Front Runner SSDR010 Manual de usuario

DRAWer

SSDR010

INSTALL TIME: 30 Min

REV_A00

IMPORTANT WARNING!

IT IS CRITICAL THAT ALL FRONT RUNNER PRODUCTS BE PROPERLY AND SECURELY ASSEMBLED AND ATTACHED TO YOUR

VEHICLE. IMPROPER ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY IN-

JURY OR DEATH TO YOU OR TO OTHERS. YOU ARE RESPONSIBLE FOR ASSEMBLING AND SECURING ALL FRONT RUNNER

PRODUCTS TO YOUR VEHICLE, CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE PROD-

UCTS FOR ADJUSTMENT, WEAR, AND DAMAGE. THEREFORE, YOU MUST READ AND UNDERSTAND ALL OF THE INSTRUCTION

AND CAUTIONS SUPPLIED WITH YOUR FRONT RUNNER PRODUCT PRIOR TO INSTALLATION OR USE. IF YOU DO NOT UNDER-

STAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOR-

OUGHLY FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSION

AL INSTALLER OR OTHER QUALIFIED PERSONNEL.

If you have purchased a vehicle specific Deck Set to go with your Drawer System, disregard this Fitting Instruction and

refer to your vehicle specific Instruction received with your Deck Set.

If you have not purchased a vehicle specific Deck Set, you may require additional fasteners and tools in order to create

four suitable mounting points on the vehicle to secure the Drawer System to. It is suggested that you read through the

Fitting Instructions, place Drawer System in the desired position on the vehicle and work out how best to secure the

Drawer System via the Turn Buckles and C-hooks supplied should the vehicle not have suitable mounting points.

GET ORGANIZED...

Here is what you are looking at for SSWO008:

You will need:

10 mm Flat & Socket Wrench

4 mm Hex Key

a Friend

Additional Fasteners and Tools de-

pending on application

REV_A00

Item # Quantity Description

1 1 DRAWER

2 4 TURNBUCKLE

3 4 WING NUT

4 4 D-RING

5 4 M6 x 20 HEX BOLT

6 4 M6 SPRING WASHER

7 4 M6 x 19 FLAT WASHER

8 6 EYE NUT

9 6 STUD PLATE

10 6NYLON WASHER

11 460mm C-HOOK

12 3M8 x 16 HEX BOLT

13 3M8 CHANNEL NUT

14 3M8 x 25 FLAT WASHER

15 3M8 SPRING WASHER

16 1TRACK

Install drawer

Loosen the round end of the four Turn Buckles (Item 2). Screw a M6 Wing Nut (Item 3) onto each round

end and reassemble the Turn Buckle as shown.

()A

Assemble the M6 Eye Nuts and Nylon

Washers (Items 7 & 8) to the Stud Plates

(Item 9) as shown.

()B

REV_A00

()c

Assemble two D-rings (Item 4) to either side of the Drawer as shown using the M6 x 20 Hex Bolts, M6 x 19

Flat Washers and M6 Spring Washers as shown.

Install drawer cont...

REV_A00

Slide a Channel Nut (Item 13) into each end of the Track (Item 16). Place the Track under the front of the

Drawer System and line the Channel Nuts in the Track up with the mounting holes in front corners of the

Drawer System. Loosely secure the Track in position using the two M8 x 16 Hex Bolts, two M8 x 25 Flat

Washers and two M8 Springs Washers (Items 12, 14, 15). Center the Track from left to right and fasten.

()D

(F )

Connect a Turn Buckle and C-Hook (Item 11) to each of the D-rings assembled to Drawer System in Step 2C

()E

Place the Drawer System into the vehicle and position as desired.

Install drawer cont...

REV_A00

With the Turn Buckles and C-hooks in position, work out how best to secure the "hook end " of the Turn

Buckle to the vehicle. Referring to the image below, note that the Turn Buckles must all pull away form

each other in order to prevent the Drawer System from moving one secured into position.

As mentioned on the front page, you may require additional fasteners and tools at this stage in order to

create suitable mounting points.

(

)

Once you have the four mounting points on your vehicle, secure the Drawer to the vehicle by tightening

the four Turn buckles. Once the Drawer is secure in position tighten the Wing Nuts on the Turn Buckles

and the Bolts securing the D-rings to the Drawer System and the vehicle's load bay.

()H

Install DrawER

REV_A00

Should you wish to use the Eye Nut

assemblies from Step 2B as tie down

points, they can be slid into any of the

three top extrusions as shown and

tightened in the required position.

()

Congratulations, you have completed your installation. Take a step back and admire your work. Good Job!

(

)

INSTALL OTHER VEHICLE AND RACK ACCESSORIES

Now's the time to visit your favorite Front Runner dealer in person or online.

()A

Tabla de contenidos

Otros manuales de Accesorios para automóviles de Front Runner

Front Runner

Front Runner Pro Bike Carrier Manual de usuario

Front Runner

Front Runner LALD007 Manual de usuario

Front Runner

Front Runner FAJK003 Manual de usuario

Front Runner

Front Runner RRAC189 Guía de inicio rápido

Front Runner

Front Runner Easy-Out Manual de usuario

Front Runner

Front Runner SHOWER ARM MKII Manual de usuario

Front Runner

Front Runner Pro Water Tank with Strap Manual de usuario

Front Runner

Front Runner KSTF003T Manual de usuario

Front Runner

Front Runner BRONCO TBRA040 Manual de usuario

Front Runner

Front Runner SSDR002 Manual de usuario

Front Runner

Front Runner RRAC129 Manual de usuario

Front Runner

Front Runner Slimline II KRKS007T Manual de usuario

Front Runner

Front Runner LAMS002 Manual de usuario

Front Runner

Front Runner RRAC119 Manual de usuario

Front Runner

Front Runner FAJK002 Manual de instrucciones

Front Runner

Front Runner SSDR005 Manual de usuario

Front Runner

Front Runner FSLI021 Manual de usuario

Front Runner

Front Runner Drawer 6 Box Large MKII SSWO008 Manual de usuario

Front Runner

Front Runner FATT002 Manual de usuario

Front Runner

Front Runner PRO UNDER RACK TABLE bracket Manual de usuario

Front Runner

Front Runner SLIMLINE II Manual de usuario

Front Runner

Front Runner SSAM009 Manual de usuario

Front Runner

Front Runner PBTH001 Manual de usuario

Front Runner

Front Runner FAFE001 Manual de usuario

Manuales populares de Accesorios para automóviles de otras marcas

James Baroud

James Baroud Odyssey Manual de usuario

Motorola

Motorola i50sx Manual de usuario

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manual de usuario

Feniex

Feniex T3 Manual de usuario

Renault

Renault 77 11 423 180 Manual de usuario

Kia

Kia E8300-4D000 Manual de usuario

Brink

Brink 756843 Manual de usuario

Whispbar

Whispbar K085W Manual de usuario

v.link

v.link CI-VL2-PC-HSD Manual de usuario

Viking

Viking Stack-Rack Guía de configuración rápida

Aries

Aries 203015 Manual de usuario

Choetech

Choetech AT0005 Manual de usuario

ZZ2

ZZ2 ZZAIR-PRO Manual de usuario

Holman

Holman 4A80L Manual de usuario

Thule

Thule 2075 Manual de usuario

Motorola

Motorola T325 Manual de usuario

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guía de instalación

DV8

DV8 FBJL-02 Manual de usuario