Field Controls FIELD DIRECT VENT SYSTEM REDUCING TEE Manual de usuario

www.eldcontrols.com

Please retain these instructions after installation.

This device MUST be installed by a qualied agency in accordance with the manufacturer's installation instructions. The denition of

a qualied agency is: any individual, rm, corporation or company which either in person or through a representative is engaged

in, and is responsible for, the installation and operation of HVAC appliances, who is experienced in such work, familiar with all the

precautions required, and has complied with all the requirements of the authority having jurisdiction.

READ THESE INSTRUCTIONS CAREFULLY AND COMPLETELY BEFORE PROCEEDING WITH THE INSTALLATION.

Installation Date:

Installed By: Phone:

FIELD DIRECT VENT SYSTEM

REDUCING TEE

Model: FDVS WITH REDUCING TEE

page 2

Figure 1

Figure 2

REDUCING TEE INSTALLATION

1. Apply a bead of sealant to appliance collar

approximately 1" from end of collar.

(See Figure 1)

2. Remove all oil and grease from the inside of the

appliance reducing tee and apply a bead of

sealant to inside of reducing tee 1⁄2" from end.

(See Figure 1)

3. With a twisting motion, assemble the reducing

tee rmly onto the appliance collar.

4. Push the reducing tee onto the appliance collar,

using care to avoid damaging the appliance

collar or the reducing tee. (See Figure 2)

5. Assemble clamp halves using the supplied 5⁄16"

bolts and square nuts, and install the appliance

clamp onto the reducing tee and tighten

securely. (See Figure 1)

6. Install the supplied self-drilling, self-tapping

anchoring screws through the 4 holes in the

appliance clamp into the appliance collar.

(See Figure 2) No pilot hole is required.

7. Apply sealant to the end of the reducing tee

and anchoring screws. (See Figure 2)

8. After testing and burner adjustments have

been made, apply sealant to the supplied 3⁄8"

sampling port plug screw and install the screw

in the sampling port. (See Figure 2)

page 3

JOINT ASSEMBLY: VENT PIPE TO TERMINATION AND

REDUCING TEE

If necessary, the vent pipe may be cut to length with a

hacksaw or cut o saw.

CAUTION: Use safety glasses and other appropriate

safety gear.

1. Pull outer vent pipe back 1-2" from inner vent

pipe end and remove insulation. (See Figure 3)

2. Slide cover sleeve onto end of vent pipe a few

inches back from end of outer vent pipe.

(See Figure 3)

3. Slide cover ring over stop bead on termination

inner pipe. (See Figure 3)

4. Assemble inner pipe clamp halves using the

supplied 1⁄4" bolts and square nuts, and position

inner pipe clamp 1⁄4" from end of inner pipe.

(See Figure 3)

5. Remove all oil and grease from end of termination

inner pipe and apply a bead of sealant between

the stop bead and retainer bead. (See Figure 4)

6. Apply a thick bead of sealant to inside of inner

vent pipe 1⁄2" from the end of pipe, working the

sealant into the corrugations. (See Figure 4)

7. Push the inner vent pipe onto the termination inner

pipe all the way up to the stop bead.

8. Tighten the inner pipe clamp bolts until both

clamp halves are within 1⁄8" of each other at each

end. (See Figure 5)

9. Slide the cover sleeve and cover ring together to

engage the ring in the groove of the sleeve and

tighten the cover sleeve clamp. (See Figure 6)

10. Repeat this procedure to install vent pipe on

reducing tee.

11. To maintain 1" clearance to combustibles, wrap

minimum 11⁄2" thick ceramic insulation (installer-

supplied) around the exposed portion of the

termination inner pipe (See Figure 6), and secure

with foil tape (installer supplied).

Figure 6

Figure 5

Figure 4

Figure 3

Phone: 252.522.3031 • Fax: 252.522.0214

www.fieldcontrols.com

Warranty

For warranty information about this or any Field Controls product, visit:

www.eldcontrols.com/warranty

Tabla de contenidos

Otros manuales de Admirador de Field Controls

Field Controls

Field Controls 46378300 Manual de usuario

Field Controls

Field Controls 46284600 Manual de usuario

Field Controls

Field Controls 46413900 Manual de usuario

Field Controls

Field Controls 46256400 Manual de usuario

Field Controls

Field Controls 46115300 Guía del usuario

Field Controls

Field Controls 46261200 Manual de usuario

Field Controls

Field Controls 1536760 Manual de usuario

Field Controls

Field Controls 46385600 Manual de usuario

Field Controls

Field Controls CAC-120 Manual de usuario

Field Controls

Field Controls 46086300 Instrucciones de montaje

Field Controls

Field Controls PVG-100 Manual de usuario

Field Controls

Field Controls FC95HRV Operation and Hoja de especificaciones

Field Controls

Field Controls 46233500 Guía

Field Controls

Field Controls 46334800 Manual de usuario

Field Controls

Field Controls 46107700 Manual de usuario

Field Controls

Field Controls 46483500 Manual de usuario

Field Controls

Field Controls 46330800 Manual de usuario

Field Controls

Field Controls 46477000 Manual de usuario

Field Controls

Field Controls VentCool 2.4 Manual de usuario

Field Controls

Field Controls 46457000 Manual de usuario

Field Controls

Field Controls Oil Venting Systems Manual de usuario

Field Controls

Field Controls CAS-4 Manual de usuario

Field Controls

Field Controls 46139100 Manual de usuario

Field Controls

Field Controls 46326900 Manual de usuario

Manuales populares de Admirador de otras marcas

ELTA FANS

ELTA FANS H03VV-F Manual de usuario

Hunter

Hunter 20714 Manual de instrucciones

Emerson

Emerson CARRERA VERANDA CF542ORB00 Manual de usuario

Hunter

Hunter Caraway Manual de instrucciones

Panasonic

Panasonic FV-15NLFS1 Manual de usuario

Kompernass

Kompernass KH 1150 Manual de usuario

VES

VES FALA100/12V/TR Manual de usuario

Vertiv

Vertiv Liebert DCD Manual de usuario

Westinghouse

Westinghouse GFP Series Manual de usuario

Venmar

Venmar KUBIX HRV PLUS Series Manual de usuario

Maico

Maico ECR 31 Manual de usuario

Sonnenkonig

Sonnenkonig Dinky Manual de usuario

S&P

S&P ECOWATT HXBR Manual de usuario

Wider

Wider IMP03369BH Manual de usuario

Panasonic

Panasonic F-60DHN Manual de usuario

Hinkley

Hinkley HIGHLAND Manual de usuario

Broan

Broan 766BN Manual de usuario

Premium

Premium PFS16022 Instrucciones de montaje