Assigning the door station to the camera gate-
way
If an audio door station is assigned to the camera
gateway the external camera behaves as a system
camera, i.e. the external camera is automatically
activated with a door call from the assigned door
station.
To assign a camera gateway to an audio door sta-
tion:
1. Press the "System prog." button on the control
device for 3 s to start programming mode.
✓The LED at the control device flashes yellow.
The LED at the DCS-camera-gateway flashes red.
2. Press any call button on the audio door station
for 3 s. Release the call button following the brief
acknowledgement tone.
✓The door station outputs a long acknowledge-
ment tone.
3. Press and hold the programming button at the
DCS-camera-gateway for 3 s until the LED
briefly flashes green.
✓The LED flashes green one time long, and then
lights up red: assignment successful.
or
The LED flashes green three times and then fla-
shes red: assignment not successful.
The call buttons of the door station must then be
assigned to the corresponding home stations as
described in the operating instructions of the con-
trol device.
Deleting assignment to the door station
1. Press the "System prog." button on the control
device for 3 s to start programming mode.
✓The LED at the control device flashes yellow.
The LED at the DCS-camera-gateway lights up
red.
2. Press and hold the programming button at the
DCS-camera-gateway for 6 s.
✓The LED briefly flashes green after 3 and 6 s.
✓The LED flashes green one time long and then
flashes red: assignment deleted.
Using a camera gateway without door station
With operation without an assigned door station the
camera is not automatically activated via a door call.
The camera can only be activated via the home sta-
tions with video function that exist in the system.
For operation without an assigned door station the
camera gateway must be registered in the door
communication system:
1. Press the "System prog." button on the control
device for 3 s to start programming mode.
✓The LED at the control device flashes yellow.
The LED at the DCS-camera-gateway flashes red.
2. Press and hold the programming button at the
DCS-camera-gateway for 9 s.
✓The LED briefly flashes green after 3, 6 and 9 s.
✓The LED flashes green one time long, and then
lights up red: the camera gateway has been suc-
cessfully registered in the system.
Example topologies
Up to 5 camera gateways in series can be operated.
Each external camera requires its own power sup-
ply.
Up to 3 camera gateways can be wired in a star con-
figuration if they are connected to the video control
device via video distributors.
Technical data
Video signal: FBAS 1 Vss,
PAL standard
Temperature range: -25 °C to +70 °C
Relay load: 50 μA to max. 1.6 A
at 24 V AC/DC
Dimensions
(W x H x D): 36 x 52 x 27 mm
Maximum cable lengths
Camera gateway -
TFT display: 100 m
Camera gateway -
Camera: 30 m
Warranty
We provide a warranty in accordance with the statu-
tory requirements.
Please send the device postage paid with error
description via the specialist trade to our central
customer service centre.
Gira
Giersiepen GmbH & Co. KG
Service Center
Dahlienstraße 12
42477 Radevormwald
