Genie ZD2812WL Manual de usuario

ULTRA HIGH RESOLUTION DIGITAL DAY/NIGHT

PIR CAMERA

ZD2812WL/PIR

USER MANUAL

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION:TO REDUCE THE RISK OF ELECTRIC SHOCK

DO NOT REMOVE COVER(OR BACK).

NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

ISO14001

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION:TO REDUCE THE RISK OF ELECTRIC SHOCK

DO NOT REMOVE COVER(OR BACK).

NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

ISO14001

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION:TO REDUCE THE RISK OF ELECTRIC SHOCK

DO NOT REMOVE COVER(OR BACK).

NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

ISO14001

The lightning flash with an arrowhead symbol, within an equilateral

triangle is intended to alert the user to the presence of uninsulated

dangerous voltage within the product's enclosure that may be of

sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert

the user to the presence of important operating and maintenance

(servicing) instructions in the literature accompanying the appliance.

INFORMATION - This equipment has been tested and found to comply with

limits for a Class A digital device, pursuant to part 15 of the FCC Rules & CE Rules.

These limits are designed to provide reasonable protection against harmful

interference when the equipment is operated in a commercial environment.

This equipment generates, uses, and can radiate radio frequency energy and, if

not installed and used in accordance with the instruction manual, may cause

harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful

interference in which case the user will be required to correct the interference at

their own expense.

WARNING - Changes or modifications not expressly approved by the

manufacturer could void the user’s authority to operate the equipment.

This installation should be made by a qualified service person and

should conform to all local codes.

CAUTION : To prevent electric shock and risk of fire hazards:

☞Do NOT use power sources other than those specified.

Precautions

Do not install the camera in

extreme temperature conditions.

Do not touch the front lens of the

camera.

Do not install or use the camera in an

environment where the humidity is high.

Do not drop the camera or subject

it to physical shocks.

Do not expose the camera to

radioactivity.

Do not install the camera under

unstable lighting conditions.

Never keep the camera pointed

directly at strong light.

Only use the camera in conditions

where temperatures are between

-20°C and +50°C. Be especially careful

to provide ventilation when operating

under high temperatures.

This is one of the most important parts

of the camera. Be careful not to leave

fingerprints on the lens cover.

Do not install or use the camera in an

environment where the humidity is

high.

It can cause malfunctions to occur.

If exposed to radioactivity the CCD

will fail.

Severe lighting change or flicker can

cause the camera to work improperly.

Severe lighting change or flicker can

cause the camera to work improperly.

NOTE

* If the camera is exposed to

spotlight or an object reflecting strong light, smear or blooming may

occur.

* please check that the power satisfies the normal specification before

connecting the camera.

SPECIFICATIONS

MODEL

1/3” Sony Super HAD CCD ll

NTSC, PAL

NTSC=811(H) * 508(V) / PAL=795(H) * 596(V)

NTSC=768(H) * 494(V) / PAL=752(H) * 582(V)

NTSC=15.734KHz(H) & 59.94Hz(V) / PAL=15.625KHz(H) & 50.00Hz(V)

2:1 Interlace

Internal

600TV Lines

CDS OFF: 0.15 Lux, CDS ON: 0.00002 Lux

More than 52dB

CVBS: 1.0Vp-p / 75Ω

NTSC=(1/60sec~1/120,000sec) / PAL=(1/50sec~1/120,000sec)

Available

On / Off (Level adjustable)

BLC / HLC / OFF

Colour / BW / AUTO / EXT

Low / High / Off

ATW / Outdoor / Indoor / Manual / AWC (1,700°K ~ 11,000°K)

Auto / Off (Selectable x2 ~ x512)

On / Off (8 Programmable Zones)

On / Off (12 Programmable Zones)

On / Off (Level adjustable)

On / Off (x1 ~ x16)

On / Off

On / Off (Level adjustable)

On / Off / V-Rev / H-Rev

DC 12V / AC 24V-Dual Voltage

CDS ON:500mA Max

DC Auto Iris Varifocal Lens(2.8mm-12mm)

~20 ~ +50 Deg C. RH95% MAX.

~20 ~ +60 Deg C. RH95% MAX.

