Fisher-Price W9894 Manual de usuario
1
W9894
fisher-price.com
Please keep this instruction sheet for future reference,
as it contains important information.
Requires two “D” batteries (included) for soother operation and two
“AAA” (LR03) alkaline batteries (not included) for remote operation.
The soother batteries included are for demonstration purposes only.
Adult assembly is required for crib attachment and battery installation.
Tool required: Phillips screwdriver (not included).
2
Care
• Wipe this toy with a clean, damp cloth. Do not immerse.
• This toy has no consumer serviceable parts. Do not take apart.
Consumer Information
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
©2012 Mattel. All Rights Reserved.
PRINTED IN CHINA W9894pr-0920
• Protect the environment by not disposing of this product with
household waste (2002/96/EC). Check your local authority for
recycling advice and facilities.
3
For best performance, we
recommend replacing the batteries
that came with the soother with two,
new “D” (LR20) alkaline batteries.
• Locate the battery compartment on
the back of the soother.
• Loosen the screws in the battery
compartment door with a Phillips
screwdriver and remove the door.
• Remove the exhausted batteries and
dispose of them properly.
• Insert two, new “D” (LR20)
alkaline batteries.
• Replace the battery compartment
door and tighten the screws. Do
not over-tighten.
• If the soother begins to operate
erratically, you may need to reset the
electronics. Turn the power dial off
and then back on.
• A low battery indicator will appear on
screen when there is approximately
30% of battery power left, and again
when battery power is below 10%.
• When you see the low battery
indicator on the screen, it's time for
an adult to change the batteries.
IMPORTANT! Under normal use
conditions, the batteries in the soother
will require replacement more often
than the batteries in the remote.
Soother Battery Replacement
1,5V x 2
"D" (LR20)
4
• Locate the battery compartment on
the back of the remote.
• Loosen the screw in the battery
compartment door with a Phillips
screwdriver and remove the door.
• Insert two “AAA” (LR03)
alkaline batteries.
• Replace the battery compartment
door and tighten the screw. Do not
over-tighten.
• If the remote begins to operate
erratically, you may need to reset the
electronics. Remove the batteries
and reinstall them.
In exceptional circumstances,
batteries may leak fluids that can
cause a chemical burn injury or
ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or
rechargeable (nickel-cadmium).
• Insert batteries as indicated inside
the battery compartment.
• Remove batteries during long
periods of non-use. Always remove
exhausted batteries from the product.
Dispose of batteries safely. Do not
dispose of product in a fire. The
batteries inside may explode or leak.
• Never short-circuit the
battery terminals.
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-recharge-
able batteries.
• Remove rechargeable batteries from
the product before charging.
• If removable, rechargeable batteries
are used, they are only to be charged
under adult supervision.
Remote Battery
Installation
Battery Safety
Information
1,5V x 2
“AAA” (LR03)
5
Crib Attachment
• Position the crib connector inside
the crib.
• Wrap the attachment strap around
the top of the crib rail.
• Slide the end of the attachment strap
through the slot on the back of the
crib connector.
• Pull the end of the attachment strap
up and fasten the strap slot onto the
peg on the back of the crib connector.
Note: The crib connector should be
snug against the crib rail and spindles.
Use the strap slot that provides the
tightest fit.
Attachment
Attachment
Strap
Strap
Crib Rail
Crib Rail
1
2
Slot
Slot
Peg
Peg
Prevent Entanglement Injury
This product may not attach
to all crib designs. Do not add
additional strings or straps
to attach to a crib or playpen.
Use only the crib connector.
WARNING
IMPORTANT! Always attach with all
provided fasteners tightly to a crib
according to the instructions. Do not
add additional strings or straps to
attach to a crib. Check frequently.
OUTSIDE CRIB VIEW
OUTSIDE CRIB VIEW
6
• Tie the strings to a crib spindle.
Note: It is better to tie the strings in
a knot than a bow, since a bow may
be easily untied.
• If you have excess strap, slide the
free end of the attachment strap
under the slot at the top of the
attachment strap.
4
3
• Make sure the distance between the
bottom of the crib connector and the
crib mattress is at least 7 inches
(18 cm).
• If the distance is less than 7 inches
(18 cm), readjust the attachment
strap to lift the crib connector; or
lower the crib mattress.
At least
At least
7 inches (18 cm)
7 inches (18 cm)
Crib Attachment
5
Mattress
Mattress
Crib
Crib
Connector
Connector
7
6
• At an angle, fit the tab on the back
of the soother into the slot in the
crib connector.
• Push the top of the soother to
“snap” in place.
