Freewing Flight Design CTLS Manual de usuario

Flight Design

MADE IN CHINA

Version No.: F3601-V01

Item No.: F3601

The manual suit for every color scheme of Freewing Flight Design CTLS.

The manual only choose one color scheme as an example.

WINGSPAN : 1200mm (47-1/4")

The manual is only for reference. All is according to the actual product .We can't note if any

improvement or upgrade.

Spareparts support please visit to search.,www.sz-freewing.com

Instruction Manual



CTLS

YES

EPO

30A ESC

3S 11.1V 1600mAh 20C

3-Bladed 9*6

3510-1000KV

900mm (35-7/16")

1200mm (47-1/4")

1100g (38.80 oz.)

1150g (40.60 oz.)

Item No.: F3601

: -1-

The following is our basic specification.

Specification

Material

Fuselage length

Wingspan

Flight weight

Pull

Motor size

Prop size

Battery

ESC

Servo

Landing gear

Aileron

Elevator

Rudder

Throttle

9g servo (5pcs)

According to different demands, we provide (no transmitter, receiver ,battery and

charger), , the three equipment for your choose. Please refer tothe following list to

take an inventory and make sure it is complete.

RTF ARF

Airframe only

、

Note:1.Picture use RTF version for your reference.

2. refer to RTF version refer to ARF version refer to Airframe version

EPO Foam Fuselage

Motor

ESC

Servo

Battery

Charger

Manual

Spare Parts Bag

:

Version No.: F3601-V01

F3601-V01

Flight Design CTLS

Thanks very much for your purchasing our Freewing Flight Design CTLS. This upper wing airplane

has a very high natural roll stablility. At the same time, it has a strong automatic recovery stability

during flight. So, this Flight Design CTLS is very suitable for beginners for basic flight training.

This airplane use EPO material, also add parts of carbon material to strengthen. In the case of

increasing a slight weight, it ensure its strength structure. We have spent a lot of energy and try the

best to do it close to the real aircraft. In fact, we have done it, these design like scale fuselage, scale

Its structural design is very reasonable, you can finish its install very quickly. Install main wing and tail

wing is extremely simple .Only take several minutes, you can complete its assemble. Please read the

assembly manual carefully to familiarize you with all the steps before starting.

YES

F3601

YES

Flap YES (Do it by yourself)

cockpit, pilot figure, etc, makes it look like a real aircraft.

(RTF\ARF)

Accessory Bag Content List

()Airframe Only

of this model and any damage of harm it may cause.

2.Before flying the Flight Design CLTS for the first time .Please read through the instructions

carefully and make sure that your radio equipment is working properly and has been range

tested prior to flight.

3.Young people under the age of 14 should only be permitted to operate this model under the

instruction and supervision of and adult with modeling experience.

4.Please keep these instructions for future reference after completing model assembly. They

contain information critical to the safe operation of this model.

your local hobby shop .flying club or Freewing Model for professional help and advice.

This is not a toy .It is for experienced modelers only. You are responsible for the safe operation

If you have any further questions regarding the safe operation of you RC model. please contact

Note:

Item No.: F3601

: -2- :

Version No.: F3601-V01

F3601-V01

Flight Design CTLS

F3601

4PWA3*8mm 8

Y wire

1.0mm

PA2.3*16mm

PT1.7*14mm

PT1.7*12mm

2.3

3.6

1.2mm

L=100mm

L=41.5mm 1.2mm

4PA3*10mm 3

1.0mm

FA2.3*16mm

PT1.7*14mm

PT1.7*12mm

2.3

3.6

1.2mm

L=100mm

L=41.5mm 1.2mm

PWA3*8mm

Locknut

5PA2.3*8mm

4mm

3 Bladed 9*6

Screw

Screw Driver Handle

Screw Driver Head

Metal wire

Clips

Rudder arm sets

Antenna

Screw

Metallic Gasket

Screw Driver Handle

Screw Driver Head

Y wire

Metal wire

Clips

Rudder arm sets

Propeller Cowling

Propeller Fixed disk

Propeller

Antenna

Rear Wheel Wire

Fixing Cover(Left)

Rear Wheel Wire

Fixing Cover(Right)

Spare Parts Bag 1

Spare Parts Bag 2

Spare Parts Bag 1

Spare Parts Bag 2

Spare Parts Bag 3

No. Name Specification Qty.

