Flexitron TAXITRONIC TX80 Urba Manual de usuario

INSTALLATION MANUAL TX80 SKYGLASS INTERFACOM, S.A.U. 02/03/2022

Inst TX80_EN.doc 08/03/2017

INSTALLATION MANUAL

TAXITRONIC TX80 SKYGLASS

TAXITRONIC TX80 URBA

INSTALLATION MANUAL TX80 SKYGLASS INTERFACOM, S.A.U. 
Inst TX80_EN.doc 2 
 
 
 
 
GENERAL INDEX 
 
INTRODUCTION................................................................................................................... 3 
SAM INSTALLATION............................................................................................................3 
MOUNTING........................................................................................................................... 3 
2. MOUNTING AND LOCATION OF TX80 ............................................................................3 
2. MOUNTING AND LOCATION OF SKYGLASS..................................................................4 
2. MOUNTING AND LOCATION OF URBA........................................................................... 4 
SEALING.............................................................................................................................13 
1. TX80 SEALING.................................................................................................................13 
2. SKYGLASS SEALING...................................................................................................... 14 
3. URBA SEALING ..............................................................................................................14 
TECHNICAL CHARACTERISTICS.....................................................................................15 
IMPULSE GENERATOR.....................................................................................................16 
1. INTRODUCTION .............................................................................................................. 16 
2. INSTALLATION ................................................................................................................ 16 
2.1. ASSEMBLY OF THE SPEEDOMETER CABLE AND PULSE GENERATOR.............. 16 
2.2. CABLE CONNECTION, COVER CLOSING AND PULSE GENERATOR SUPPORT..18 
3. SEALING (Drawing 11).....................................................................................................19 
4. TECHNICAL CHARACTERISTICS .................................................................................. 19 
VEHICLES WITH ELECTRONIC IMPULSE SIGNAL......................................................... 19 
ERROR MESSAGES ..........................................................................................................20 
 
 

INSTALLATION MANUAL TX80 SKYGLASS INTERFACOM, S.A.U.

Inst TX80_EN.doc 3

1. INTRODUCTION

This document describes the installation and parameterization of the taximeter

TAXITRONIC TX80 SKYGLASS and URBA.

2. SAM INSTALLATION

To introduce SAM card the device must be opened, then introduce SAM card in the

Skyglass groove as there is shown on the plane.

To configure the SAM card, the toolkit manual (SIM/SAM configuration section) indications

must be followed. This process must be done after the installation has been completed in

the vehicle.

3. MOUNTING

3.2. MOUNTING AND LOCATION OF TX80

The device will arrive sealed. It is necessary to open it to proceed to the connection All

TC60 connectors are inside the unit, covered by a sealable cover.

The tools necessary for the installation are:

- Screwdriver with head format Z1

Al other devices are interconnected with TX80. So, it can’t be sealed until the whole

installation process is finished.

TX80 must be installed so that passengers can’t see or access it. Seals and serial

numbers must be easily visible and accessible upon verification at a verification office.

INSTALLATION MANUAL TX80 SKYGLASS INTERFACOM, S.A.U.

Inst TX80_EN.doc 4

For this reason, it is necessary to take care of the orientation, with the stickers looking to

the outside.

Standard positions are inside the glovebox or under the vehicle board. Some vehicle

brands have standardized the TX80 position.

It is necessary that the identification sticker and the seals are easy to inspect. Cables

can’t cover neither the identification sticker nor the seals.

3.2. MOUNTING AND LOCATION OF SKYGLASS

SKYGLASS must be tied to the interior rear-view mirror of the vehicle by two Velcro strips.

The connection of the device is done through their cable into the TX80 internal connector.

3.2. MOUNTING AND LOCATION OF URBA

URBA must be fixed to the dashboard by means of an adhesive support. If the surface is

rough, adhesion will not be possible. The base of the support can also be fixed on the

dashboard with screws. The connection of the device is done through their cable into the

TX80 internal connector.

INSTALLATION MANUAL TX80 SKYGLASS INTERFACOM, S.A.U.