INSIDE CRIB VIEW
INSIDE CRIB VIEW
Soother Tab
Soother Tab
Soother Receiver
Soother Receiver
Remote
Remote
Remote Use
• Make sure there is a clear path
between the remote and the soother.
• Point the end of the remote toward
the soother receiver and press
the button.
Notes:
• You can use the remote to "wake up"
the soother from "sleep" mode (for
up to 10 hours of inactivity).
• In the unlikely event that use of the
remote interferes with normal use of
other remote controlled equipment,
such as televisions and stereos, or
use of other electronic or battery
powered appliances interfere with
operation of the soother, do not use
both at the same time.
• You may notice a loss of range
between the remote and the soother
when using in bright or flourescent
light. For best performance, avoid
using the remote in areas of bright
light. Move the soother, or
reduce the amount of light to
improve performance.
Crib Attachment
7
8
Lots of Music & Fun Sounds!
• Rotate the power/volume dial to turn
the soother ON and select a volume
level. When you are finished playing
with this toy, rotate the power/
volume dial OFF .
• Press the nightlight button to
turn the nightlight ON.
• Press the next button to change
the nightlight image.
Hint: You can also change the night-
light image in the Advanced Settings
menu. See the Advanced Settings
section for more information.
• Press the nightlight button again to
turn the nightlight OFF.
Nightlight Button
Nightlight Button
Next and Select Button
Next and Select Button
Power/Volume Dial
Power/Volume Dial
9
Main Menu
• From the main menu, press the next
button to scroll to the desired
app. Then press the select button
to open the app menu.
3 Entertaining Apps!
Personal Photos - Allows you to
upload your own photos for baby
to watch!
High Contrast - Watch black and
white images to enhance baby's
visual skills
Peek-a-boo Rainforest - Baby is
surprised by animal friends!
Personal
Photos App
High
Contrast App
Peek-a-boo
Rainforest App
Northern
Lights App Counting
Sheep App
Aquarium
Wonders App
3 Soothing Apps!
Northern Lights - Watch sleepy time
lights and snuggly animals.
Counting Sheep - Baby can count the
sheep on screen.
Aquarium Wonders - Watch your
ocean friends and listen to
soothing sounds.
10
Advanced Settings
• From an app menu, press the next
button to scroll to the advanced
settings menu . Press the select
button to open the advanced
settings menu.
• Use the next button to scroll
through settings: Time Out, Brightness,
or Nightlight. Press the select button
to choose a setting.
Time Out
• Choose a 10 minute or 5 minute time
out for entertaining apps.
• Choose 20 minute or 10 minute time
out for soothing apps.
• The soother will time out after 5, 10
or 20 minutes of inactivity, depending
on the duration you chose, and go into
"sleep" mode. Press the next button ,
select button or spin the roller to
"wake up" the product.
Brightness
• Press the select button to adjust
the brightness up or down.
Time Out Nightlight
Brightness
Setting
Exit
The soother comes ready to use! Or, you can customize each app using
advanced settings.
The image above shows the advanced
settings menu for the entertaining
apps. The advanced settings menu
for the soothing apps has a darker
background and moon in the upper
left corner.
Otros manuales para W9894
1
Tabla de contenidos
Otros manuales de Juguete de Fisher-Price
Fisher-Price
Fisher-Price H5698 Manual de usuario
Fisher-Price
Fisher-Price Rescue Heroes K9700 Manual de usuario
Fisher-Price
Fisher-Price W9981 Manual de usuario
Fisher-Price
Fisher-Price J4186 Manual de usuario
Fisher-Price
Fisher-Price FBB99 Manual de usuario
Fisher-Price
Fisher-Price HNB42 Guía de configuración rápida
Fisher-Price
Fisher-Price BFK51 Manual de usuario
Fisher-Price
Fisher-Price Little People Musical Birthday Party G8681 Manual de usuario
Fisher-Price
Fisher-Price M5606 Manual de usuario
Fisher-Price
Fisher-Price X6020 Manual de usuario
Fisher-Price
Fisher-Price TOOTS THE TRAIN 74878 Manual de usuario
Fisher-Price
Fisher-Price W6169 Manual de usuario
Fisher-Price
Fisher-Price W6085 Manual de usuario
Fisher-Price
Fisher-Price 73769 Manual de usuario
Fisher-Price
Fisher-Price B4251 Manual de usuario
Fisher-Price
Fisher-Price GEOTRAX L9182 Manual de usuario
Fisher-Price
Fisher-Price Little People Animal Sounds Farm B8343 Manual de usuario
Fisher-Price
Fisher-Price KFP2112 Manual de usuario
Fisher-Price
Fisher-Price L5906 Manual de usuario
Fisher-Price
Fisher-Price W9898 Manual de usuario
