Fanaway CLASSIC Manual de usuario

V2.0 –EN –AU WS Classic ( 07/ 2018)

FANAWAY CLASSIC

CEILING FAN

INSTALLATION

OPERATION

MAINTENANCE

WARRANTY INFORMATION

CAUTION

READ INSTRUCTIONS CAREFULLY FOR SAFE

INSTALLATION AND FAN OPERATION.

Fanaway Classic Installation Instructions

2 | P a g e

THANK YOU FOR PURCHASING

Thank you for purchasing this quality Fanaway product. To ensure correct function and safety, please

read and keep all instructions before using the product.

SAFETY PRECAUTIONS

1. In Europe: This appliance can be used by children aged from 8 years and above and persons with

reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have

been given supervision or instruction concerning the use of the appliance in a safe way and

understand the hazards involved. Cleaning and maintenance shall not be undertaken by children

without supervision.

2. In Australia: The appliance is not intended for use by persons (including children) with reduced

physical, sensory or mental capabilities, or lack of experience and knowledge, unless theyhave been

given supervision or instruction concerning the use of the appliance by a person responsible for their

safety.

3. Children should be supervised to ensure that they do not play with the appliance.

4. An all-pole disconnection switch must be incorporated into the fixed wiring, in accordance with local

wiring rules.

IN AUSTRALIA

WARNING:

FOR SAFE USE OF THIS FAN AN ALL-POLE DISCONNECTION

MUST BE INCORPORATED INTO THE FIXED WIRING IN

ACCORDANCE WITH THE WIRING RULES.

As outline in clause 7.12.2 of AS/NZS 60335-1 for meeting the

minimum electrical safety of this standard.

Please note warranty will be void if installation is without a means

for an all-pole disconnection incorporated in the fixed wiring in

accordance with the wiring rules.

Fanaway Classic Installation Instructions

3 | P a g e

Example: If a fan is connected to a circuit that can be isolated via an

all-pole safety switch at the switchboard, then this is considered to

be an all-pole disconnection to the ceiling fan electrical circuit,

meeting the requirements of clause 7.12.2 of AS/NZS 60335.1.

A single-pole switch on the active of the receiver input of remote

control must also be included in the wiring, and located the

same room as the ceiling fan.

5. Do not dispose of electrical appliances as unsorted municipal waste, use separate collection

facilities. Contact your local government for information regarding the collection systems available. If

electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the

ground water and get into the food chain, damaging your health and well-being.

6. The structure to which the fan is to be mounted must be capable of supporting a weight of 50kg.

7. The fan should be mounted so that the blades are at least 2.3m above the floor in Europe or 2.1m

above the floor in Australia.

8. This fan is designed for indoor use only. Mounting the fan in a location where it is subject to water or

moisture is dangerous and will void the warranty.

9. Only a licensed electrician should execute the installation.

Fanaway Classic Installation Instructions

4 | P a g e

BEFORE INSTALLATION

Unpack your ceiling fan and carefully identify the parts. Please refer to Fig 1.

Fanaway Classic Installation Instructions

5 | P a g e

Fig. 1

Fanaway Classic Installation Instructions

6 | P a g e

Mounting bracket x 1

Retraction mechanism x 1

Canopy screws x 4

Lamp base x 1

Canopy x 1

Lamp shade x 1

Down rod x 1

Light kit x 1

Bolt and pin cover x 1

Light kit screw x 3

Bolt x 1

Wooden screw x 2

Pin x 1

Wall swtich x 1 set

Top housing x 1

Blades x 4

INSTALLING THE MOUNTING BRACKET

The ceiling fan must be installed in a location so that the blades are a minimum 300mm spacing from

the tip of the blade to the nearest objects or walls.

Secure the hanging bracketto the ceiling joist or structure that is capable of carrying a load of at least

50kg, with the two long screws provided. Ensure at least 30mm of the screw is threaded into the

support.

NOTE: The bracket screws provided are for use with wooden structures only. For structures

other than wood, the appropriate screw type MUST be used.

Angled Ceiling Installation

This fan hanging system supports a maximum 15 degree angled

ceiling installation.

Fig. 2

Fig. 3

Fanaway Classic Installation Instructions

7 | P a g e

INSTALLING THE FAN

Installing the down rod

1) Feed the down rod (5) through the canopy (4) and the bolt and pin cover (6).

2) Remove the ball joint (2) by loosening the set screw (3), insert the motor wires through the down

rod then secure the ball joint back to the down rod.

3) Insert the down rod to the coupling (7), line up the coupling holes with the down rod holes and

insert the bolt (8). Then insert the pin (9) to the end of the bolt.

4) Finally secure the down rod and coupling by tightening the two set screws (10) on the coupling.

