Explore Scientific ES-2ROBV Manual de usuario
TWO ROOM POP-UP OBSERVATORY TENT
INSTRUCTIONS
Item No. ES-2ROBV
V.012021
This tent is made of flame-resistant fabric which meets CPAI-84 specifications. IT IS NOT FIRE-PROOF. The fabric will burn if left in continuous contact with any flame
source. The application of any foreign substance to the product fabric may render the flame-resistant properties ineffective.
– DO NOT use fuel burning devices inside or near tent materials.
– DO NOT permit children to light matches, operate burning appliances, or handle any flame sources in or near the tent.
– DO NOT smoke, use matches, candles or open flames of any kind in or near the tent.
– DO NOT refuel lanterns, stoves or heaters inside tent.
– DO NOT cook inside tent.
– DO NOT store flammable liquids inside tent.
WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC.
Page 1
© 2021 Explore Scientific, LLC. 1010 S 48th Street, Springdale, AR 72762
explorescientificusa.com | 866.252.3811 All rights reserved. Made in China.
6 ft
60” X 60”TENT EXTENSION TENT 120” X 180”TOP COVER
12 PARACORDS
WITH CORD LOCKS 12 GROUND STAKES
#1. Grab the 60 x 60 tent and extension tent.
Carefully expand and set aside.
BEFORE YOU BEGIN
Read all instructions thoroughly before beginning set up.
– Select a level site clear of rocks, branches, and other hard or sharp
objects, to set up your tent.
– Do not set up your tent under trees because of potential lightning
strikes or falling tree limbs in inclement weather.
#2. Stand the 60 x 60 tent upright, open and
pull from the center to form the structure.
NOTE: Some twisting of the steel loops might
be necessary to form the correct shape.
#3. Open both entrances and roll the door flaps.
Use the attached straps to tie the flaps.
CAUTION: This structure uses a spring steel loop that will pop open quickly!
1
2
WHAT’S IN THE BOX
Page 2 Continue
SCAN THE QR CODE TO VISIT OUR PRODUCT PAGE TO
VIEW OUR “HOW TO SET UP” VIDEO.
#4. Stand the extension tent upright, open each side and locate the hook
and loop fasteners.
#5. Locate the hook and loop fasteners on the 60 x 60 tent.
Hook & Loop Fastener
Hook & Loop Fastener
Hook & Loop
Fastener
#6. Attach the extension tent to the 60 x 60 tent
with the hook and loop fasteners.
Optional: For a more secure structure, slide
stakes through each bottom loop corner and
hammer into the ground.
#9. Use the 120 x 180 top cover for temporary protection when
not in use. Follow Steps #7 and #8 to secure the top cover.
NOTE: Use the same stakes from Step #8 to attach the paracords.
Top cover should be loose and not taut to keep the structure up.
#7. Take the paracords and insert one on
each top corner loop of the tents. Make a
knot of your choice to secure.
#8. Hammer stakes into the ground and
extend the paracords out at a 45° angle
from the tent.
Tighten the paracords as needed by
adjusting the slider up the cord.
NOTE: Tents should be taut when staked
properly.
x6
Slider
Page 3 Continue
Page 4
HOW TO FOLD AWAY
1
2
Start with the 60 x 60 tent, push one corner into the
opposite corner and fold down the center flat.
Rotate tent 180° and hold as shown with the peak
pointing away from you.
Take one corner and connect it to the opposite corner.
Slide the top corner to the left. Fold in the circles that are formed on each side.
Extension tent, fold each side panel to the inside flat.
180°
1
2
Otros manuales de Carpa de Explore Scientific
