Fujitsu ScanPartner 3091DC Manual de usuario

3091DC Image Scanner

OPERATION GUIDE

C150-E140-03EN

M3091DC Image Scanner Operation Guide

FOR SAFE OPERATION

Treatment of This Manual

Since this manual contains important information for safely using the 3091DC, please read

it thoroughly before using the product. Use the 3091DC only after thoroughly reading and

understanding this manual, especially the section "Important Alert Messages" in this

manual. Keep this manual handy, and store it carefully.

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses, and can radiate radio frequency energy and, if not installed and

used in accordance with the instruction manual, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user

is encouraged to try to correct the interference by one or more of the following measures:

•Adjust or relocate the receiving antenna.

•Increase the distance between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from the circuit the receiver

is connected to.

•Consult your dealer or an experienced radio/TV technician for help.

FCC warning: Changes or modifications not expressly approved by the party responsible

for compliance could void the user's authority to operate the equipment.

Notes

•The use of a non-shielded interface cable with the referenced device is prohibited.

•The length of the SCSI interface cable must be 2 meters (6 feet) or less.

•The length of the power cord must be 3 meters (10 feet) or less.

M3091DC Image Scanner Operation Guide

Le pésent appareil numérique n'ément pas de bruits radioélectriques dépassantles limites

applicables aux appareils numériques de la classe B prescrites dans le Règlement sur le

brouillage radioélectrique dicté par le ministère des Communications du Canada.

Hiermit wird bescheinigt, daß der/die/das

3091DC in Übereinsstimmung mit den Bestimmungen der AmtsblVfg 243/1991 funk-

entstört ist. Der Deutschen Bundespost wurde das Inverkehrbringen dieses Gerätes

angezeigt und die Berechtigung zur Überprüfung der Serie auf Einhaltung der

Bestimmungen eingeräumt.

Maschinenlärminformationsverordnung 3. GSGV, 18.01.1991: Der höchste

Schalldruckpegel beträgt 70dB (A) oder weniger gemäß ISO 7779.

Warning: This equipment may cause electromagnetic interference. It has not been tested

to show compliance with AS3548 Class A equipment, which is designed to provide

reasonable protection against such interference.

Operation of this equipment in a residential area is likely to cause interference in which case

the user at his own expense will be required to take whatever measures may be required to

correct the interference.

Third Edition December 1999

The contents of this manual may be revised without prior notice.

The contents of this manual shall not be disclosed in any way or reproduced in any media

without the express written permission of Fujitsu Limited.

M3091DC Image Scanner Operation Guide

Preface

Thank you very much for your purchase of the 3091DC Image Scanner.

The 3091DC Image Scanner can produce high-quality color,greyscale or

black and white images.

This manual explains the basic handling of the scanner, read it carefully to

use the scanner properly.

In this manual, the MicrosoftWindows NTOperating System is

referred to as Windows NT, the MicrosoftWindows 95Operating

System is referred to as Windows 95, and the MicrosoftWindows 98

Operating System is referred to as Windows 98.

Microsoft, Windows, and Windows NT are registered trademarks of

Microsoft Corporation of the U.S. in the United States and other countries.

Other company names or product names appearing in this manual are

trademarks or registered trademarks of individual companies.

M3091DC Image Scanner Operation Guide

Important Notes to Users

Every user is requested to use this product including the manuals and

software supplied with the product at the user's own responsibility.

Fujitsu assumes no liability with respect to any damage or loss caused to

data as the result of using this product.

Please understand that the warranty range for failure of this product will

never exceed the amount of money paid by the user for the product.

Fujitsu prohibits any user from using software supplied with this product

or any software updates for this product to be used for any purpose other

than incorporation into this product. Fujitsu also prohibits any user from

reworking or disassembling such software.

M3091DC Image Scanner Operation Guide

Conventions for Alert Messages

Alert messages

This manual uses alert messages to prevent users and bystanders from

being injured or from suffering damage to their property. An alert

message consists of an alert symbol and alert statements. The alert signals

and their meanings are as follows.

WARNING This indicates a hazardous situation that could

result in serious personal injury if the user

does not perform the procedure correctly.

