FujiFilm GFX 50R Manual de usuario
Owner’s Manual
BL0000####-20Z EN
2
Introduction
Thank you for your purchase of this product. Be sure that you
have read this manual and understood its contents before
using the camera. Keep the manual where it will be read by
all who use the product.
For the Latest Information
For the latest information on this product, including the latest ver-
sions of the manuals and sample color photographs, visit:
http://fujifilm-dsc.com/manuals/
The site can be accessed not only from your computer but also
from smartphones and tablets.
For information on rmware updates, visit:
http://www.fujifilm.com/support/digital_cameras/software/
3
About This Manual
This manual contains instructions for your FUJIFILM GFX50R
digital camera. Be sure you have read and understood its
contents before proceeding.
Symbols and Conventions
The following symbols are used in this manual:
O
Information that should be read to prevent damage to the
product.
N
Additional information that may be helpful when using the
product.
PPages on which related information may be found.
Menus and other text in the displays are shown in bold. Illustrations
are for explanatory purposes only; drawings may be simplied, while
photographs are not necessarily taken with the model of camera
described in this manual.
Terminology
The optional SD, SDHC, and SDXC memory cards the camera uses
to store pictures are referred to as “memory cards”. The electronic
viewnder may be referred to as the “EVF” and the LCD monitor as
the “LCD”.
4
Charging the Battery
The battery is not charged at shipment. Before use, charge
the battery in the supplied battery charger.
O
An NP-T125 rechargeable battery is supplied with the camera. Charging
takes about 140 minutes.
1 Connect the plug adapter.
The plug adapter supplied with the camera varies with the
country or region of purchase; use the adapter appropriate to
your country or region as described in the enclosed notice.
2 Place the battery in the charger.
Insert the battery in the orientation shown
by the arrow.
3 Plug the charger in.
Plug the charger into an indoor power out-
let. The charging indicator will light.
4 Charge the battery.
Remove the battery when charging is complete.
5
Charging the Battery
The Charging Indicator
The charging indicator shows battery charge status as follows:
Charging indicator
Charging indicator
Battery status
Battery status
Action
Action
Off Battery not inserted. Insert the battery.
Battery fully charged. Remove the battery.
On Battery charging. —
Blinks Battery fault. Unplug the charger and
remove the battery.
O
The supplied charger is compatible with power supplies of 100 to 240
volts (a plug adapter may be needed for overseas use).
Do not ax labels or other objects to the battery. Failure to observe
this precaution could make it impossible to remove the battery from the
camera.
Do not short the battery terminals. The battery could overheat.
Read the cautions in “The Battery and Power Supply”.
Use only battery chargers designated for use with the battery. Failure to
observe this precaution could result in product malfunction.
Do not remove the labels from the battery or attempt to split or peel the
outer casing.
The battery gradually loses its charge when not in use. Charge the bat-
tery one or two days before use. If the battery fails to hold a charge, it has
reached the end of its charging life and must be replaced.
Unplug the charger when it is not in use.
Remove dirt from the battery terminals with a clean, dry cloth. Failure to
observe this precaution could prevent the battery from charging.
Note that charging times increase at low temperatures.
6
Inserting the Battery
After charging the battery, insert the battery in the camera as
described below.
1 Open the battery-chamber cover.
Slide the battery-chamber latch as shown
and open the battery-chamber cover.
O
Do not open the battery-chamber cover when
the camera is on. Failure to observe this pre-
caution could damage image les or memory
cards.
Do not use excessive force when handling the
battery-chamber cover.
2 Insert the battery.
Using the battery to keep the battery latch
pressed to one side, insert the battery con-
tacts rst in the direction shown by the arrow.
Conrm that the battery is securely latched.
O
Insert the battery in the orientation shown. Do
not use force or attempt to insert the battery
upside down or backwards. The battery will
slide in easily in the correct orientation.
3 Close the battery-chamber cover.
Close and latch the cover.
O
If the cover does not close, check that the
battery is in the correct orientation. Do not at-
tempt to force the cover shut.
7
Inserting the Battery
Removing the Battery
Before removing the battery, turn the camera o and open the battery-cham-
ber cover.
To remove the battery, press the battery latch to the side,
and slide the battery out of the camera as shown.
O
The battery may become hot when used in
high-temperature environments. Observe caution
when removing the battery.
8
Inserting Memory Cards
Pictures are stored on memory cards (sold separately).
1 Open the memory card slot cover.
Unlatch and open the cover.
O
Do not open the memory card-slot cover when
the camera is on. Failure to observe this precau-
tion could damage image les or memory cards.
2 Insert the memory card.
Holding the card in the orientation shown,
slide it in until it clicks into place at the back
of the slot.