Rear Wheel Wire

Fixing Cover(Left)

Rear Wheel Wire

Fixing Cover(Right)

" ， 。，

，。，" "

.

Flight Design CTLS”

Flight Design CTLS

  ，。，

.， 。，， 、

、， ， 。

EPO

 、 。、。

， 。，、。

 :



， 、  、 、、)、

 。。

ARF(











 



















EPO 















   

：1.  .ARF



ARF

 

YES

EPO

30A ESC

3S 11.1V 1600mAh 20C

3-Bladed 9*6

3510-1000KV

900mm (35-7/16")

1200mm (47-1/4")

1100g (38.80 oz.)

1150g (40.60 oz.)

9g servo (5pcs)

YES

Item No.: F3601

: -3- :

Version No.: F3601-V01

F3601-V01

Flight Design CTLS

F3601





 



PWA3*8mm 8

( 、 )ARF



( )

Item No.: F3601

: -4- :

Version No.: F3601-V01

F3601-V01

Flight Design CTLS

F3601

 



 



Y

1

 1.0mm







PA2.3*16mm

PT1.7*14mm

PT1.7*12mm

 1

2.3

3.6





 1.2mm

L=100mm

L=41.5mm 1.2mm





 



PA3*10mm 3



 



 



Y

1

 1.0mm





FA2.3*16mm

PT1.7*14mm

PT1.7*12mm

2.3

3.6

 1.2mm

L=100mm

L=41.5mm 1.2mm





PWA3*8mm







5PA2.3*8mm

4mm

 

 1

 1













9*8

2-5mm



：

，，，，

。

1．

[email protected]

Install

1.When install, please read the manual carefully. if you have any questions, kindly contact with your distributor,

or contact us on [email protected]

Note:

2. ,,12 。

2.Before install, please refer to P12 ,check the screw position.

3.Spareparts support please visit to search.

,www.sz-freewing.com

-,.

- "", 

.

- ,

..

-,.

-.

-Main wing install well as the right photo shown.

-Prepare to install main wing as the right photo

shown.

-Connect the main wing servo wire and Y-wire,

then insert main wing into fuselage.

-Turn over the fuselage, fixing the plastic parts

between main wing and fuselage by screws.

-Use the same way to install another main wing.

3. ， .- . .www sz freewing com

PWA 3*8

Item No.: F3601

: -5- :

Version No.: F3601-V01

F3601-V01

Flight Design CTLS

F3601

- ,.

-,

."" ，

。

- .

-，.

.

- ，.

-Install nose landing gear on the fuselage, please

pay attention of its direction.

-Take the elevator and prepare to install.

-As the right photo shown, Insert the elevator into

the rudder plastic parts, after the voice “ka”, it

means install successful.

-Elevator install well as the right photo shown.

-Prepare landing gear parts and start to install as

the right photo shown.

Item No.: F3601

: -6- :

Version No.: F3601-V01

F3601-V01

Flight Design CTLS

F3601

-。

- .，，

。

-，。

- .

-，、 、 ，

 。

-Prepare Transmitter, Receiver ,Y-wire, Battery

to adjust before fly.

-Fixed nose landing gear by screws.

-Install main landing gear, please pay attention of

its direction as the right photo shown.

-Fixed main landing gear by screws as the right

photo shown.

-Complete to install, as the right photo shown.

FA 2.3*16

PWA 3*8

Item No.: F3601

: -7- :

Version No.: F3601-V01

F3601-V01

Flight Design CTLS

F3601

- “”.

-“” 

。

- .

: "

PS P12 "

.

-1.853 ，A

。。

2. 。。

-. .

-Install well the battery cabin cover and adjust

the plane,

-Open the battery cabin cover under fuselage.

-Use Y-wire to connect the nose landing servo

wire and rudder servo wire, combine into one

channel.

-Insert the channels into the receiver

-Install 8pcs 5# AAA battery into the transmitter.

Swith on the transmitter.

-Connect lipo battery and fix it by velcro.

PS: ,.

PS: The following step please refer to the “ ”,

Transmitter set” for detail explain.

P12

PS: Please make sure the battery is full power.

Battery Size L=11*W=5.5*H=3.5 (mm)

Item No.: F3601

: -8- :

Version No.: F3601-V01

F3601-V01

Flight Design CTLS

F3601

- ，

。

-，，

。

Ps：，,

 .

