EUTECH INSTRUMENTS DO 6 - REV 2 Manual de usuario

Technolo

ade

Instruction Manual

DO 6

Economy Hand-held Dissolved Oxygen Meter

68X243622

Rev 2 Apr 08

Part of Thermo Fisher Scientific

Preface

This manual serves to explain the use of the DO 6 Dissolved Oxygen Handheld.

This manual functions in two ways: first as a step by step guide to help you

operate the meter; second, as a handy reference guide.

This manual is written to cover as many anticipated applications of the DO6

palm-top meter as possible. If there are doubts in the use of the Dissolved

Oxygen Handheld, please do not hesitate to contact the nearest Eutech

Instruments / Oakton Instruments authorized Distributor.

Eutech Instruments/Oakton Instruments will not accept any responsibility for

damage or malfunction to the meter caused by improper use of the instrument.

The information presented in this manual is subject to change without notice as

improvements are made, and does not represent a commitment on the part of

Eutech Instruments / Oakton Instruments.

Eutech Instruments Pte Ltd

Oakton Instruments

TABLE OF CONTENTS

1INTRODUCTION ..........................................................................1

2DISPLAY & KEYPAD FUNCTIONS.............................................2

2.1 DISPLAY .................................................................................2

2.2 KEYPAD ..................................................................................3

3PREPARATION............................................................................4

3.1 INSERTING &REMOVING RUBBER BOOT ................................4

3.2 INSERTING THE BATTERIES .....................................................5

3.3 BATTERY REPLACEMENT........................................................6

3.4 DISSOLVED OXYGEN PROBE INFORMATION............................7

3.5 CONNECTING THE PROBE TO METER ......................................9

3.6 SWITCHING THE METER ON..................................................10

3.7 MEASUREMENT MODE SELECTION:- PERCENTAGE

SATURATION (%), CONCENTRATION (MG/L)(PPM)AND

TEMPERATURE(T).................................................................11

4CALIBRATION...........................................................................12

4.1 IMPORTANT INFORMATION ON METER CALIBRATION...........12

4.2 PREPARING THE METER FOR CALIBRATION ..........................13

4.3 TEMPERATURE CALIBRATION ...............................................15

4.4 DISSOLVED OXYGEN CALIBRATION IN %SATURATION........17

4.4.1 To calibrate 100% Saturation:................................................17

4.4.2 To calibrate 0% Saturation.....................................................19

4.5 DISSOLVED OXYGEN CALIBRATION IN MG/L OR PPM

CONCENTRATION MODE ........................................................20

4.5.1 To calibrate in mg/L (ppm) Concentration mode:...................20

5MEASUREMENT........................................................................22

5.1 WITH AUTOMATIC TEMPERATURE COMPENSATION (ATC)..22

5.2 MANUAL TEMPERATURE COMPENSATION ............................23

5.3 TAKING MEASUREMENTS .....................................................25

5.3.1 To take measurements: .........................................................25

5.4 TAKING PRESSURE/SALINITY COMPENSATED DO

MEASUREMENTS...................................................................26

5.4.1 Pressure Setting Adjustment..................................................26

5.4.2 Salinity Setting Adjustment ....................................................29

6HOLD FUNCTION......................................................................30

7ADVANCED SETUP FUNCTIONS.............................................31

7.1 ADVANCED SETUP OVERVIEW..............................................31

7.1.1 To enter the % Saturation or Temperature Set Up menu: .....31

7.1.2 To enter the mg/L (ppm) Concentration Set Up menu:..........31

7.2 (COF.1) CONFIGURATION MENU..........................................36

7.2.1 Selection of Automatic Temperature Compensation..............36

7.2.2 Selection of mg/L or ppm mode .............................................38

7.3 (CAL.2) CALIBRATION DATA...............................................39

7.3.1 Viewing the % Saturation calibration data..............................39

7.3.2 Viewing the mg/L (ppm) Concentration calibration data ........39

7.4 (ELE.3) ELECTRODE PROPERTIES.........................................40

7.4.1 Viewing the electrode Slope Factor .......................................40

7.4.2 Viewing the % Saturation Offset (Only available in %

Saturation or Temperature Set Up menu):...............................................40

