Freewing F9F Panther Manual de usuario

Please read all instructions carefully before assembly and flight!

Thank you for purchasing the F9F Panther. This model is designed for the intermediate to

advanced flyer. The model is receiver-ready and includes everything that you need to assemble

and fly your F9F Panther, except for the radio transmitter and receiver. Please read the following

instructions carefully, assembly is easy and should only take an hour or so.

Main Specifications

Wingspan: 27” (685mm)

Fuselage length: 28-3/4” (730mm)

Flight weight: 19-1/2 oz. (552g)

64mm EDF

4300KV out-runner brushless motor.

3-cell 11.1V 1600mAh 20C lipo battery

30A ESC

3pcs. 9g Servo

Optional Landing Gear (Sold Separately) w/ steerable nose wheel and servo included

Radio System with minimum 3-channel Transmitter and Receiver

Battery charger capable of charging a 3-cell Lipo battery

Safety Statement

1. This is not a toy. It is for experienced modelers only. You are responsible for the safe

operation of this model and any damage or harm it may cause.

2. Before flying the F9F Panther for the first time please read through the instructions carefully

and make sure that your radio equipment is working properly and has been range tested

prior to flight.

3. Young people under the age of 14 should only be permitted to operate this model under the

instruction and supervision of an adult with modeling experience.

4. Please keep these instructions for future reference after completing model assembly. They

contain information critical to the safe operation of this model.

5. If you have any further questions regarding the safe operation of your RC model, please

contact your local hobby shop, flying club or Freewing Model Company

for professional

help and advice.

F9F Panther

Item No.:F1701 -1-

All of the above parameters only for the RTF with landing gear, if you purchase another version, you

could refer to the above and choose another spareparts.

Safety Precautions!

Please read this section and follow all recommendations!

1. Do not fly in strong wind or bad weather.

2. Never fly the model in crowded areas where there are lots of people, automobiles on the

road or power lines overhead. Do not fly near full-scale airports.

3. Make sure that you have enough open area for flying as the model can travel at a high rate

of speed and cover a lot of area quickly. Initial flights should be made in an area with a

minimum size of a football field.

4. This model is not recommended for children under the age of 14.

5. When charging the LiPo batteries, always charge them on a non-flammable surface and

monitor the charge process. Improper charging of LiPo batteries is dangerous and can lead

to a fire!

6. The F9F Panther is made from EPO foam and plastic. These materials are flammable and

can be damaged by high heat. Never leave your F9F Panther near a heat source or in an

automobile.

7. Do not attempt to catch your F9F Panther while flying.

8. Never leave your F9F Panther unattended when ready for flight.

9. When preparing for flight, always turn on your transmitter first and make sure that your

throttle is in the off position prior to plugging in the flight battery. Failure to follow this step

may lead to unintended motor start and damage to the model.

Illustration of Assembly

1. Open box and carefully unwrap all parts.

F9F Panther

Item No.:F1701 -2-

2. Apply a small amount of epoxy to one 3. Apply a small amount of epoxy to the vertical

of the horizontal stabilizers. stabilizer slot for the horizontal stabilizer

and glue it in place. Repeat for other side.

4. Check that horizontal stabilizers are 5. Apply 5-minute epoxy to the root of

at 90 degrees to the fin. one wing panel.

6. Apply 5-minute epoxy to the wing tabs 7. Attach and hold the wing in place until

on the fuselage. the epoxy cures. Repeat for other wing.

F9F Panther

Item No.:F1701 -3-

8. Insert the aileron servo wires into the 9. Apply 5-minute epoxy to the bottom of

holes in the fuselage and route to Rx. the vertical stabilizer with the foam insert

on the right side removed.

10. Carefully install the vertical stabilizer onto the fuselage, making sure the elevator tube

goes into the exit slot. Be sure not to foul the pushrod opening with glue.

11. Epoxy the area where the foam insert goes and carefully install the insert while

making sure the elevator tube goes into the exit slot.

F9F Panther

Item No.:F1701 -4-

12. Slide the elevator pushrods through the tubes and attach the plastic clevises. Center

the elevator servo and while holding the elevators in the neutral position, tighten the

connector screw on the servo horn with a screwdriver.

13. Apply 5-minute epoxy to the nose cone and attach it to the fuselage, making sure it

is aligned properly.

14. The hatch has magnets at the front and a tab at the back. Lift from the front and slide

forward to remove the hatch. Install your receiver using double sided tape or Velcro.

F9F Panther

Item No.:F1701 -5-

15. If not installing the optional landing gear (sold separately), glue the front plastic

nose cover on with contact adhesive or 5-minute epoxy.

16. Installing the optional landing gear (sold separately). Remove the plastic covers on the

wings. Use 5-minute epoxy to install the plastic landing gear base. Next, feed the steering

servo wire into the nose and glue the nose gear base in place. Connect the nose wheel

steering lead to the rudder channel on your receiver.

F9F Panther

Item No.:F1701 -6-

17. Install the battery pack in the nose and position to achieve proper center of gravity.

18. Aileron control throws are 3/8” Up and Down on Low Rates. They are 1/2" Up and Down

on High Rates.

