Generac Power Systems ECOGEN 005818-0 Manual de instalación y operación

1 of 4

¡INNOVATIVE DESIGN & PROTOTYPE TESTING are key components

of GENERAC’S success in “IMPROVING POWER BY DESIGN.” But it

doesn’t stop there. Total commitment to component testing, reliability

testing, environmental testing, destruction and life testing, plus testing

to applicable CSA, NEMA, EGSA, and other standards, allows you to

choose GENERAC POWER SYSTEMS with the confidence that these

systems will provide superior performance.

¡TEST CRITERIA:

PROTOTYPE TESTED NEMA MG1-22 EVALUATION

SYSTEM TORSIONAL TESTED MOTOR STARTING ABILITY

¡SOLID-STATE, FREQUENCY COMPENSATED VOLTAGE REGULATION.

This state-of-the-art power maximizing regulation system is standard on

all Generac models. It provides optimized FAST RESPONSE to changing

load conditions and MAXIMUM MOTOR STARTING CAPABILITY by

electronically torque-matching the surge loads to the engine.

¡SINGLE SOURCE SERVICE RESPONSE from Generac’s dealer network

provides parts and service know-how for the entire unit, from the engine

to the smallest electronic component.

¡PURPOSE BUILT FOR RENEWABLE ENERGY APPLICATIONS.

Designed specifically to interact with off-grid renewable energy

applications, Generac introduces the first generator intended for

alternative energy interaction. Capable of tying into an inverter and

battery storage system to supplement the alternative energy source.

This provides the cleanest running, low emission solution to recharging

house batteries.

¡EXTENDED RUN CAPABILITY. This innovative oil circulation system

extends the maintenance intervals by an unprecedented 5 times the industry

standard by offering 500 hour maintenance intervals.

INCLUDES:

• Electronic Governor

• External Main Circuit Breaker

• Sound Attenuated Enclosure

• Flexible Fuel Line Connector

• Composite Mounting Pad

• LP Gas Operation Only

• Advanced Oil Circulation System

• Easy Inverter Connections

• 120V (240V Capable with Conversion)

• 2000 Hour / 3 Year Limited Warranty

• UL 2200 Listed

Standby Power Rating

Model 005818-0 (Steel - Bisque) - 6 kW 60Hz

FEATURES

EcoGen™ SERIES

Residential Standby Generators

Air-Cooled Gas Engine

6kW

Not for sale in CA

2 of 4

EcoGen™ - 6 kW features and benefits

Engine

•Generac (OHVI) Design Maximizes engine “breathing” for increased fuel efficiency. Plateau honed cylinder walls and plasma moly rings

helps the engine run cooler, reducing oil consumption resulting in longer engine life.

•“Spiny-lok” cast iron cylinder walls Rigid construction and added durability provide long engine life.

•Electronic ignition/spark advance These features combine to assure smooth, quick starting every time.

•Full pressure lubrication system Pressurized lubrication to all vital bearings means better performance, less maintenance and longer engine life.

•Low oil pressure shutdown system Superior shutdown protection prevents catastrophic engine damage due to low oil.

•High temperature shutdown Prevents damage due to overheating.

•Spin-on automotive type oil filter Captures and collects harmful impurities with easy serviceability.

•Oil circulatory system Extends maintenance intervals to 500 hours and virtually eliminates oil degradation.

Generator

•Revolving field

Allows for a smaller, light weight unit that operates 25% more efficiently than a revolving armature generator.

•Displaced phase excitation

Maximizes motor starting capability.

•Automatic voltage regulation Regulates the output voltage to ±2% prevents damaging voltage spikes.

•UL 2200 Listed For your safety.

Controls

•Auto/Off/Manual switch Selects the operating mode.

•2-wire start/Inverter connection Allows the generator to be started by a two wire signal.

•Battery sentinel This smart system only charges the battery when needed, prolonging battery life.

•Main Line Circuit Breaker Protects generator from overload.

•Electronic governor Maintains constant 60 Hz frequency.

Unit

•Weather protective enclosure Ensures protection against mother nature. Hinged key locking roof panel for security.

Lift-out front for easy access to all routine maintenance items. Electrostatically applied

textured epoxy paint for added durability.

•Enclosed critical grade muffler Quiet, critical grade muffler is mounted inside the unit to prevent injuries.

•Small, compact, attractive Makes for an easy, eye appealing installation.

•SAE Sound attenuated enclosure ensures quiet operation.

Installation System

•1’ Flexible Fuel Line Connector

Easy Installation.

•Composite Mounting Pad

6kW

3 of 4

Rating definitions - Standby: Applicable for supplying emergency power for the duration of the utility power outage. No overload capability is available for this rating. (All ratings in accordance with BS5514,

ISO3046 and DIN6271). * Maximum wattage and current are subject to and limited by such factors as fuel Btu content, ambient temperature, altitude, engine power and condition, etc. Maximum power

decreases about 3.5 percent for each 1,000 feet above sea level; and also will decrease about 1 percent for each 6° C (10° F) above 16° C (60°F). Sound output ratings from certain points on the generator

subject to change based on installation parameters.