7.4.3 Viewing the 100% Saturation mV value.................................41

7.4.4 Viewing the 0% Saturation mV value.....................................41

7.5 (ATO.4) AUTOMATIC OFF ....................................................43

7.6 (RST.5) RESET TO FACTORY DEFAULT..................................44

7.6.1 Calibration Reset....................................................................44

7.6.2 User Reset .............................................................................46

7.7 (OFS.6) %SATURATION OFFSET ADJUSTMENT....................47

7.8 (DPR.7) DISSOLVED OXYGEN PARAMETERS.........................49

7.8.1 Pressure Setting Adjustment..................................................49

7.8.2 Salinity Setting Adjustment ....................................................51

8PROBE CARE AND MAINTENANCE........................................52

8.1 PROBE CARE .........................................................................53

8.2 PRE-MEMBRANED CAPS REPLACEMENT...............................53

8.3 TO REPLACE THE PROBE PRE-MEMBRANED CAP ....................54

8.4 ELECTROLYTE SOLUTION .....................................................55

9TROUBLE-SHOOTING GUIDE..................................................56

10 ERROR MESSAGES..................................................................57

11 FACTORY DEFAULT SETTINGS..............................................58

12 SPECIFICATIONS......................................................................60

13 ACCESSORIES..........................................................................62

14 ADDITIONAL INFORMATION....................................................63

14.1 DISSOLVED OXYGEN ............................................................63

14.1.1 General Information ...............................................................63

14.1.2 Measurement Units................................................................65

14.1.3 What Is Being Measured?......................................................65

14.1.4 Air Calibration.........................................................................66

14.1.5 Applications............................................................................66

15 WARRANTY...............................................................................68

16 RETURN OF ITEMS...................................................................69

Instruction Manual DO 6

1 INTRODUCTION

Thank you for purchasing the DO 6 Dissolved Oxygen Handheld. This economy

microprocessor-based handheld has a large custom LCD (Liquid Crystal

Display) for clear and easy reading.

The DO 6 offers the measurement of dissolved oxygen in the percentage

saturation mode and in the concentration mode. Temperature measurement is

also available in degrees Celsius. The meter ensures accurate measurement of

the Dissolved Oxygen values through its temperature, barometric pressure and

salinity compensation features.

Your meter includes a dissolved oxygen probe, refill solution, a rubber boot, 4

alkaline “AAA” batteries, and instruction manual.

Please read this manual thoroughly before operating your meter.

To order other accessories and standard solutions, please refer to the Section

on Accessories for more information.

Instruction Manual DO 6

2 DISPLAY & KEYPAD FUNCTIONS

2.1 Display

The meter has a large custom LCD that consists of 14-segment 4 digit display

and operation annunciators for Percentage Saturation measurement mode (%),

Concentration measurement mode (mg/L or ppm) and Temperature

measurement mode in degrees Celsius (T). Other annunciators include “A”

(when the ATC function is activated), “CAL” (when meter is in calibration mode)

and battery diagram for low battery condition. See Figure 1.

milligram per litre

(Concentration Mode)

mg/l

ppm

14-segment Liquid Crystal Display

Low Battery annunciato

Calibration Mode

Annunciator

CAL

Temperature Mode

A T C annunciator

parts per million

Percentage

(Percentage Saturation

Mode)

Figure 1: Active LCD display for DO 6

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Instrumento de medición de EUTECH INSTRUMENTS

