller

Adjust the variable lowpass frequency to the desired frequency between 30

and 250 Hz using the controller.

Master / Slave Switch

For choosing the operation mode of each amplifier in link mode.

Cinch Outputs

For connection of additional amplifiers in fullrange operation.

Remote control input

For connection of the bass remote control.

Phase shift controller

This controller allows you to fit the subwoofer channel in-phase to the front

system.

Subsonic controller

This controller allows you to filter low frequencies in a range between 10

and 50 Hz. This function reduces the mechanical Xmax and raises the

capacity of the connected subwoofer.

Master/Slave

Cinch-In-/Output

Cinch In- / Output for operation of two same amplifiers in linkmode.

Turning on the amplifier

The amplifier automatically turns on a few seconds after you turn on your radio.

Note: Your amplifier temporarily shuts down if it gets too hot, then restarts automatically once it cools

(At about 80° / 176° F).

Adjusting the audio level

1. LEVEL (Min/Max): Turn fully counter- clockwise to MIN position

2. Turn the auto sound system's volume control to about two-third of its full range.

3. Adjust LEVEL to a comfortable listening level.

- 6 -

2 Woofer wiring

- 7 -

Master & slave wiring

- 8 -

Master & slave wiring

- 9 -

Specifications

Model

GZRA 1.1650DX

Type

1 Channel Class D

RMS Power @ 4 Ω

CEA Standard CEA-2006-A

1 x 650 W

(1% THD+N)

1 x 800 W (10% THD+N)

RMS Power @ 2 Ω

CEA Standard CEA-2006-A

1 x 1250 W (1% THD+N)

1 x 1400 W (10% THD+N)

RMS Power @ 1

Ω

CEA Standard CEA-2006-A

1 x 1800 W (1% THD+N)

1 x 2300 W (10% THD+N)

RMS Power @ 2ΩLinkmode

CEA Standard CEA-2006-A

1 x 3600 W

(1% THD+N)

1 x 4600 W (10% THD+N)

Damping factor

> 100

Signal to noise Ratio

> 75 dB

Lowpass

30 Hz – 250 Hz

Subsonic filter

10 Hz – 50 Hz

Bass boost

0 ~ +12 dB (45 Hz)

Frequency response

10 Hz – 250 Hz (± 1 dB)

Input sensitivity

200 mV – 9 V (± 5%)

Bass remote control



Fuse

4 x 35A

Dimensions

W x H x L mm

230 x 53 x 446

Dimensions

W x H x L inch

9.04“ x 2.09“ x 17.56“

Trouble shooting guide

Symptoms

Check Points

Cure

No sound Is the POWER LED illuminated?

Check fuses in amplifier.

Be sure remote lead is connected.

Check +12 Volt connection

Check ground connection

Is the diagnostic LED illuminated?

Check for speaker short or amplifier overheating

Amp not switching on

No power to the amplifier

Check power wire or connections

No power to remote wire with receiver on

Check connections to radio

No sound in one channel

Check speaker leads

Inspect for short circuit or an open connection

Check audio leads

Reverse left and right RCA inputs to determine if it

is occurring before the amp

Amp turning off at medium /

high volume Check speaker load impedance

Be sure proper speaker load impedance

recommendations are observed

(If you use an ohm meter to check speaker

resistance, please remember that DC resistance

and AC impedance may not be the same.)

Protection LED is on

Temperature shut down

Turn radio volume down

Speaker wires short

Separate speaker wires and insulate

- 10 -

Die Gewährleistung entspricht der gesetzlichen Regelung. Eine Rücksendung kann nur nach vorheriger Absprache und in der

Originalverpackung erfolgen. Bitte unbedingt einen maschinell erstellten Kaufbeleg und eine Fehlerbeschreibung beilegen. Von der

Gewährleistung ausgeschlossen sind Defekte, die durch Überlastung, unsachgemäße Behandlung oder bei Teilnahme an Wettbewerben

entstanden sind. Wir behalten uns das Recht vor, zukünftig nötige Änderungen oder Verbesserungen an dem Produkt vorzunehmen ohne

den Kunden darüber zu informieren.

Limited warranty - defective products must be returned in original packaging - please add a copy of the original purchasing invoice showing

the purchasing date and a detailed description of the failure. Failure caused by overload, misuse or by using the product for competition

purpose are not covered by the warranty. We reserve the right to make needed change or improvement to the product without informing

customer about this in advance.

