GE GFDS170EH Manual

For answers to your Monogram,® GE Profile™or

GE®appliance questions, visit our website at

geappliances.com or call GE Answer Center®

service, 800.626.2000.

Listed by

Underwriters

Laboratories

Dimensions and Installation Information (in inches)

Exhaust Options: 4-way via rear, right, left and bottom.

Circuit Requirements: An individual, properly grounded

branch circuit, protected by a 30-amp circuit breaker or

a time-delay fuse, is required.

Note: Dryer wall outlet must be located within 36”

of service cord entry and accessible when dryer is

mounted in position.

Installation Information: For complete information, see

installation instructions packed with your dryer.

27 33

39-3/8

4-3/8

5-3/8

Electric Dryer Rating

240V 5600W, 24A, 60Hz

208V 4400W, 22A, 60Hz

Specification Created 4/14

GFDS170EH

GE®7.5 cu. ft. capacity frontload electric dryer with Steam and stainless steel drum

For answers to your Monogram,® GE Profile™or

GE®appliance questions, visit our website at

geappliances.com or call GE Answer Center®

service, 800.626.2000.

3-1/2

24-7/8

50-5/8

39-3/8

Special Installation Requirements:

Stacked Installation:

Brackets for stacking dryer over washer are not included with the dryer.

Order part no. GEFLSTACK or part no. WE25X10018.

Alcove or Closet Installation:

• If your dryer is approved for installation in an alcove or closet, it will be

stated on a label on the dryer back.

• The dryer MUST be exhausted to the outside.

• Minimum clearances between dryer cabinet and adjacent walls or other

surfaces are: 0" either side, 3" front and rear

• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52".

• Closet doors must be louvered or otherwise ventilated and must contain a

minimum of 60 sq. in. of open area equally distributed. If this closet contains

both a washer and a dryer, doors must contain a minimum of 120 sq. in. of

open area equally distributed.

• No other fuel-burning appliance shall be installed in the same closet with

a gas dryer.

Bathroom or Bedroom Installation:

• The dryer MUST be exhausted to the outdoors.

• The installation must conform with the local codes, or in the absence of

local codes, with the National Electric Code and National Fuel Gas Code,

ANSI Z223 for gas dryers.

Minimum Clearance other than Alcove or Closet Installations:

• Minimum clearances to combustible surfaces 0" both sides, 3" rear.

For more information on venting kits and accessories,

please call 1-800-GE-CARES.

Listed by

Underwriters

Laboratories

Stacked Dimensions (in inches)

28-3/4

Pedestal Dimensions (in inches)

SBSD137HWW - white

This optional 13" pedestal raises

the door opening and height of

the washer or dryer. Feet on 13"

pedestal allow it to adjust to

13-3/8" height.

GFDS170EH

GE®7.5 cu. ft. capacity frontload electric dryer with Steam and stainless steel drum

Specification Created 4/14

Dryer Exhausting Information – Metal Duct Only

For complete information, see installation instructions packed with your dryer.

Ducting Materials: For best performance, this dryer should be vented with 4” diameter

all rigid metal exhaust duct. If rigid metal duct cannot be used, then UL-listed flexible

metal (semi-rigid) ducting can be used (Kit WX08X10077). In special installations, it may

be necessary to connect the dryer to the house vent using a flexible metal (foil-type) duct.

A UL-listed flexible metal (foil-type) duct may be used ONLY in installations where rigid

metal or flexible metal (semi-rigid) ducting cannot be used AND where a 4” diameter can

be maintained throughout the entire length of the transition duct. Please see installation

instruction packed with your dryer for complete instructions when using flexible metal

(foil type) ducting.

Exhaust Length Calculation:

1. Determine the number of 90° turns needed for your installation. If you exhaust to the

side or bottom of dryer, add one turn.

2. The maximum length of 4’ rigid (aluminum or galvanized) duct which can be tolerated is

shown in the table.

A turn of 45° or less may be ignored. Two 45° turns within the duct length should be

treated as a 90° elbow.

