3. Vacuum toilet reassembly
During this procedure refer to g. 4 and 5.
3.1. Install the toilet push button.
3.1.1. Check to see that the hole in the porcelain is circular. If not, le the hole to the proper size, so that the
push button moves freely.
3.1.2. Position the lower part of the push button assembly in the porcelain.
3.1.3. Install the upper parts of the push button assembly through the hole in the porcelain.
3.1.4. Secure the push button assembly in position with the locking pin.
Bowl mounted push button
Fig. 4
Upper part of push button
Locking pin
Lower part of push button
3.2. Attach the water connection hose to the water valve inlet and install the push button hose into the ush
control unit.
3.2.1 For units with a water connection through the back and a USPH vacuum breaker, disconnect the hose from
the water valve outlet. Remove the elbow from the hose. Connect the vacuum breaker inlet hose to the
water valve. Insert the elbow into the vacuum breaker outlet hose and connect the other end of the elbow
to the ush ring.
3.2.2 For units with a water connection through the back and that not have a vacuum breaker, insert the elbow
on the end of the hose from the water valve outlet to the ush ring.
3.2.3 For units with a side water connection, remove the connector and cut off the tubing, leaving a tube length of
approximately 20 mm. Install the side water connector. Attach the elbow to the end of the water connection
hose. Connect one end of the water connection hose to the water valve inlet on the ush control unit, and
connect the end with the elbow to the side connection.
EVAC reserves the right to make alterations to this specication without prior notice.
© Copyright Evac Oy. All rights reserved.
installation
Date: Doc.
VACUUM TOILET
4
5350000 EVACinCliCk 1
05 Jun 2013 2:01009E