88mm(W) * 115mm(H) * 245mm(D)

1600g

ZD2812WL/PIR

Image Pick-Up Device

TV System

Total Pixels

Effective Pixels

Scanning Frequency

Scanning System

Synchronisation

Resolution

Minimum Illumination

S/N Ratio

Video Output

Electronic Shutter Speed

OSD

SSDR

BLC

Day & Night

Gain Control

White Balance

SENS-UP

Motion Detection

Privacy Masking

SSNR III (Digital Noise Reduction)

Digital Zoom

DIS (Digital Image Stabilizadion)

Sharpness

Filp / Mirror

Power Supply

Power Consumption

Lens

Operational Temp.

Storage Temp.

Dimension

Weight

600TV Lines

DC Auto Iris Varifocal

Lens (2.8mm-12mm)

White LEDs * 30pcs

IP 66

Ultra High Resolution Digital Day&Night PIR Camera

Built-in 30-power White LEDs with CDS Sensor

Camera OSD Control

Specification

Anti Vandal

Hood Camera

IP66

Registant

Weather

Function

DC 12V / AC 24V

LENS

DC VARIFOCAL

Shutter

High Speed

Resolution

Horizontal

Backlight

Compensation

600

BLC

Auto White

Balance

DAY & NIGHT

CCD

1/3"

0.00002Lux

Minimum

Illumination

Auto

Gain

Control

OSD

Motion

Detection

2x ~ 512x

Contents

◑Contents

◑Safety Instructions

◑General Features

◑OSD Control Button

◑Camera Menu Set Up

1. Menu Set Up

2. Lens Setting

3. Exposure Setting

4. White Balance Setting

5. SSNR Setting

6. Backlight Setting

7. DNR3 Setting

8. Day/Night Setting

9. Special Setting

10. Exit Setting

◑Trouble Shooting

Precautions for use

Please read this manual thoroughly before using the camera to become familiar with the

correct operational procedures.

Cautions When Using

Do not open the camera body and touch any electrical parts to avoid possible electric shocks.

Do not insert objects into the camera body to prevent fire hazards and electric shock.

Do not touch the camera with wet hands - to avoid an electric shock.

Do not disconnect the power cord from a power plug when still connected to the outlet.

Always disconnect the power by removing the plug from the power socket.

lf the camera emits a burning smell, immediately disconnect it from the power source and

report the problem to your distributor.

Cautions When Install

Only apply power after installation of the product.

Do not install the camera in a position facing directly at a strong light source.

Do not install or use the camera in areas of high humidity.

Do not install near any cooling or heating equipment.

Do not install the camera in dusty environments.

Do not install the camera in places where the camera is subjected to physical shocks.

This products must be used with a regulated adaptor for power, such as the Genie PSU1SM.

☞

Safety Instructions

General Features

◑ Ultra High Sensitivity

- The built-in high sensitivity COLOUR CCD produces a clear image even in 0Lux(B/W, IR-LED ON)or lower

illumination.

◑ 600TV Lines

- By adopting a diagonal 6mm(1/3") 410,000 (NTSC) pixel, 470,000(PAL) pixel SONY CCD, the camera

produces clear picture quality with a horizontal resolution of 600 TV lines for colour and a horizontal

resolution of 700TV lines for BW mode.

◑ DNR3

- The high-performance W-V DSP chip effectively removes low-light gain noise and ghosting to provide

clear images even in dark environments.

◑ Day & Night

- This camera has a function that automatically selects the mode that is appropriate for daytime or night-time

conditions.

The COLOUR mode operates in daytime conditions to provide optimum colours, and BW mode operates in

night-time conditions to enhance the definition of the image.

◑ SSNR

- For images with high contrast between bright and dark Areas from difficult lighting conditions such as

backlighting, this camera selectively illuminates darker Areas while retaining the same light level for

brighter Areas to even out the overall brightness.

◑Miscellaneous Functions

- HLC(High Light Compensation), SENS-UP, FLIP(H/V-REV), D-ZOOM, SHARPNESS, MOTION DETECTION and PRIVACY

functions are provided.

◑ Disk Saving Effects

- Up-most and advanced DNR technology camera picture quality has a disk saving effects due to Image sizes

are smaller than standard CCTV camera image.

◑ Controlled by OSD Menu

◑ PIR Sensor

- The camera can be controlled by selecting the menu text displayed on the monitor screen.

- Built-in PIR sensor makes white LED "ON" when forces sombody's entry as a warning system

or function of the light.

OSD Control Button

1. Type A, Type B, Type C of OSD button could be used when it needs to

OSD control.