O
Be sure card is in the correct orientation; do not
insert at an angle or use force.
3 Close the memory card slot cover.
Close and latch the cover.
Removing Memory Cards
Before removing memory cards, turn the camera o and open the memory
card slot cover.
Press and release the card to eject it part way (to prevent
the card falling from the slot, press the center of the card
and release it slowly, without removing your nger from
the card). The card can then be removed by hand.
9
Inserting Memory Cards
Using Two Cards
The camera can be used with two cards, one in each of its two slots.
At default settings, photos are saved to the card in the second slot
only when the card in the rst slot is full. This can be changed using
DSAVE DATA SETTING> CARD SLOT SETTING (STILL IMAGE).
Option
Option
Description
Description
Display
Display
SEQUENTIAL
(default)
The card in the second slot is used only when the card in
the first slot is full. If the second slot is selected for DSAVE
DATA SETTING> SWITCH SLOT (SEQUENTIAL), re-
cording will start on the card in the second slot and switch to
the first slot when the card in the second slot is full.
BACKUP Each picture is recorded twice, once to each card.
RAW/JPEG
As for SEQUENTIAL, except that the RAW copy of pictures
taken with FINE + RAW or NORMAL + RAW selected for
HIMAGE QUALITY SETTING> IMAGE QUALITY will
be saved to the card in the first slot and the JPEG copy to the
card in the second slot.
The card used to store movies can be selected using DSAVE DATA
SETTING> MOVIE FILE DESTINATION.
Compatible Memory Cards
FUJIFILM and SanDisk SD, SDHC, and SDXC memory cards have
been approved for use in the camera; UHS-II cards can be used in
both slots, while cards with a UHS speed class of 3 or better are
recommended for movies. A complete list of approved memory
cards is available at http://www.fujifilm.com/support/digital_cameras/
compatibility/. Operation is not guaranteed with other cards. The
camera can not be used with xD-Picture Cards or MultiMediaCard
(MMC) devices.
10
Inserting Memory Cards
O
Do not turn the camera o or remove the memory card while the memory
card is being formatted or data are being recorded to or deleted from the
card. Failure to observe this precaution could damage the card.
Memory cards can be locked, making it impossible
to format the card or to record or delete images. Be-
fore inserting a memory card, slide the write-protect
switch to the unlocked position.
Format memory cards before rst use, and be sure to reformat all mem-
ory cards after using them in a computer or other device.
Memory cards are small and can be swallowed; keep out of reach of chil-
dren. If a child swallows a memory card, seek medical assistance imme-
diately.
miniSD or microSD adapters that are larger or smaller than memory cards
may not eject normally; if the card does not eject, take the camera to an
authorized service representative. Do not forcibly remove the card.
Do not ax labels or other objects to memory cards. Peeling labels can
cause camera malfunction.
Movie recording may be interrupted with some types of memory card.
Formatting a memory card in the camera creates a folder in which pic-
tures are stored. Do not rename or delete this folder or use a computer
or other device to edit, delete, or rename image les. Always use the
camera to delete pictures; before editing or renaming les, copy them to
a computer and edit or rename the copies, not the originals. Renaming
the les on the camera can cause problems during playback.
Otros manuales para GFX 50R
3
Tabla de contenidos
Otros manuales de Cámara digital de FujiFilm
FujiFilm
FujiFilm FinePix 4800 ZOOM Manual de usuario
FujiFilm
FujiFilm X-PRO2 Manual de usuario
FujiFilm
FujiFilm FinePix F440 Manual de usuario
FujiFilm
FujiFilm FinePix S602 Zoom Manual de usuario
FujiFilm
FujiFilm X100F Manual de usuario
FujiFilm
FujiFilm FinePix J10 Guía de instalación
FujiFilm
FujiFilm FinePix F550EXR Manual de usuario
FujiFilm
FujiFilm X-E4 Manual de usuario
FujiFilm
FujiFilm FinePix F440 Manual de usuario
FujiFilm
FujiFilm FinePix Z 2 Manual de usuario
FujiFilm
FujiFilm FINEPIX Z33 WP Manual de usuario
FujiFilm
FujiFilm Finepix F750EXR Manual de usuario
FujiFilm
FujiFilm Instax Mini 11 Manual de usuario
FujiFilm
FujiFilm 2400 Manual de usuario
FujiFilm
FujiFilm FinePix F11 Manual de usuario
FujiFilm
FujiFilm FI038 Manual de usuario
FujiFilm
FujiFilm FINEPIX BL00840-200 E Manual de usuario
FujiFilm
FujiFilm FinePix S200EXR Manual de usuario
FujiFilm
FujiFilm FinePix A800 Manual de usuario
FujiFilm
FujiFilm X100T Manual de usuario