Inst TX80_EN.doc 5

4. ELECTRICAL INSTALLATION

To access the TX80 connectors it is necessary to open the Connector cover:

-Take out the screw that seals the cover

-Connect each cable into its connector

-Pass each cable through its retention

-Break the holes in the top cover in order the cables can pass

-Clos the device

-Screw the cover

The TX80 has the following connectors:

•(1) CAN Vehicle

Contact number

Function

+ 12V

+ 5V

CAN H

CAN L

Ground

•(2) Power Supply

Contact number

Color

Function

Green / White

Distance pulses

Brown

Emergency signal

Violet

Passenger sensor

Blue

Contact Key

Yellow

Position lights

Green

Rooflight (L1)

Red

Battery 12V

Red

Battery 12V

Black

Ground

Black

Ground

* If the emergency signal is not used, Brown cable must be connected to ground.

•(3) Impulse Generator

Contact number

Color

Function

Mesh

Ground

Red

+ 5V

Green

Signal

INSTALLATION MANUAL TX80 SKYGLASS INTERFACOM, S.A.U.

Inst TX80_EN.doc 6

•(4) Serial Port (IR80)

Contact number

Function

+ 12 V

+ 5 V

TXD

RS232 levels +- 12V

TXD

TTTL levels 0 - 5 V

RXD

Ground

•(5) CAN Accessories

Contact number

Color

Function

Red

+ 12V

+ 5V

Yellow

CAN H

Green

CAN L

Blue

Black

Ground

•(6) SKYGLASS / URBA Connector

Contact number

Color

Function

Red

+ 12V

+ 5V

Yellow

CAN H

Green

CAN L

Blue

Black

Ground

•(7) Serial Rooflight

The connector on the cable has a white mark, which has to be oriented to the pulses

connector.

Contact number

Function

Ground

+ 12V

TXD

TTL 0 –5 V

RXD

TTL 0-5 V

INSTALLATION MANUAL TX80 SKYGLASS INTERFACOM, S.A.U.

Inst TX80_EN.doc 7

TX80 CONNECTORS

IPL80 CONNECTION

IPL80 must be connected to CAN accessories (5) connector. The rooflight cables must be

connected to IPL80 as the rooflight installation diagram shows.

INSTALLATION MANUAL TX80 SKYGLASS INTERFACOM, S.A.U.

Inst TX80_EN.doc 8

COMPLETE INSTALLATION

INSTALLATION MANUAL TX80 SKYGLASS INTERFACOM, S.A.U.

Inst TX80_EN.doc 9

PARALLEL ROOFLIGHT INSTALLATION

INSTALLATION MANUAL TX80 SKYGLASS INTERFACOM, S.A.U.

Inst TX80_EN.doc 10

INSTALLATION IN A VEHICLE WITH CIA447 PROTOCOL

Otros manuales para TAXITRONIC TX80 Urba

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Instrumento de medición de Flexitron

Flexitron

Flexitron webdyn MTX-StarWater Manual de usuario

Flexitron

Flexitron webdyn MTX-StarWater Manual de usuario

Flexitron

Flexitron TAXITRONIC TX80 Urba Manual de usuario

Flexitron

Flexitron MTX-StarSensor Manual de usuario

Flexitron

Flexitron TAXITRONIC TX80 Urba Manual de usuario

Flexitron

Flexitron webdyn MTX-StarEnergy-E Manual de usuario

Manuales populares de Instrumento de medición de otras marcas

Suaoki

Suaoki D40 Manual de usuario

Elster

Elster BK-G1.6 Manual de usuario

Endress+Hauser

Endress+Hauser Deltabar FMD71 Manual

Duratool

Duratool D03128 Manual de usuario

Vega

Vega VEGAPULS 65 Manual de usuario

Tonghui

Tonghui TH2618B Manual de usuario

Tenmars

Tenmars TM-801 Manual de usuario

MSR

MSR 145 Manual de usuario

TPS

TPS WP-82 Manual de usuario

ELMETRON

ELMETRON CP-511 Manual de usuario

PCB Piezotronics

PCB Piezotronics 003C30 Manual de usuario

Tenma

Tenma 72-10465 Manual de usuario

Endress+Hauser

Endress+Hauser Proline Promag 50 Especificaciones técnicas

Siemens

Siemens SITRANS F Coriolis FCT030 Manual de lista de piezas

KLINGER

KLINGER CMF V Series Manual de usuario

EXFO

EXFO FTB-2 Manual de operación y mantenimiento

Keysight

Keysight M8290A Manual de usuario

ADTEK

ADTEK MW-5 Manual de usuario