Event Lighting STORM Manual de usuario

STORM

12W LED RGBW Rotating Multi Beam Effect Light

USER MANUAL

For your safety, please read this user manual carefully before use.

Event Lighting reserves the right to revise the manual at any time. Information and specifications

within this manual are subject to change without notice. Event Lighting assumes no liability or

responsibility for any errors or omissions. Please consult Event Lighting for any clarification or

information regarding this item.

Version 1.0 (revised 5 November 2020)

www.event-lighting.com.au

Safety Instructions

Warning

• Do not open this device, there are no user serviceable parts inside. Risk of electric

shock.

• Do not look directly at the light source from close range.

• Avoid contact with the unit during operation, as the housing may become hot. Allow the

fixture to cool for at least 15 minutes after turning off before touching.

• Install this device in a location with adequate ventilation, at least 50cm from adjacent

surfaces.

• Do not operate this device, or connect this device to power, within 50cm of any

flammable material.

• Use a safety chain when mounting this device overhead.

• Do not operate this device outdoors where excessive dust, heat, water, or humidity may

affect it.

• Do not operate this device if the housing, lenses, or cables appear damaged.

• Do not connect this device to a dimmer or rheostat.

• Do not operate this device at temperatures higher than 40°C (104°F).

• Only connect this device to a grounded and protected circuit.

• Only use the hanging bracket to carry this device.

• Stop using this device immediately if a serious operating problem becomes apparent.

Power Input and Power Linking

This device has an auto switching power supply work with input voltage range of 100-240V AC,

50/60Hz. Link up to a maximum of 8A. Do NOT exceed this numbe.r

Product Installation

STORM can be mounted in many orientations, provided each individual device is secured by the

use of the correct mounting bracket. Use a safety chain when mounting STORM overhead.

Fuse Replacement

If the fine-wire fuse of the device fuses, replace the fuse with one of the same type of rating.

Before replacing the fuse, unplug the device from the power source.

Fuse Replacement Steps

1. Unscrew the fuse holder located on the rear panel from the housing.

2. Remove the old fuse from the holder.

3. Install the new fuse into the holder.

4. Place the fuse holder back into the housing and secure tightly.

www.event-lighting.com.au

Dimensions

Control Panel

Buttons and Indicators

(1) LED Display

(2) DMX signal LED indicator (On/Off)

(3) Slave Mode LED indicator (On/Off)

(4) Master Mode LED indicator (On/Off)

(5) Sound Active Mode LED indicator (On/Off)

(6) MENU – Select an operation mode or return to

previous screen.

(7) UP – Increase parameters.

(8) DOWN – Decrease parameters.

(9) ENTER – Confirm the selected function.

Input and Output

(10) Fuse (T3A M205)

(11) IEC Power In

(12) IEC Power Out

(13) DMX In

(14) DMX Out

www.event-lighting.com.au

Press the MENU button to select an operation mode or return to the previous menu. Use UP and

DOWN to navigate the menu. Press ENTER to change or activate menu options.

DMX Chart

Channel

Value

Function when Channel 1’s

value is 59-255

Function when Channel 1’s value

is 0-58

000 - 058

Switch on colour dimmer DMX

mode

059 - 078

Auto show 1

079 - 098

Auto show 2

099 - 118

Auto show 3

119 - 138

Auto show 4

139 - 158

Auto show 5

159 - 178

Auto show 6

179 - 198

Auto show 7

199 - 227

Sound active show 1

228 - 255

Sound active show 2

000 - 255

Program speed adjustment for

auto show 5, 6 & 7

Master dimmer

000 - 255

Strobe speed adjustment

strobe speed adjustment

000 - 255

Motor speed adjustment

Red 0% ~ 100%

000 - 255

Green 0% ~ 100%

000 - 255

Blue 0% ~ 100%

000 - 255

White 0% ~ 100%

Select DMX Address

Master Mode

Slave Mode

First digit: Motor Speed. Second digit: Program

Program Speed adjustment for Auto Program 5, 6, 7

Strobe Speed

Sound Active Program 1 or 2

Red LED Brightness

Green LED Brightness

Blue LED Brightness

White LED Brightness

Motor Speed

Normal Display

Inverted Display

Software Version

www.event-lighting.com.au

000 - 009

The motor stops

010 - 128

Counter clockwise rotation speed

adjustment (slow to fast)

129 - 137

The motor stops

138 - 225

Clockwise rotation speed

adjustment (slow to fast)

Technical Specifications

Photometrics

• Light Source: 1x 12W CREE RGBW 4-in-1 LED

• Coverage angle: 85°

• LED Lifespan: 50,000 hours.