2. Type D is extra Option (wired Remote controller)

▲Up button: Moves the cursor upwards. Use this button to select an item

or adjust the parameters.

▼Down button: Moves the cursor downwards. Use this button to select an

item or adjust the parameters.

◀Left button: Moves the cursor to the left. Use this button to select or

adjust the parameters of the selected item. The parameter changes

each time this button is pressed.

▶Right button: Moves the cursor to the right. Use this button to select or

adjust the parameters of the selected item. The parameter changes each

time this button is pressed.

◎Set button: Executes selections and displays a submenu for an item with

the mark.

●

Menu Setup

●

Lens Setting

1. Press the Function Setup switch.

- Main setup menu is displayed on the monitor screen.

3. THE Lens mode has sub menu items as listed below.

- BRIGHTNESS : Adjusts the video brightness.

Using this function, you can control the screen brightness.

1. When the SETUP menu screen is displayed, select 'LENS' by using

the Function Setup switch so that the arrow indicates 'LENS'.

2. DC : You can adjust the minimum shutter and maximum value of ESC

shutter mode.

2. Select a desired function using the Function Setup switch.

- Place the cursor over a desired item.

3. Set up a selected item by using the Function Setup switch.

To finish the setting, select 'EXIT' and press the Function Setup switch.

MAIN SETUP

1.LENS

2.EXPOSURE

3.WHITE BAL

4.SSNR

5.BACKLIGHT

6.DNR3

7.DAY/NIGHT

8.SPECIAL

9.EXIT

1.LENS

2.EXPOSURE

3.WHITE BAL

ATW

OFF

AUTO

SAVE

ATW

☞ NOTE

■ An item with the

◀

icon also has sub menus. To select a sub menu, select an item

with the icon and press the Function Setup switch.

■ An item with the - - - icon is unavailable due to function settings.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Cámara de seguridad de Genie

Genie

Genie WIP2BVLG Manual de usuario

Genie

Genie PWIPN2EBV Manual de usuario

Genie

Genie WIPX4BVAF722 Manual de usuario

Genie

Genie UMD300 Series Manual de usuario

Genie

Genie HDI221 Manual de usuario

Genie

Genie TPC 8922 Series Manual de usuario

Genie

Genie SSIP2BVAF Manual de usuario

Genie

Genie PWIP4EBVAF Manual de usuario

Genie

Genie WIPX2LBVLPR Manual de usuario

Genie

Genie GIPW4NPIR Manual de usuario

Genie

Genie WIPX4EBVAF Manual de usuario

Genie

Genie WIPX4FD Manual de usuario

Genie

Genie WIPX4VDVAF Manual de usuario

Genie

Genie SSAHD2LBVAF Manual de usuario

Genie

Genie WAHD2LBV Manual de usuario

Genie

Genie GAHDB21W Manual de usuario

Genie

Genie PWIP4BVAF Manual de usuario

Genie

Genie ZD5502 Manual de usuario

Genie

Genie GMC3CH Manual de usuario

Genie

Genie WIP1VD Manual de usuario

Genie

Genie ZD2812IR Manual de usuario

Genie

Genie VRD73TDN Manual de usuario

Genie

Genie M640 Manual de usuario

Genie

Genie TPIR-607 Series Manual de usuario

Manuales populares de Cámara de seguridad de otras marcas

Okina USA

Okina USA SIR36-870VF650LP Manual de usuario

Divio

Divio NDR155PA Manual de usuario

Canon

Canon VB-C500D Manual de usuario

Easy Access

Easy Access EasyGuard Manual de usuario

Vivotek

Vivotek FD9389-EHV-v2 Manual de usuario

TUYA

TUYA COSMO W2 Manual de usuario

Eusso

Eusso UNC7500-IR Guía de configuración

urmet domus

urmet domus 1096/204 Manual de usuario

VC VC20 series Manual de usuario

Axis

Axis Q1614 Manual de usuario

ieGeek

ieGeek DD201 Manual de usuario

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Manual de usuario

Vicon

Vicon V662-D-1 Instrucciones de funcionamiento

Grundig

Grundig GCH-K0274P Manual de usuario

Lorex

Lorex VANTAGE LBC7032 Manual de usuario

4xem

4xem WPT Manual de usuario

Samsung

Samsung SCV-3082 Manual de usuario

Vitek

Vitek VTC-C544 Manual de usuario