Gaggia PLATINUM VOGUE Manual de funcionamiento
Emissione Luglio 2007 REV.00
TECHNICAL SERVICE
MANUAL
Ideas with Passion
PLATINUM TECHNICAL SERVICE MANUAL (Rev 00 Aug.06): CONTENTS
1. Introduction (rev.00)
1.1 Documentation required
1.2 Tools and equipment required
1.3 Safety warnings
1.4 Platinum range
2. Technical data (rev.00)
2.1 Product technical data
2.2 Internal / external machine components
3. Summarised instructions (rev.00)
3.1 Client and programming menu (rev.00)
3.2 Maintenance and cleaning (rev.00)
4. Diagrams (rev.00)
4.1 Wiring diagram (rev.00)
4.2 Water circuit diagram (rev.00)
5. Troubleshooting (rev.00)
5.1 Test functions (rev.00)
5.2 Diagnostics function (rev.00)
5.3 Error messages for Service personnel (rev.00)
5.4 Problems, Causes, Remedies (rev.00)
6. Operating logic (rev.00)
6.1 Resetting coffee grounds drawer (rev.00)
6.2 Water reserve (rev.00)
6.3 Motorized tank (rev.00)
6.4 Prima water (rev.00)
6.5 SBS valve (rev.00)
6.6 Solenoid pilot (rev.00)
7. Component assembly / disassembly (rev.00)
7.1 Top cover (rev.00)
7.2 Right and left-side cover (rev.00)
7.3 Electronics (rev.00)
7.4 Gearmotor (rev.00)
7.5 Pump (rev.00)
7.6 Heater and solenoid pilot unit (rev.00)
7.7 Oetiker clamp assembly and disassembly (rev.00)
7.8 Coffee grinder (rev.00)
7.9 Grinder adjustment/assembly and disassembly (rev.00)
7.10 Grinder adjustment during servicing (rev.00)
7.11 Motorized drip tray (rev.00)
8. Service schedule (rev.00)
8.1 Routine maintenance Check list (rev.00)
9. Exploded drawing (rev.00)
TALEA Contents
REV00 - August 06 1/1
SECTION 1
INTRODUCTION
REV.00
TALEA Section 01
REV00 - August 06
1.1 Documentation required
The following technical documentation is required for repairs:
Instruction booklet for specific model.
Technical documentation for specific model (diagrams, exploded drawings).
1.2 Tools and equipment required
As well as the standard equipment, the tools listed below are required.
1 special screwdriver with Torx T10 tip.
1 digital thermometer with full 200°C scale.
This must be suitable for measuring in liquids and on surfaces.
1 set of pliers for Oetiker clamps.
1 pincer.
1 CC -A - Vdc tester.
1.3 Safety warnings
Before starting operations on the machine, consult the relative instruction booklet.
Observe all current standards related to the repair of domestic appliances.
Always disconnect the power plug from the mains before carrying out repairs. Simply turning
off the main switch is not sufficient to prevent electrical discharge.
This domestic appliance is rated with insulation class I.
On completion of repairs, the insulation and dielectric rigidity tests must be performed.
1/2
TALEA Section 01
REV00 - August 06
Ideas with Passion
1.4 Platinum range
- Touch Screen
- S B S
- Cup warmer
- Motorized tank
- Milk adapter
- Rapid Steam
- Pre-ground option
- 24x2 display
- Ring selector
- S B S
- Cup warmer
- Motorized tank
- Milk adapter
- Rapid Steam
- Pre-ground option
- 10x2 display
- Ring selector
- S B S
- Milk adapter
- Rapid Steam
- Pre-ground option
- Height adjustment ringnut
- S B S
- Milk adapter
- Rapid Steam
VISION
SWING UP
SWING
VOGUE
TALEA Section 01
REV00 - August 06
2/2
EVENT
- S B S
- Rapid Steam
TALEA - ODEA Cap. 01
REV00 - Luglio 07 3/3
SECTION 2
TECHNICAL DATA
REV.00
TALEA Section 02
REV00 - August 06
2.1 Product technical data
Power supply and output: 230 V~, 50/60 Hz, 1300 W.
Temperature control: 1 (NTC) variable resistor sensor – transmits the value
to the electronic board.
Safety system: 2 x 175°C manual reset thermostats.
Coffee heat exchanger output:
Stainless steel
1300 W – to dispense coffee, hot water and steam.
Motorized tank only on
Platinum Vision e Swing Up 24V stepper motor.
Water level and drip
tray sensor:
Capacitive sensor
Gearmotor: 33VC with 2 directions of rotation.
Cup warmer plate:
Solo Platinum Vision e Swing Up Activated via MENU display.
PTC Type.
Pump: Ulka reciprocating piston type with thermal cutout at
100°C,
48 W, 230V, 50 Hz, Type EX5 approx. 13-15 bars.
Pressure relief valve: Opening at approx. 18-20 bars.
Water filter: In tank.
Coffee grinder: DC motor with ceramic plate
grinders.
Solenoid pilot: 15 VA.
Coffee dose control: Hall sensor – Pulse control. Dose adjustment can
be set from approx. 7 to 10.5 g.
Amps: During heating phase- approx. 5.6 A.
Dimensions: l x h x d in mm: 310/390/440
Weight: 10 kg (average).
Water tank capacity: 1.7 l.
Coffee container capacity: 250g coffee granules.
Coffee grounds drawer capacity: 14
Heatex changer capacity: Approx. 10 cc.
Water circuit filling time: Approx. 15 sec on first filling cycle.
Heating time: Approx. 45 sec.
Dispensed drink temperature: Approx. 73°C - 83°C
Grinding time: Approx. 8-10 sec.
1/4
TALEA Section 02
REV00 - August 06
on 02
REV00 - August 06
4/4
Internal components
Pump
Static
eliminator
Turbine
Heater
Coffee grinder
Power
board
CPU
Card
Motorized tank
stepper motor
Solenoid pilot
Ideas with Passion
SECTION 3
BRIEF
INSTRUCTIONS
REV.00
TALEA Section 03
REV00 - August 06
Otros manuales para PLATINUM VOGUE
1
Este manual sirve para los siguientes modelos
4
Tabla de contenidos
Otros manuales de Cafetera de Gaggia
Gaggia
Gaggia Carezza Series Manual de usuario
Gaggia
Gaggia 10002008 Manual de usuario
Gaggia
Gaggia Academia Manual de usuario
Gaggia
Gaggia 10002841 Manual de usuario
Gaggia
Gaggia BESANA Manual de usuario
Gaggia
Gaggia cubika plus Manual de usuario
Gaggia
Gaggia MAGENTA MILK Manual de usuario
Gaggia
Gaggia RI8154/80 Manual de usuario
Gaggia
Gaggia RI8177/50 Manual de usuario
Gaggia
Gaggia COFFEE DELUXE Manual de usuario
Gaggia
Gaggia 10002511 Manual de usuario
Gaggia
Gaggia Topazio Manual de usuario
Gaggia
Gaggia SUP 043U Manual de usuario
Gaggia
Gaggia CUBIKA Manual de usuario
Gaggia
Gaggia RI9380 Manual de usuario
Gaggia
Gaggia Baby Twin Manual de usuario
Gaggia
Gaggia GRAN DELUXE RI8425 Manual de usuario
Gaggia
Gaggia Carezza Manual de usuario
Gaggia
Gaggia Ruby PRO Manual de usuario
Gaggia
Gaggia Brena Manual de usuario