CAUTION This indicates a hazardous situation that could

result in minor or moderate personal injury if

the user does not perform the procedure

correctly. This alert signal also indicates that

damage to the products or other property may

occur if the user does not perform the

procedure correctly.

In addition to the above-cited signals, the

following symbols are also used to provide

detailed information concerning injury or

damage:

Electric shock The symbol marked with

indicates a warning or caution.

The meaning of an alert is

illustrated in the symbol. (The

example at left indicates caution

against an electric shock.)

M3091DC Image Scanner Operation Guide

Disassembly The symbol marked with

indicates what must not be done

(prohibited action). The meaning

of the action is illustrated in the

symbol. (The example at left

indicates the prohibition of

disassembly.)

Plug The symbol marked with

indicates what must be observed.

The meaning of the action is

illustrated in the symbol. (The

example at left directs the

operator to disconnect the power

plug from the outlet.)

Otros manuales para ScanPartner 3091DC

Tabla de contenidos

Otros manuales de Escáner de Fujitsu

Fujitsu

Fujitsu S510M - ScanSnap - Document Scanner Manual de usuario

Fujitsu

Fujitsu ScanSnap iX1600 Guía de configuración

Fujitsu

Fujitsu S510 - ScanSnap - Document Scanner Manual de usuario

Fujitsu

Fujitsu fi-5650C Manual

Fujitsu

Fujitsu ScanSnap N1800 Manual

Fujitsu

Fujitsu fi-5650C Guía de configuración

Fujitsu

Fujitsu ScanSnap S300 Manual de usuario

Fujitsu

Fujitsu fi-7300NX Guía de configuración

Fujitsu

Fujitsu fi 5750C - Document Scanner Manual

Fujitsu

Fujitsu fi-6000N Guía de configuración

Fujitsu

Fujitsu fi-4110EOX2/ScanSnap Guía de configuración

Fujitsu

Fujitsu fi-6400 Manual de usuario

Fujitsu

Fujitsu S1500M - ScanSnap - Document Scanner Manual de usuario

Fujitsu

Fujitsu FI-4990C Guía de configuración

Fujitsu

Fujitsu N7100 Guía de configuración

Fujitsu

Fujitsu ScanSnap Manual de usuario

Fujitsu

Fujitsu Scan Snap iX 500 Manual de usuario

Fujitsu

Fujitsu fi 5750C - Document Scanner Guía de configuración

Fujitsu

Fujitsu FI 4220C - Document Scanner Manual

Fujitsu

Fujitsu ScanSnap fi-5110EOX Manual

Fujitsu

Fujitsu Fi-5110EOX2 - ScanSnap! - Document Scanner Manual de usuario

Fujitsu

Fujitsu ScanPartner 93GX Manual de usuario

Fujitsu

Fujitsu FI-4120C Manual

Fujitsu

Fujitsu fi-7160 Manual

Manuales populares de Escáner de otras marcas

Plustek

Plustek Scanner Manual de usuario

Z/I Imaging

Z/I Imaging PhotoScan 2001 Manual de usuario

Renkforce

Renkforce DS100-5M Manual de usuario

Image Access

Image Access WideTEK A2 Manual de usuario

Canon

Canon imageFORMULA CR-120N Manual de usuario

GeoSlam

GeoSlam ZEB Horizon Instrucciones de instalación

Kodak

Kodak i5800 Scanner Manual de usuario

Kodak

Kodak i7300 Manual de usuario

Revopoint

Revopoint POP Manual de usuario

Eddyfi Technologies

Eddyfi Technologies Floormap X Manual de usuario

Faselase

Faselase F6 Manual de usuario

Uniden

Uniden BC340CRS Manual de usuario

Infinite Peripherals

Infinite Peripherals INFINEA TAB M Manual de usuario

Mustek

Mustek PageExpress 4800 Pro Manual de usuario

Optex

Optex 750830 Manual de usuario

Innova

Innova 5210 Manual de usuario

Visioneer

Visioneer CardReader 100 Guía de inicio rápido

Rohde & Schwarz

Rohde & Schwarz TSME6 Manual de usuario