Funkwerk W1002 Manual de usuario
Copyright © 2005
Funkwerk Enterprise Communications GmbH
No part of this documentation may be reprinted without the
prior written permission of Artem GmbH.
Funkwerk Enterprise Communications GmbH
Südwestpark 94
D-90449 Nuremberg, Germany
http://www.funkwerk-ec.com
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Windows, Windows NT and Windows 2000 are registered trademarks of Microsoft Corporation.
Other company, trademark, or product names not explicitly mentioned here are trademarks or registered trademarks of
their respective owners and are protected.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Imprint
This documentation was compiled and translated by ExperTeach GmbH.
Status: 05 May 2006 5400407283
I
Table of Contents
Preface ..............................................................................................................III
Knowledge Prerequisites .................................................................................IV
Manual Conventions .......................................................................................IV
Important Text Passages .................................................................................. V
funkwerk Service ............................................................................................... V
The Product Package .......................................................................................VI
Hardware Description and Commissioning ............................................. 1-1
The funkwerk Wx002 ....................................................................... 1-1
The Power Supply ............................................................................. 1-2
Commissioning ................................................................................. 1-3
After Successful Commissioning ..................................................... 1-6
The Basic Configuration ............................................................................. 1-7
Booting the ComPoint Manager ...................................................... 1-7
Performing the Basic Configuration ................................................ 1-8
Conventions for Interface Names .................................................... 1-9
Selecting the Frequency in the 2.4 GHz Band ............................... 1-11
Configuring the Ethernet ............................................................... 1-12
Security Measures for your Wireless LAN .................................... 1-12
Resetting the Password ................................................................... 1-16
The ComPoint Manager .............................................................................. 2-1
The User Interface of the ComPoint Manager ................................ 2-2
The Functions of the ComPoint Manager ...................................... 2-4
The funkwerk Wx002 User Interface ......................................................... 3-1
The User Interface via Telnet ........................................................... 3-1
The Browser-Based User Interface .................................................. 3-5
The User Interface via SSH .............................................................. 3-9
The User Interface via Secure Web .................................................. 3-9
funkwerk Wx002 AccessPoint .................................................................... 4-1
The Status Menu ............................................................................... 4-2
The Config Menu ............................................................................ 4-20
The Control Menu .......................................................................... 4-70
The Refresh Command .................................................................. 4-92
II
The Help Command ....................................................................... 4-92
The Exit Command ........................................................................ 4-92
funkwerk Wx002 Bridge Port ..................................................................... 5-1
Using the funkwerk Wx002 Bridge .................................................. 5-1
Preconditions for Use of Links with funkwerk Wx002 Bridges ..... 5-5
Configuring the funkwerk Wx002 Bridge ....................................... 5-8
VLAN Configuration ................................................................................... 6-1
Setting up a VLAN ............................................................................ 6-2
Adding a Port to a VLAN ................................................................. 6-2
Viewing the VLAN Configuration ................................................... 6-4
Defining Rules for Receiving Frames on Individual Ports ............. 6-4
Viewing the Receive Rules ................................................................ 6-6
The LED States ............................................................................................ A-1
Assignment of LEDs to Ports .......................................................... A-1
Technical Data and Specifications ............................................................ B-1
Frequencies and Channels ................................................................ B-1
Specifications ..................................................................................... B-1
Glossary ....................................................................................................... C-1
Index ............................................................................................................ D-1
III
Preface
The W1002 and W2002 access points are manufactured environ-
ment friendly and are compliant to the RoHS directive. They sup-
port the latest WLAN technology and have been designed for use
in professional environments in particular.
Depending on the model, the access points are equipped with one
or two radio modules and two or four antennas for antenna diver-
sity for optimized coverage under heavy conditions, thus allowing
them to meet a wide variety of requirements.
When using data of different applications it´s important to prio-
rize some of them. The Wx002 series supports WMM (Wireless
Multimedia), a technique to priorize certain data of applications
like video or voice in order to provide maximum of transmission
quality for time critical applications.
In addition to the WLAN standards 802.11b and 802.11g, these
devices also support 802.11a as well as its European counterpart,
the 802.11h, to enable a data throughput rate of up to 54 Mbps in
the 5 GHz frequency range as well. This is particularly advisable
for building bridge solutions in outdoor areas.