A turn over 45° should be treated as a 90° elbow.

Dryers must be exhausted to the outside.

Caution: For personal safety do not terminate exhaust into a chimney, under any enclosed

house floor (crawl space), or into an attic, since the accumulated lint could create a fire

hazard or moisture could cause damage. Never terminate the exhaust into a common duct

or plenum with a kitchen exhaust, since the combination of lint and grease could create a

fire hazard.

Exhaust ducts should be terminated in a dampered wall cap to prevent back drafts, bird

nesting, etc. The wall cap must also be located at least 12" above the ground or any other

obstruction with the opening pointed down.

For more information on venting kits and accessories, please call 1-800-GE-CARES.

Listed by

Underwriters

Laboratories

Best performance

Domestic

dryer models

Maximum length of 4"

dia. rigid metal duct

Number

90°

turns

Exhaust hood type

opening

2-1/2"

opening

7.5 cu. ft.

capacity models

electric dryers

90 ft.

60 ft.

45 ft.

35 ft.

25 ft.

60 ft.

45 ft.

35 ft.

25 ft.

15 ft.

2-1/2

1-3/4

3-1/2

Electrical

Connection

Gas Pipe

Connection

Specification Created 4/14

GFDS170EH

GE®7.5 cu. ft. capacity frontload electric dryer with Steam and stainless steel drum

Features and Benefits

• Steam Refresh - Rejuvenate lightly worn clothes by getting rid of wrinkles and odors

with this convenient setting using the power of steam

• Steam Dewrinkle - Stored or wrinkled clothes come out wrinkle-free with this helpful

setting that uses steam to refresh and dry a load of any size

• HE Sensor Dry - Keep your clothes looking and feeling their best. Dual thermistors

continually monitor temperature with a sensor bar that measures moisture to

prevent over-drying

• Quick Dry - Quickly dries items and small loads for families on the go

• Damp Dry - Allows you set an alert to remove select items for hang-drying or

damp ironing

• Dura Drum interior - Provides long-lasting dependability

• Delay start - Set the dryer to begin cycles whenever it’s convenient for you

• Sanitize - Extends heating cycle time to reduce certain types of bacteria by 99.99%*

*The Sanitize cycle is certified by NSF International to NSF Protocol P9 Sanitization

Performance of Residential Clothes Dryers

• Bulky Bedding cycle - Dries larger items, such as comforters, blankets and jackets

• Model GFDS170EHWW – White

• Model GFDS170EHDG – Diamond Gray

Specification Created 4/14

GFDS170EH

GE®7.5 cu. ft. capacity frontload electric dryer with Steam and stainless steel drum

Manuales populares de Secadora de otras marcas

Bosch

Bosch WTA79200GB Manual de usuario

Amana

Amana W10233410A Manual de usuario

Miele

Miele TWH 780 WP Manual de usuario

Asko

Asko T760 Manual de usuario

Alliance Laundry Systems

Alliance Laundry Systems 25 Series Manual de usuario

Bosch

Bosch Logixx 10 WTB76556GB Hoja de especificaciones

STIEBEL ELTRON

STIEBEL ELTRON Ultronic S Manual de instrucciones

Electrolux

Electrolux EW2H328R2 Manual de usuario

Beko

Beko DS8433RX1M Manual de usuario

Dawlance

Dawlance Spinner DS 6000 C Manual de usuario

Electrolux

Electrolux TP5080TW Manual de usuario

AEG

AEG TR838P4OB Manual de usuario

Indesit

Indesit IDV 75 Manual de usuario

Infiniton

Infiniton SD-DG85C Manual de usuario

BOMANN

BOMANN WT 5019 Manual de usuario

Alliance Laundry Systems

Alliance Laundry Systems TMB795C Manual de usuario

Asko

Asko T793C Manual de usuario

Kenmore

Kenmore 8041 - 5.8 cu. Ft. Capacity Electric Dryer Manual de usuario