Gira 1117 00 Manual de usuario
Solar/twilight sensor, outdoor
Order-No. : 1117 00
Operating instructions
1 Safety instructions
Electrical equipment may only be installed and fitted by electrically skilled persons.
Failure to observe the instructions may cause damage to the device and result in fire and
other hazards.
These instructions are an integral part of the product, and must remain with the end
customer.
2 Device components
Figure 1: Sun sensor front view
(1) Photodiode
(2) Sun connection terminal
(3) Earth connection terminal
(4) Fastening for strain relief
(5) Sensor cable entry
3 Function
Intended use
- Sensor for brightness detection. Provides a sun protection or twilight function in connection
with covers of the blind system.
- Surface-mounted device for outdoor installation.
1/4
82534112 17.05.2011
Solar/twilight sensor, outdoor
Blind control system
Product characteristics
The sensor supports the following functions of blind covers:
- Sun protection function enables automatic lowering of the blind/shutter when a set
brightness value is exceeded.
Application: sun protection for monitor-equipped workstations, flower windows or
greenhouses.
- Twilight function enables automatic lowering of a blind/shutter when the brightness drops
below as set value.
Application: lowering the blind/shutter at dusk.
4 Information for electrically skilled persons
4.1 Fitting and electrical connection
Mounting and connecting the device
i The sensor cable carries safety extra-low voltage (SELV). Observe fitting instructions
according to VDE 0100.
Figure 2: Sun sensor and included accessories.
o Mount the sun sensor using the mounting bracket (8) in position suitable for brightness
measurement with the cable entry facing downwards (Figure 2).
o Fasten mounting bracket (8) and housing using supplied screw (6), washer and nut (7).
o Insert sensor cable into the housing from below (5).
o Connect sensor cable to sun (2) and earth (3) terminals (Figure 1).
o Secure sensor cable with strain relief (9).
o Push on transparent housing cover (10) from above until it snaps into place and secure
from rear with supplied screw (11) (Figure 2).
82534112 17.05.2011 2/4
Blind control system
Solar/twilight sensor, outdoor
Connecting sensor cable to terminal block in insert
DANGER!
Electrical shock when live parts are touched.
Electrical shocks can be fatal.
Before working on the device, disconnect all the corresponding miniature
circuit breakers. Cover up live parts in the working environment.
Figure 3
o Connect sensor cable to the terminal block in the blind insert in accordance with
connection diagram (Figure 3).
(12) = Earth
(13) = Sun
Interchanging the connections will result in malfunctions.
i The sensor cable must not be too long, because otherwise interference from other loads
and cables may occur. This may result in malfunctions. Therefore use only shielded cables,
and connect the shielding to earth. Recommended cable J-Y(St)Y2x2x0.6. The total length
must not exceed 20 m; avoid proximity to other electrical facilities.
5 Appendix
5.1 Technical data
Ambient temperature -30 ... +70 °C
Protection rating IP 54
5.2 Warranty
The warranty is provided in accordance with statutory requirements via the specialist trade.
Please submit or send faulty devices postage paid together with an error description to your
responsible salesperson (specialist trade/installation company/electrical specialist trade). They
will forward the devices to the Gira Service Center.
82534112 17.05.2011 3/4
Blind control system
Solar/twilight sensor, outdoor
Gira
Giersiepen GmbH & Co. KG
Elektro-Installations-
Systeme
Industriegebiet Mermbach
Dahlienstraße
42477 Radevormwald
Postfach 12 20
42461 Radevormwald
Deutschland
Tel +49(0)21 95 - 602-0
Fax +49(0)21 95 - 602-399
www.gira.de
82534112 17.05.2011 4/4
Blind control system
Solar/twilight sensor, outdoor
Tabla de contenidos
Otros manuales de Accesorios de Gira
Gira
Gira 5472 02 Manual de usuario
Gira
Gira 5466 02 Manual de usuario
Gira
Gira KNX 5011 00 Manual de usuario
Gira
Gira 5461 02 Manual de usuario
Gira
Gira 5069 00 Manual de usuario
Gira
Gira 0384 00 Manual de usuario
Gira
Gira Touch sensor 2 Manual de usuario
Gira
Gira 2688 Series Manual de usuario
Gira
Gira 5466 02 Manual de usuario
Gira
Gira 5068 00 Manual de usuario
Gira
Gira 1025 00 Manual de usuario
Gira
Gira KNX/EIB Manual de usuario
Gira
Gira EDA 3902 F Manual de usuario
Gira
Gira 1493 00 Manual de usuario
Gira
Gira Observer 110 Manual de usuario
Gira
Gira 5472 02 Manual de usuario
Gira
Gira GEDU 10 Guía
Gira
Gira 1170 Series Manual de usuario
Gira
Gira Observer 70 Manual de usuario
Gira
Gira System 106 Manual de usuario
