FIBARO FGK Series Manual de usuario

First step to provide professional support and service is proper diagnose of failure. To avoid sending

fully functional devices to warranty service, please follow step by step guide below.

STEP 1. Check visually.

FIBARO Door/Window Sensor should have no scratches or cracks visible. However, if there

are any heavy mechanical damages, as smashed casing, casing bitten by a dog, warranty

will not be considered!

STEP 2. Check the battery.

To check the battery You will need voltmeter. Open the casing and touch voltmeter contacts

with battery poles. Remember to make a measurement while battery is connected. Properly

working battery should indicate voltage between 3,5 [V] up to 3,7 [V].IfYoudonthaveany

voltmeter, please simply try to change the battery from other, efficient module.

STEP 3. Resetting FIBARO Door/Window Sensor.

The FIBARO Door/Window reset erases the EEPROM memory, including all information on

the Z-Wave network and the main controller.

Reset procedure:

-takeoffthesensorscoverandremovebattery;

-makesurethetamperisntpressed;

-put the magnet near sensor;

-insert the battery;

-within 2 seconds remove the magnet from the sensor;

-after 3 seconds LED should start blinking;

-remove the battery and reinstall it again.

Successful reset should be confirmed by LED blinking.

STEP 4. Excluding and including sensor from Z-Wave Network.

Before every inclusion, sensor must be excluded from Z-Wave network. This can be done in

two ways, resetting sensor or:

-set main controller in learn mode (delete device mode);

-make sure sensors casing is closed;

-press tamper three times briefly;

To include sensor into Z-Wave network, please follow:

-set main controller in learn mode (add device mode);

-make sure sensors casing is closed;

-press tamper three times briefly;

-sensor should be added to device panel. Press tamper three times briefly to wake it up;

STEP 5. Reaction to the magnet.

After including sensor in Z-Wavenetworkcheckdevicesreedsensorefficiency:

-go to device panel in Z-Wave controller;

-put the magnet near the sensor. The device should change its state in the interface;

-take the magnet away from the sensor. The device should change its state in the interface

again;

-check whether LED is blinking during test.

STEP 6. Loose casing.

Casing in the sensor shouldntbeloose.Ifsuchsituationoccurred,pleasefollow:

-check whether casing is closed properly from both sides of the sensor;

-check whether antenna inside the sensor is on its place.

Antenna should be curved and placed near casing.

STEP 7. Contact with service.

If only one of steps above has failed, please contact with Fibaro Servicedesk at:

servicedes[email protected]

Tabla de contenidos

Otros manuales de Accesorios de FIBARO

FIBARO

FIBARO FGWPB-121 Manual de usuario

FIBARO

FIBARO Walli Outlet E Manual de usuario

FIBARO

FIBARO FGFS-101 Manual de usuario

FIBARO

FIBARO FGFS-101-ZW5 Manual de usuario

FIBARO

FIBARO FGWPG-111 Manual de usuario

FIBARO

FIBARO FGFS-101 Manual de usuario

FIBARO

FIBARO FGBHDW-002 Manual de usuario

FIBARO

FIBARO FGK-10x Manual de usuario

FIBARO

FIBARO FGWPA-111 Manual de usuario

FIBARO

FIBARO Flood Sensor Manual de usuario

FIBARO

FIBARO FGK-101 Manual de usuario

FIBARO

FIBARO FGFS-001 Manual de usuario

FIBARO

FIBARO FGBHCD-001 Manual de usuario

FIBARO

FIBARO CO Sensor FGCD-001 Manual de usuario

FIBARO

FIBARO Flood Sensor Manual de usuario

FIBARO

FIBARO FGBHMS-001 Guía de instalación

FIBARO

FIBARO FGBHFS-001 Manual de usuario

FIBARO

FIBARO FGFS-101 Manual de usuario

FIBARO

FIBARO FGWPB-111 Manual de usuario

FIBARO

FIBARO FGBHMS-001 Manual de usuario

FIBARO

FIBARO FGBHFS-101 Manual de usuario

FIBARO

FIBARO FGDW-002 Manual de usuario

FIBARO

FIBARO FGFS-101 Manual de usuario

FIBARO

FIBARO FGWP-102 Manual de usuario

Manuales populares de Accesorios de otras marcas

Hillco

Hillco 2810 Manual de usuario

Siemens

Siemens QSA2700D Manual del operador

Contours

Contours ZY024 Manual de usuario

Saivod

Saivod VS621 Manual de usuario

Virtuox

Virtuox VirtuCLEAN 2.0 Manual de usuario

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Manual de usuario

Z-Wave

Z-Wave HSD-200Z Manual de usuario

turck

turck FMX-IM-2UPLI63FX Manual de usuario

Decagon Devices

Decagon Devices 10HS Manual de usuario

UPPAbaby

UPPAbaby Cup Holder Manual de usuario

Elko

Elko SmartSensor Leakage Wireless Manual de usuario

Grizzly

Grizzly H8371 Manual de usuario

Panasonic

Panasonic HG-T Series Manual de usuario

IFM Electronic

IFM Electronic Efector 250 Series Guía de referencia

DigiDesign

DigiDesign 888/24 I/O Manual de usuario

PROZIS

PROZIS QUAY Manual de usuario

patagonia

patagonia PSI Vest Manual de usuario

SFC Energy

SFC Energy EFOY GO! Manual de usuario