-As the right photo shown, you can repair or

replace the tail control servos, just need to

unscrew the screws.

-Make sure the servos are in the center, through

turning plastic chuck to adjust the rod length.

-As the right photo shown, when all the wing is in

the center, fasten the plastic chuck.



 ，，。，

。

3. P

、， ，  。

2. ,,、,。

, .. 22 .

、，。

、  ，， ，  ，

 。 。

、  ，, ，。

7、,,.:.- .。www sz freewing com

After check everything before flight, as a beginner, we should pay attention of following issues, to make sure

our flight is successful.

1. When use radio set, make sure switch on the transmitter power firstly, then power on the receiver.

2. Before flight, under power on condition, push up and down the throttle and check the motor/ESC work well.

3. Before flight, check well the plane's center of gravity. Correct CG is the key factor of successful flight. Please

refer to P11 to check the center of gravity.

4. No matter take-off on the road or hand launch, we must upwind to take off.

5. After take off, if any unusual flight or hard to control, we should pull high the plane, then trim to adjust according

to the actual situation to maintain it level flight.

6. When the transmitter alarm, you must end your flight as soon as possible and operate to its landing, to avoid

the radio will be out of control since of low voltage.

7. If any damage in flight, please purchase the spareparts from your distributor or refer to www.sz-freewing.com

to check.

Preflight

Item No.: F3601

: -9- :

Version No.: F3601-V01

F3601-V01

Flight Design CTLS

F3601

Tabla de contenidos

Otros manuales de Juguete de Freewing

Freewing

Freewing Li P.15 Diana Manual de usuario

Freewing

Freewing REBEL FJ20311 Manual de usuario

Freewing

Freewing Stinger 64 Manual de usuario

Freewing

Freewing FJ308 F-14 Tomcat Manual de usuario

Freewing

Freewing F-35 Lightning II Joint Strike Fighter Manual de usuario

Freewing

Freewing MIG-21 FISHBED Manual de usuario

Freewing

Freewing F/A-18E Super Hornet FJ1071 Manual de usuario

Freewing

Freewing L-39 Albatros Manual de usuario

Freewing

Freewing FJ211 Manual de usuario

Freewing

Freewing Eurofighter Typhoon V2 Manual de usuario

Freewing

Freewing F-14 TOMCAT Manual de usuario

Freewing

Freewing F-5N Tiger II FJ208 Manual de usuario

Freewing

Freewing F-35 V2 FJ2011 Manual de usuario

Freewing

Freewing BAe HAWK T.1A Manual de usuario

Freewing

Freewing A-6E Intruder Manual de usuario

Freewing

Freewing T-45 Goshawk Manual de usuario

Freewing

Freewing F/A-18C Hornet Manual de usuario

Freewing

Freewing F-16 fighting falcon Manual de usuario

Freewing

Freewing A-10 Thunderbolt II Manual de usuario

Freewing

Freewing AT-6 Texan Manual de usuario

Freewing

Freewing FJ307 Manual de usuario

Freewing

Freewing F-22 Raptor Manual de usuario

Freewing

Freewing Avanti S Manual de usuario

Freewing

Freewing F9F-8 Cougar Manual de usuario

Manuales populares de Juguete de otras marcas

marklin

marklin 37321 Manual de usuario

Canon

Canon PAPER CRAFT Manual de usuario

GREAT PLANES

GREAT PLANES Pitts M-12S Manual de usuario

NOCH

NOCH 14261 Manual de usuario

Hausler

Hausler 450 SE V2 Manual de usuario

Dynaflite

Dynaflite Daydream Manual de usuario

MiniacRC

MiniacRC MIGHTY MINI P40 WARHAWK Manual

Kenner

Kenner Batman 63651 Manual de usuario

LEGO

LEGO 8527 Manual de usuario

iKarus

iKarus ECO 8 Manual de usuario

Multiplex

Multiplex EasyStar II Manual de instrucciones

Walkera

Walkera 38 Manual de instrucciones

Hasbro

Hasbro TRANSFORMERS BUMBLEBEE Manual de usuario

MD MXION SWD Manual de usuario

Mattel

Mattel Disney Pixar Cars Cozy Cone Spiral Rampway Manual de usuario

marklin

marklin 39671 Manual de usuario

Meccano

Meccano 15103 Manual de usuario

LEGO

LEGO TECHNIC 8735 Manual de usuario