19. Elevator control throws are 3/16” Up and Down on Low Rates. They are 5/16" Up and

Down on High Rates.

20. The Center of Gravity for the F9F Panther is 1-3/4” (45mm) back from the leading edge

F9F Panther

Item No.:F1701 -7-

of the wing where it meets the fuselage. Adjust the position of the battery to achieve correct

balance. Never attempt to fly a model that is not correctly balanced.

Preparation before flight

21. Set throttle to the lowest position and set transmitter trims to neutral.

22. Turn on the transmitter

23. Connect the flight battery to the ESC. After ESC initializes check that the correct channel is

controlling each control surface and that they are traveling in the correct direction when

commanded. Example: right stick moved to the right and the aileron on the right wing

moves upward while the aileron on the left wing moves downward.

24. Adjust each control surface to its neutral position by mechanically adjusting each clevis.

Recommended control throws for F9F Panther

Elevator

Low Rates 3/16” Up and Down

High Rates 5/16” Up and Down

Aileron

Low Rates 3/8” Up and Down

High Rates 1/2” Up and Down

After initial flights adjust the control throws to best suit your flying style and ability.

F9F Panther

Item No.:F1701 -8-

Check before flight

1. Make sure that your transmitter is fully charged. Conduct a range test of your radio system per the

manufacturer’s specs.

2. Check all flying surfaces for correct direction of movement, correct amount of movement and for correct

centering, adjust as required.

3. Fully charge your flight batteries prior to flying.

4. Hand launch into the wind and land into the wind.

Flight Adjustment

1. On initial flight climb to about 75-100 feet and see if any trim is required. If the model rolls to the right, apply

some left aileron trim to level the wings. If the model dives, apply some up elevator trim, ect.

2. Landing should be made into the wind, reduce the throttle to just above idle and keep the nose level or a little

high allowing the airplane to sink toward the ground. Apply a little throttle as the model reaches an altitude of

a foot or so, this will slow the descent and aid in the flare to a smooth landing.

F9F Panther

Item No.:F1701 -9-

Spare parts for F9F

F9F landing gear

Item No.: F170106

64mm EDF

Item No.: F90210

2627-4300kv Brushless Motor

Item No.: F90131

F9F Fuselage

Item No.: F170104

F9F Tail Wing Set

Item No.: F170102

F9F Main wing Set

Item No.: F170103

Otros manuales de Juguete de Freewing

Freewing

Freewing F-104 Starfighter Manual de usuario

Freewing

Freewing Eurofighter Typhoon V2 Manual de usuario

Freewing

Freewing A 18E Manual de usuario

Freewing

Freewing FJ308 F-14 Tomcat Manual de usuario

Freewing

Freewing B-17 F2601 Manual de usuario

Freewing

Freewing F-105 Thunderchief Manual de usuario

Freewing

Freewing Spirit Manual de usuario

Freewing

Freewing F-15 Eagle FJ309 Manual de usuario

Freewing

Freewing F-15 eagle Manual de usuario

Freewing

Freewing F-86 Sabre FJ2031 Manual de usuario

Freewing

Freewing F-5N Tiger II FJ208 Manual de usuario

Freewing

Freewing A-6E Intruder Manual de usuario

Freewing

Freewing B-17 Flying Fortess Manual de usuario

Freewing

Freewing FJ311 Manual de usuario

Freewing

Freewing A-10 Thunderbolt II Manual de usuario

Freewing

Freewing E52 Manual de usuario

Freewing

Freewing F9F-8 Cougar Manual de usuario

Freewing

Freewing EUROFIGHTER TYPHOON Manual de usuario

Freewing

Freewing Flight Design CTLS Manual de usuario

Freewing

Freewing MIG-21 FISHBED Manual de usuario

Freewing

Freewing stinger 90 Manual de usuario

Freewing

Freewing F-104 Starfighter Manual de usuario

Freewing

Freewing BAe HAWK T.1A Manual de usuario

Freewing

Freewing Seagull Manual de usuario

Manuales populares de Juguete de otras marcas

marklin

marklin 37321 Manual de usuario

Canon

Canon PAPER CRAFT Manual de usuario

GREAT PLANES

GREAT PLANES Pitts M-12S Manual de usuario

NOCH

NOCH 14261 Manual de usuario

Hausler

Hausler 450 SE V2 Manual de usuario

Dynaflite

Dynaflite Daydream Manual de usuario

MiniacRC

MiniacRC MIGHTY MINI P40 WARHAWK Manual

Kenner

Kenner Batman 63651 Manual de usuario

LEGO

LEGO 8527 Manual de usuario

iKarus

iKarus ECO 8 Manual de usuario

Multiplex

Multiplex EasyStar II Manual de instrucciones

Walkera

Walkera 38 Manual de instrucciones

Hasbro

Hasbro TRANSFORMERS BUMBLEBEE Manual de usuario

MD MXION SWD Manual de usuario

Mattel

Mattel Disney Pixar Cars Cozy Cone Spiral Rampway Manual de usuario

marklin

marklin 39671 Manual de usuario

Meccano

Meccano 15103 Manual de usuario

LEGO

LEGO TECHNIC 8735 Manual de usuario