280514VC
1. Cut a mounting hole 35mm in diameter. There must be a minimum 15mm width of at around the hole.
2. Fit benchtop rubber seal onto benchtop around 35mm hole.
3. Screw the two threaded studs into the mixer base.
4. Screw the “HOT” supply hose (with red marking) into mixer base hole ‘H’ (with red marking)
5. Screw the “COLD” supply hose (unmarked) into the last hole in the mixer base.
6. Lower the tted hoses, one hose at a time, into mounting hole.
7. From UNDERNEATH the bench, t ‘C’ rubber washer (if supplied), and metal washer around both hoses
and over the threaded stud.
8. Screw on the two M6 nuts and tighten with your ngers.
9. Check the mixer and the benchtop seal are correctly aligned on the bench. Secure with spanner.
10. Flush the supply pipes to remove debris.
11. Connect the water supply and check all the ttings are tight.
12. Turn on water supply and check for leaks.
Mixer Installation
Maximum bend for flexible hose is 35mm radius. The nipples on the hoses must be con-
nected to fittings which have machined end faces, not “sawn off” threaded tube.
Warranty, Maintenance & Care - USMC
For technical assistance please ring: 0800 743 358 or +64 9 528 0810
Felton Industries Limited - 8 Farmhouse Lane Glen Innes Auckland 1072 New Zealand www.felton.co.nz
Felton Industries Limited guarantees these mixers to be free from defects in materials and workmanship for a period of ten (10) years
from the date of purchase.
This warranty is effective for 10 years from the date of purchase and covers supply of replacement parts only and 5 years of plumbers
labour relating solely to repairing or replacing the mixer from the date of purchase, provided the product is installed by a registered
plumber. You must retain proof of purchase of the Mixer (such as an invoice or receipt) and proof of installation by a registered plumber
and provide these to Felton on request.
This warranty is for manufacturing defects only and does not cover any damage to product due to abuse, negligence or improper
installation. This warranty is given on the understanding that the product is installed by a registered plumber and operated according
to Felton’s installation guide and the Australian/New Zealand standard AS/NZS3500. This warranty is provided to persons who are a
“consumer” under the Consumer Guarantees Act 1993 only and for use in domestic/residential dwellings only (not for commercial use).
Please ll in the details below, attach your receipt to this installation guide and keep as your proof of purchase.
Purchased at:
Date of purchase:
Installed by:
At no stage should plated surfaces be cleaned with cleaning agents that contain a corrosive acid or a scour-
ing additive. Plated surfaces should be cleaned with liquid detergent or soap and water. Any damage caused
through the use of an unsuitable cleaner will not be covered by warranty.
This warranty is subject to any other rights or remedies that you may have under the Consumer Guarantees Act
1993 (or any other applicable legislation) and to Felton’s Terms of Trade.
