Flight Model YAK-54 35-40CC Instrucciones de operación

CAUTION : this plane is not a toy!

Before use , please carefully read this manual.

●First-time builders should seek advice from people having building

experience in order to assemble the model correctly and to produce its

●Assemble this kit only in places out of children’s reach!

●Take enough safety percautions prior to operating this model.

You are responsible for this model’s assembly and safe operation!

●Always keep this instruction manual ready at hand for quick

reference,even after completing the assembly.

Radio:6channels 6-7servos;

Flying Weight:4500-5100g;Wing Span:76.7in/1950mm;

Wing Area:71.8sq.dm;

Length:73.5in/1867.3mm;

performance to full extent .

Engine:35-40CC GAS;

P.1

Gather the wings and joiner

parts as show.

Install the aileron horns in place

with AB glue.Align the holes in the

horns .Install the servo after

pulling the servo extention wire

in the wing.Install the servo arm

on the servo and loctitle it in place

on the mount screw.Install the

pushrod and control horn.

●Check for movement and center

on the servo for the aileron to be

in a level resting position.

●Check to make sure you have

the servos in a reverse manner

so ailerons with work properly.

MAIN WINGS

P.2

Find out the holes in each sides

of fuselage,then remove the

covering.Insert the carbon joiner

in place,then put on wings.

●Check to make sure you have

the carbon in a right length in the

wings.

Mounting the wings with

plastic bolts on both sides.

Plastic

bolt

P.3

●Make sure to apply Vaseline to

the rudder hinges to prevent the

epoxy from getting in to the joint.

●Make sure to allow room for

epoxy to penetrate the hinges.

Carefully slide the rudder onto

each hinge and against the trailing

edge of the fin.Wipe away excess

epoxy with alcohol wetted wipes.

●Ensure there is no gap

between fin and rudder.

Install the rudder servo in the

fuselage that prepared by factory.

Feed the rudder cable through the

cable exit tube in the tail of the

fuse toward the front of the fuse.

Repeat on other side.

Adjust rudder pull-pull cables

to desied tension by screwing in

or out on the threaded couplers

and or ball links.Make all adjust-

ments with the rudder servos still

rudder still taped in the neutral

position.

RUDDER AND TAIL WHEEL

Push

rods

Rudder

servo arm

P.4

●Ensure the servo doesn't bind

at center or at either end point.

Drill holes in the hardwood tail

wheel mount and install the blind

nut through the opening in the

rear of the fuse.

Install the mounting screw for the

tail wheel.

●Ensure it has been totally

screwed into the blind nuts.

Install the hatch over the opening in the rear of the stabilizer with 4 screws

Mount the elevator onto the stab

making sure you use Vaseline in

the hinge points so the glue will

not stick the hinge shut.

Install the control horns in place

for the elevator horn before sliding

the stab in place.

Screw the threaded pushrod and

swivel in place onto the elevator

horn.Plug in a 24"servo wire

extension and use a securing clip

provided to make sure they don't

come unplugged in flight.

STABILIZER AND ELEVATOR

luminum

steering peg

P.5

Mount the elevator servo in place

and pull the servo wire extension

up toward the front.

●Make sure the bolts has been

totally screwed into the blind nuts.

Install the servo arm to the servo

after making sure the elevator is

level with the stab with the servo

is in dead center.Tape the

elevator in place using blue

painter's masking tape.

Install elevator servos on

each sides of tailplane.

Bolt on tabs for

stabs

P.6

Elevator pushrod.

Gather the wheels,axles and

collars as shown.

Install the main landing gear with

the bolts provided and use blind nut

already installed and use blue

Loctite on the mounting bolts.

Install the main landing

gear on the bottom of the

fuselage.

MAIN LANDING GEAR

P.7

Permanently tighten the axle to

the gear strut by wrenches.

Install wheel pants with two

mounting bolts.

Wheel pants take a lot of abuse,

mount securely!

The finished photo as shown.

P.8

Install the four adapter to the Install the motor to the four

motor inount. adapter and use screws to

lock motor and adapter.

Use screws to lock cowling. The finished

icture

as shown.

Install the propeller and

aluminium spinner.

THE MOTOR INSTALLED

P.9

Measure the length of the engine

from the firewall mounts to the

prop thrust washer for the proper

distance allowing 1/4" to 1/2" from

the dege of the cowl.

Move if needed.

From the exhaust muffler inserted

in the position, and then from the

exhaust machine belly place flat,

fixed.

In the fuselage bottom find machine

belly，then cover with lid on

abdomen, screw machine belly

cover.

Glow Engine Installation

Aircraft

machine

belly

P.10

Tabla de contenidos

Otros manuales de Juguete de Flight Model

Flight Model

Flight Model SBACH-342 Manual de usuario

Flight Model

Flight Model Giles-202 40-50CC Instrucciones de operación

Flight Model

Flight Model Monsun-60 Instrucciones de operación

Flight Model

Flight Model Funtama 100 Instrucciones de operación

Flight Model

Flight Model Extra 330SC 100CC Manual de usuario

Flight Model

Flight Model Apollo 90 Manual de usuario

Flight Model

Flight Model F070 Stick-46 Manual de usuario

Flight Model

Flight Model M089 F3A 68.5IN Manual de usuario

Flight Model

Flight Model F130 Nemins-60 Instrucciones de operación

Flight Model

Flight Model Courage-8 40 Instrucciones de uso

Flight Model

Flight Model F0081 Katana 26-30CC Instrucciones de operación

Flight Model

Flight Model Extra-330 57" EP Instrucciones de operación

Flight Model

Flight Model Kelly F1 60 Instrucciones de operación

Flight Model

Flight Model ZERO A6M5B Manual de usuario

Flight Model

Flight Model Sbach 342 55" Instrucciones de operación

Flight Model

Flight Model F124 MXS-R 30-35CC Manual de usuario

Flight Model

Flight Model F043 Super Decathlon Manual de usuario

Flight Model

Flight Model F127 Zlin-42 60 Instrucciones de operación

Flight Model

Flight Model SU-31 Instrucciones de operación

Flight Model

Flight Model F172 Silence Twister 50CC Manual de usuario

Flight Model

Flight Model F055 Butterfly-3D Instrucciones de operación

Flight Model

Flight Model F090 CAP232-60 Instrucciones de operación

Flight Model

Flight Model SU-29 50CC Manual de usuario

Flight Model

Flight Model F136 SU-29 26-30CC Instrucciones de operación

Manuales populares de Juguete de otras marcas

marklin

marklin 37321 Manual de usuario

Canon

Canon PAPER CRAFT Manual de usuario

GREAT PLANES

GREAT PLANES Pitts M-12S Manual de usuario

NOCH

NOCH 14261 Manual de usuario

Hausler

Hausler 450 SE V2 Manual de usuario

Dynaflite

Dynaflite Daydream Manual de usuario

MiniacRC

MiniacRC MIGHTY MINI P40 WARHAWK Manual

Kenner

Kenner Batman 63651 Manual de usuario

LEGO

LEGO 8527 Manual de usuario

iKarus

iKarus ECO 8 Manual de usuario

Multiplex

Multiplex EasyStar II Manual de instrucciones

Walkera

Walkera 38 Manual de instrucciones

Hasbro

Hasbro TRANSFORMERS BUMBLEBEE Manual de usuario

MD MXION SWD Manual de usuario

Mattel

Mattel Disney Pixar Cars Cozy Cone Spiral Rampway Manual de usuario

marklin

marklin 39671 Manual de usuario

Meccano

Meccano 15103 Manual de usuario

LEGO

LEGO TECHNIC 8735 Manual de usuario