Generator

Model 005818-0 (6kW)

Rated Maximum Continuous Power Capacity (LP) 6,000* Watts

Rated Voltage 120 VAC (240 VAC capable w/kit)

Rated Maximum Continuous Load Current – 120 VAC 50 Amps (25 @240 VAC)

Main Line Circuit Breaker 50 Amps (25 after conversion)

Phase 1

Number of Rotor Poles 2

Rated AC Frequency 60Hz

Power Factor 1

Battery Requirement (not included) Group 26R 12 Volts and 525 Cold-cranking Amperes Minimum

Unit Weight (Pounds/Kilos) 387/175.5

Dimensions (L x W x H) Inches/mm 48 x 25 x 29 [1218 x 638 x 732]

Sound output in dB(A) at 23 ft. with generator operating at normal load 52

Engine

Type of Engine GENERAC OHVI

Number of Cylinders 2

Displacement 530cc

Cylinder Block Aluminum w/Cast Iron Sleeve

Valve Arrangement Overhead Valve

Ignition System Solid-state w/Magneto

Governor System Electronic

Compression Ratio 9.5:1

Starter 12 Vdc

Oil Capacity Including Filter (quarts/liters) 1.7Q/1.6L

Oil Reservoir Capacity (quarts/liters) 4.2Q / 4.0L

Operating RPM 2,600

Fuel Consumption

Liquid Propane ft3/hr (gal/hr)

1/2 Load

Full Load

30.8/0.85

48.2/1.32

Required fuel pressure to generator fuel inlet at all load ranges - 11 to 14 inches of water column for LP gas

For Btu content, multipy ft3/hr by 2520

Controls

2-Line Plain Text LCD Display Simple user interface for ease of operation.

Mode Switch

-Auto Puts unit in standby mode, waiting for inverter start call.

-Off Stops unit. Power is removed. Control and charger still operate.

-Manual/Test (start) Start with starter control, unit stays on.

Starter Lock-out Starter cannot re-engage until 5 sec. after engine has stopped.

2.5 Amp Smart Battery Charger Standard

Automatic Voltage Regulator w/Overvoltage Protection Standard

Automatic Low Oil Pressure Shutdown Standard

Overspeed Shutdown Standard, 72Hz

High Temperature Shutdown Standard

Overcrank Protection Standard

Safety Fused Standard

Low Battery Protection Standard

50 Event Run Log Standard

Internal Fault Protection Standard

EcoGen™ - 6 kW specifications

6kW

4 of 4

Generac Power Systems, Inc. • S45 W29290 HWY. 59, Waukesha, WI 53189 • generac.com

Model # Product Discription

5819 26R Wet Cell Battery Every standby generator requires a battery to start the system. Generac offers the

recommended 26R wet cell battery for use with all air-cooled standby product.

5839 Fascia Base Wrap Kit

The fascia base wrap snaps together around the bottom the new air-cooled

generators. This offers a sleek, contoured appearance as well as offering protection

from rodents and insects by covering the lifting holes located in the base.

5703 Paint Kit Bisque Kit

6004 Scheduled Maintenance Kit Generac's scheduled maintenance kits provide all the hardware necessary to

perform complete routine maintenance on a Generac automatic standby generator.

6016 240V Conversion Kit

As off-grid energy systems continue to grow in size and capacity, it is becoming

more common to have a 240V instead of 120V only. This conversion kit allows

the EcoGen to be converted easily from a 120V system to a 240V system and still

maintain a full 6kW output.

6kW

EcoGen™ - 6 kW available accessories

dimensions

Design and specifications subject to change without notice. Dimensions shown are approximate. Contact your Generac dealer for certified drawings. DO NOT USE THESE DIMENSIONS FOR INSTALLATION PURPOSES.

731.9

[28.8]

637.6

[25.1]

LEFT SIDE VIEW

642

[25.3] 76.2 [3.0]

PEA GRAVEL

MINIMUM

TRANSFER

SWITCH

8KW - 17KW

(IF SUPPLIED)

TRANSFER

SWITCH

20KW

(IF SUPPLIED)

1218

[47.9]

FRONT VIEW

1226

[48.3]

EcoGen Series

Otros manuales para ECOGEN 005818-0

Tabla de contenidos

Otros manuales de Inversor de Generac Power Systems

Generac Power Systems

Generac Power Systems RV 45 SERIES Manual de usuario

Generac Power Systems

Generac Power Systems 005040-2 Manual de usuario

Generac Power Systems

Generac Power Systems Guardian 04758-1 Instrucciones de instalación

Generac Power Systems

Generac Power Systems 15 kW EcoGen Hoja de instrucciones

Generac Power Systems

Generac Power Systems GUARDIAN SERIES Manual de usuario

Generac Power Systems

Generac Power Systems Guardian 04389-1 Instrucciones de instalación

Generac Power Systems

Generac Power Systems Transfer Switches and Accessories Manual de usuario

Generac Power Systems

Generac Power Systems 04389-3, 04456-3, 04390-3 Instrucciones de instalación

Generac Power Systems

Generac Power Systems GR160 Manual de usuario

Generac Power Systems

Generac Power Systems iX 2000 Manual de usuario

Generac Power Systems

Generac Power Systems PWRcell XVT076A03 Manual de usuario

Generac Power Systems

Generac Power Systems 004090-2, 004091-2, 004092-2, 004093-2, 004094-2, 004095-2, 004096-2, 004097-2, 004474-0, 004124-1, 004125-1, 004126-1... Manual de usuario