De Garantie bepalingen van alle door ground zero geleverde producten is volgens wettelijke

bepalingen geregeld, Een retourzending kan alleen na duidelijke afspraak en in de originele

verpakking plaatsvinden.SVP een aankoopbon en een duidelijke storingsomschrijving bijvoegen.Van garantie uitgesloten zijn defecten door

overbelasting, onkundig gebruik, of door deelname aan wedstrijden (SPL) ontstaan zijn. Wij behouden ons het recht om de nodige

veranderingen of verbeteringen aan het product door te voeren zonder de klant hierover te informeren.

La garantie est conforme aux droits légaux. Un retour du produit défectueux doit être dans son

emballage d'origine sur présentation du reçu ou de la facture indiquant la description du defaut.La présente Garantie n'est pas applicable

lorsque le produit a été endommagé en raison: Mauvaise alimentation, Trop de puissance (HP,Subwoofer) Accident, Installation ou

Utilisation non conforme aux normes Technique (Concours SPL etc). Nous nous réservons le droit d'entreprendre à l'avenir nécessairement

des modifications ou des

améliorations au produit sans informer le client.

Ground Zero GmbH

Erlenweg 25, 85658 Egmating, Germany

Tel. +49 (0)8095/873 830 Fax -8310

www.ground-zero-audio.com

Otros manuales para RADIOACTIVE Series

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Amplificador de Ground Zero

Ground Zero

Ground Zero PLUTONIUM SERIES Manual de usuario

Ground Zero

Ground Zero Competition Series Manual de usuario

Ground Zero

Ground Zero GZCA 8.0K-SPL Manual de usuario

Ground Zero

Ground Zero HYDROGEN GZHA 1.1200DXII Manual de usuario

Ground Zero

Ground Zero TITANIUM Series Manual de usuario

Ground Zero

Ground Zero GZUA 2.250SQ Manual de usuario

Ground Zero

Ground Zero HYDROGEN GZHA 2400XII Manual de usuario

Ground Zero

Ground Zero GZPA 1.10000SPL-HC Manual de usuario

Ground Zero

Ground Zero IRIDIUM SERIES Manual de usuario

Ground Zero

Ground Zero GZCS 4.60ISO Manual de usuario

Ground Zero

Ground Zero GZHA MINI FIVE Manual de usuario

Ground Zero

Ground Zero GZRA 1.2500D Manual de usuario

Ground Zero

Ground Zero URANIUM Series Manual de usuario

Ground Zero

Ground Zero GZTA 5120X-II Manual de usuario

Ground Zero

Ground Zero IRIDIUM SERIES Manual de usuario

Ground Zero

Ground Zero Competition Series Manual de usuario

Ground Zero

Ground Zero RADIOACTIVE GZRA 4230 Manual de usuario

Ground Zero

Ground Zero GZIA 1.1150D Manual de usuario

Ground Zero

Ground Zero GZTA 2155X-II Manual de usuario

Ground Zero

Ground Zero PLUTONIUM GZPA 1.6000D Manual de usuario

Ground Zero

Ground Zero IRIDIUM SERIES Manual de usuario

Ground Zero

Ground Zero PLUTONIUM GZPA 1.6000D Manual de usuario

Ground Zero

Ground Zero PLUTONIUM GZPA 1.6K-HC Manual de usuario

Ground Zero

Ground Zero IRIDIUM SERIES Manual de usuario

Manuales populares de Amplificador de otras marcas

ASTRO

ASTRO HVO V40 P Manual de usuario

Marantz

Marantz SUPERSCOPE BLA-545 Instrucciones de montaje

NAD

NAD CI980 Manual de usuario

Technics

Technics SE-CH770 Manual de usuario

Harman Kardon

Harman Kardon HK6300 Manual de usuario

NAD

NAD T975 Manual de usuario

McIntosh

McIntosh MA6850 Manual de usuario

Electro-Harmonix

Electro-Harmonix ENGLISH MUFF’N Manual de usuario

Viatron

Viatron Autrix Manual de usuario

GME

GME GA9800 Manual de usuario

Atlas

Atlas CP700 Manual de usuario

Roland

Roland KC-1000 Manual de usuario

Pyle

Pyle PFMRA350BW Manual de usuario

Advantage

Advantage S-250 Manual de usuario

IRT Electronics

IRT Electronics DVA-3007 Manual de usuario

Dimavery

Dimavery BA-100 Series Manual de usuario

Sony

Sony XM-S400D Manual de usuario

Schertler

Schertler ROY X Manual de usuario