Power

• Input Voltage: 100~240V AC, 50/60 Hz.

• Power Consumption: 72W.

• Connection: IEC in/out.

Control

• Protocol: DMX512.

• Operation modes: DMX, auto, manual, sound active, master/slave

• DMX Channels: 8

• Interface: 3-pin DMX in/out.

• Display: LED Display with 4-button control.

Housing

• Finishing: Matte Black.

• Net Weight: 3.15kg

• Dimensions: 168x309x314 mm.

Warranty

Please refer to your local dealer or contact Event Lighting.

Tabla de contenidos

Otros manuales de Equipo de DJ de Event Lighting

Event Lighting

Event Lighting NITROBALL2 Manual de usuario

Event Lighting

Event Lighting PRO PAR PAR6X12OB Manual de usuario

Event Lighting

Event Lighting BLINDER Series Manual de usuario

Event Lighting

Event Lighting F100WWMZ Manual de usuario

Event Lighting

Event Lighting M1S190W Manual de usuario

Event Lighting

Event Lighting DARKSTAR Manual de usuario

Event Lighting

Event Lighting PAR12x8A Manual de usuario

Event Lighting

Event Lighting M1H200W Manual de usuario

Event Lighting

Event Lighting PRO PAR PAR12X8L Manual de usuario

Event Lighting

Event Lighting PS200LECW Manual de usuario

Event Lighting

Event Lighting PARP12x8 Manual de usuario

Event Lighting

Event Lighting M1S75W Manual de usuario

Event Lighting

Event Lighting PAN2*1*30 Manual de usuario

Event Lighting

Event Lighting ORBIT2 Manual de usuario

Event Lighting

Event Lighting ENFORCER580 Manual de usuario

Event Lighting

Event Lighting PRO PAR Manual de usuario

Event Lighting

Event Lighting EL1000RGB Manual de usuario

Event Lighting

Event Lighting M19W15RGBW Manual de usuario

Event Lighting

Event Lighting F100WWMZ Manual de usuario

Event Lighting

Event Lighting LM60S Manual de usuario

Event Lighting

Event Lighting PIXBAR12x12 Manual de usuario

Event Lighting

Event Lighting M7W40RGBW Manual de usuario

Event Lighting

Event Lighting M1S80W Manual de usuario

Event Lighting

Event Lighting Fresnel Manual de usuario

Manuales populares de Equipo de DJ de otras marcas

ALPHA LITE

ALPHA LITE ALPHA 1500 Manual del propietario

Chauvet

Chauvet OVATION E-930VW Manual de usuario

Zumtobel

Zumtobel APHRODITE Home Manual de usuario

Snow Masters

Snow Masters Zig Oscillator Manual de usuario

EuroLite

EuroLite 50530554 Manual de usuario

Beamz

Beamz BUV243 Manual de usuario

thomann

thomann Stairville DJ Lase 40-G MK-III Manual de usuario

Eagletone

Eagletone 6 Eyes Flower Manual de usuario

EuroLite

EuroLite FLD-1508 Manual de usuario

Technical Pro

Technical Pro LG8xSEA Manual de usuario

JB Systems

JB Systems Lounge Laser DMX Manual de usuario

Lightmaxx

Lightmaxx Vega Halo 90 Manual de usuario

Elation

Elation FUZE WASH Z350 Manual de usuario

Maverick

Maverick MK3 WASH Manual de usuario

Infinity

Infinity TF-260C7 Fresnel Manual de usuario

Chauvet

Chauvet EVE E-50Z Manual de usuario

Eliminator Lighting

Eliminator Lighting E 138 Manual de usuario

EuroLite

EuroLite Mini Multicolor LED Flashing Light SC Manual de usuario