Fig. 4

HANGING THE FAN

Lift the fan assembly onto the mounting bracket. Ensure the registration slot (A) of the hanger ball is

positioned on the stopper (B) of the mounting bracket (C) to prevent the fan from rotating when in

operation. (Fig.5)

Fig. 5

Fig. 4

Fanaway Classic Installation Instructions

8 | P a g e

FAN INSTALLATION

Light kit installation

1. Loosen the screw (1) from the lamp shade bracket (3). Align the two slot screws (2) with the keyhole

slots of the lamp shade (4). Fig.6

2. Turn the lamp shade counterclockwise until the slot screws are firmly at the end of the slots.

3. Secure screw 1 back to the lamp shade bracket. Tighten all three screws. Do not over-tighten.

4. Connect the plugs (8) together.

5. Loosen the screw (5) from the lamp shade (4). Align the two slot screws (6) with the keyhole slots of

the light kit (7). Fig.7

6. Turn the light kit counterclockwise until the slot screws are firmly at the end of the slots.

7. Secure screw 5 back to the lamp shade. Tighten all three screws. Do not over-tighten.

8. Install the globes (Not included) to the lamp holders.

Fig. 6

Fig. 7

Fanaway Classic Installation Instructions

9 | P a g e

ELECTRICAL WIRING DIAGRAM

WARNING: FOR YOUR SAFETY ALL ELECTRICAL CONNECTIONS MUST BE UNDERTAKEN BY A

LICENSED ELECTRICIAN.

NOTE: AN ADDITIONAL ALL POLE DISCONNECTION MUST BE INCORPORATED IN THE FIXED

WIRING IN ACCORDANCE WITH THE WIRING RULES.

USE WITH WALL SWITCH WIRING DIAGRAM:

USE WITH REMOTE WIRING DIAGRAM: (REMOTE sold seperately)

1/ Remote without plugs

Fig. 9

Fig. 10

Fanaway Classic Installation Instructions

10 | P a g e

2/ Remote with plugs

FINISHING THE INSTALLATION

After completing the electrical connection at the mounting bracket terminal block, connect the ceiling

fan wiring via the quick connector plug.

Cover the mounting bracket with the canopy. Ensure all electrical wiring is tucked inside the canopy

and that the wires are not damaged during this step. Secure the canopy to the hanger bracket using

the screws provided.

Fig. 12

Fig. 11

Otros manuales para CLASSIC

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Admirador de Fanaway

Fanaway

Fanaway EVO2 Manual de servicio

Fanaway

Fanaway CLASSIC Guía de instalación

Fanaway

Fanaway VEIL Manual de usuario

Fanaway

Fanaway ORBIT Manual de usuario

Fanaway

Fanaway Montclair Manual de usuario

Fanaway

Fanaway LD-0003-11/WH/GS Manual de servicio

Fanaway

Fanaway CORBELLE Manual de usuario

Fanaway

Fanaway ORBIT Manual de usuario

Fanaway

Fanaway EVO1 - PREVAIL Manual de usuario

Fanaway

Fanaway ORBIT DC Manual del propietario

Fanaway

Fanaway LED EVO1 Manual de usuario

Fanaway

Fanaway INDUSTRI Guía de instalación

Fanaway

Fanaway Classic LD-0003 16 01 Series Guía de instalación

Fanaway

Fanaway LED EVO1 Manual de usuario

Fanaway

Fanaway LED EVO1 Guía de instalación

Fanaway

Fanaway EVORA Manual de usuario

Fanaway

Fanaway LD-48 FAN IN Manual de usuario

Fanaway

Fanaway MYA Manual de usuario

Fanaway

Fanaway NEXUS Manual de usuario

Fanaway

Fanaway LED EVO1 Manual del propietario

Fanaway

Fanaway XIAO Manual de usuario

Fanaway

Fanaway FANAWAY FRASER Manual de usuario

Fanaway

Fanaway EVO3 Manual de servicio

Fanaway

Fanaway EVO1 - PREVAIL Manual de servicio

Manuales populares de Admirador de otras marcas

ELTA FANS

ELTA FANS H03VV-F Manual de usuario

Hunter

Hunter 20714 Manual de instrucciones

Emerson

Emerson CARRERA VERANDA CF542ORB00 Manual de usuario

Hunter

Hunter Caraway Manual de instrucciones

Panasonic

Panasonic FV-15NLFS1 Manual de usuario

Kompernass

Kompernass KH 1150 Manual de usuario

VES

VES FALA100/12V/TR Manual de usuario

Vertiv

Vertiv Liebert DCD Manual de usuario

Westinghouse

Westinghouse GFP Series Manual de usuario

Venmar

Venmar KUBIX HRV PLUS Series Manual de usuario

Maico

Maico ECR 31 Manual de usuario

Sonnenkonig

Sonnenkonig Dinky Manual de usuario

S&P

S&P ECOWATT HXBR Manual de usuario

Wider

Wider IMP03369BH Manual de usuario

Panasonic

Panasonic F-60DHN Manual de usuario

Hinkley

Hinkley HIGHLAND Manual de usuario

Broan

Broan 766BN Manual de usuario

Premium

Premium PFS16022 Instrucciones de montaje