Furthermore, these products also support such modem processes
as Multi SSID and VLAN, with which up to 16 virtual access
points can be mapped per radio module. These access points can
be secured one against the other, thus allowing guest access for
customers, for example. Different security levels and encryption
processes can be assigned to each SSID.
To ensure highest security, the devices support the 802.1x and
802.11i (WPA, WPA2) security standards. The systems can be reli-
ably configured using SSH, SSL or alternatively via https (in pre-
paration) as well. When used as bridges, the devices support the
automatic bridge mode and are able to secure bridge connections
with the help of TKIP and AES encryption.
IV
Knowledge Prerequisites
It is assumed that the reader possesses or is in the process of acqui-
ring the following knowledge:
• Basic knowledge of the setup of networks,
• Knowledge of the basic networking terms and concepts, such
as server, client, and IP address,
• Basic understanding of Microsoft Windows operating systems.
Manual Conventions
This manual uses the following text styles for the purpose of gui-
ding through the instructions:
• References to other manuals, chapters, or sections are repre-
sented in blue (on the online help screen and in the PDF ver-
sion of the manual) and are underlined.
Example:
See Manual Conventions.
• Menus, folders, functions, hardware labels, switch settings,
systems messages, etc. are represented in
italics.
Example:
Push the switch to the off position.
• Menus, functions, and subfunctions are separated from each
other by the “>” character.
Example:
Select File > Open...
• Keys you need to press simultaneously are indicated by a “+”
character preceding the second key.
Example:
Press Alt+A.
V
Important Text Passages
Important text passages are marked with symbols in the margin,
which have the following meanings:
Caution:
Contains information which has to be observed in order to avoid
damaging the hardware or software.
Note:
Contains important general or additional information on a speci-
fic topic.
Prerequisite:
Advises you of any prerequisites which have to be fulfilled to per-
form the subsequent steps.
funkwerk Service
Do you have any questions on our products or do you require spe-
cific information on artem ComPoint?
You can contact us, as follows:
• Internet: http://www.artem.de/
VI
The Product Package
The following components should be contained in your funkwerk
Wx002 product package.
• Cable sets/power supply:
• Ethernet cable (RJ-45, STP)
• Power supply (12 V/220 V)
• Self-adhesive feet, for use of Wx002 as desktop device
• Antennas:
• Mounting kit
• 2 external, screw-on standard antennas (at W1002)
• 4 external, screw-on standard antennas (at W2002)
• Companion CD-ROM
•Documentation:
• User Manuel (on CD)
• Quick start flyer (printed)
• Safety Instructions (printed)
• R&TTE Compliance Information (printed)
Note:
If your funkwerk product package does not meet your demands,
please contact our artem Service (see Section funkwerk Service).
You can find a description of the standard components of the
funkwerk Wx002 product package in Chapter Hardware Descrip-
tion and Commissioning.
Hardware Description and Commissioning
1-1
1
Hardware Description and Commissioning
This section contains photographs and figures of the individual
components of the funkwerk Wx002 product package, as well as
further information on the parts in question.
The funkwerk Wx002
The funkwerk Wx002 can be equipped with various antenna
systems. Optionally, external standard antennas, which are
screwed on, can be used. It can either be used as a tabletop unit, or
it can be wall-mounted using the clips underside the case.
Front View of the W1002/W2002
The front side of the W1002 accommodates the two ports to screw
on the external standard antennas. W2002 offers two connectors
for external standard antennas at the front and at the rear.
W1002
W2002
Hardware Description and Commissioning
1-2
Rear View of the funkwerk Wx002
The rear side of the Wx002 accommodates the jack for the power
supply and an RJ45 jack for the Ethernet connection. Additionally
the two connectors for external standard antennas (W2002 only).
The Power Supply
The power supply is shipped as plug-in power supply.
Note:
If you require foreign adapters or power supplies, please contact
our funkwerk Service (see Section funkwerk Service).
The Wx002 product package contains a power supply. For data
informations see Section Technical Data and Specifications on
Page B –1.
Jack for
Power Supply
Ports for
Ethernet ETH1/ETH2
(RJ45)
I/O Jack
(DB15)
Ports to screw on the external
antennas (only at W2002)
Otros manuales para W1002
2
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Punto de acceso inalámbrico de Funkwerk