EUTECH INSTRUMENTS

EUTECH INSTRUMENTS ION 700 - REV 3 Manual de usuario

EUTECH INSTRUMENTS

EUTECH INSTRUMENTS CYBERSCAN DO 100 DISSOLVED OXYGEN METER Manual de usuario

EUTECH INSTRUMENTS

EUTECH INSTRUMENTS Ion 700 Manual de usuario

EUTECH INSTRUMENTS

EUTECH INSTRUMENTS 450 Series Manual de usuario

EUTECH INSTRUMENTS

EUTECH INSTRUMENTS LEAD EPOXY Manual de usuario

EUTECH INSTRUMENTS

EUTECH INSTRUMENTS ECOSCAN DO 6 DO METER Manual de usuario

EUTECH INSTRUMENTS

EUTECH INSTRUMENTS WATERPROOF PHTESTER 102030BNC Manual de usuario

EUTECH INSTRUMENTS

EUTECH INSTRUMENTS NITRATE EPOXY Manual de usuario

EUTECH INSTRUMENTS

EUTECH INSTRUMENTS WATERPROOF SALTTESTR Manual de usuario

EUTECH INSTRUMENTS

EUTECH INSTRUMENTS DO 700 Manual de usuario

EUTECH INSTRUMENTS

EUTECH INSTRUMENTS CYBERSCAN PH 110 PHMVRS232 METER Manual de usuario

EUTECH INSTRUMENTS

EUTECH INSTRUMENTS CON 700 - REV 2 Manual de usuario

EUTECH INSTRUMENTS

EUTECH INSTRUMENTS ION 6 PLUS PH ION MV TEMP Manual de usuario

EUTECH INSTRUMENTS

EUTECH INSTRUMENTS STANDARD TDSCAN 4 CONDUCTIVITY TESTER Manual de usuario

EUTECH INSTRUMENTS

EUTECH INSTRUMENTS Oakton CON 510 Manual de usuario

EUTECH INSTRUMENTS

EUTECH INSTRUMENTS WATERPROOF EC Manual de usuario

EUTECH INSTRUMENTS

EUTECH INSTRUMENTS CYBERSCAN PH 10 PHMV METER Manual de usuario

EUTECH INSTRUMENTS

EUTECH INSTRUMENTS CyberScan IR TB100 Manual de usuario

EUTECH INSTRUMENTS

EUTECH INSTRUMENTS WATERPROOF TDSCAN 4 CONDUCTIVITY TESTER Manual de usuario

EUTECH INSTRUMENTS

EUTECH INSTRUMENTS CYBERSCAN CON 11 CONDUCTIVITYTDS METER Manual de usuario

EUTECH INSTRUMENTS

EUTECH INSTRUMENTS CYBERSCAN PH500 PHORP BENCH METER Instrucciones de montaje

EUTECH INSTRUMENTS

EUTECH INSTRUMENTS CYBERSCAN TB 1000 TURBIDITY METER Manual de usuario

EUTECH INSTRUMENTS

EUTECH INSTRUMENTS TURBIDIMETER TN-100 WATERPROOF PORTABLE... Manual de usuario

EUTECH INSTRUMENTS

EUTECH INSTRUMENTS PCSTESTR 35 Manual de usuario

Manuales populares de Instrumento de medición de otras marcas

Suaoki

Suaoki D40 Manual de usuario

Elster

Elster BK-G1.6 Manual de usuario

Endress+Hauser

Endress+Hauser Deltabar FMD71 Manual

Duratool

Duratool D03128 Manual de usuario

Vega

Vega VEGAPULS 65 Manual de usuario

Tonghui

Tonghui TH2618B Manual de usuario

Tenmars

Tenmars TM-801 Manual de usuario

MSR

MSR 145 Manual de usuario

TPS

TPS WP-82 Manual de usuario

ELMETRON

ELMETRON CP-511 Manual de usuario

PCB Piezotronics

PCB Piezotronics 003C30 Manual de usuario

Tenma

Tenma 72-10465 Manual de usuario

Endress+Hauser

Endress+Hauser Proline Promag 50 Especificaciones técnicas

Siemens

Siemens SITRANS F Coriolis FCT030 Manual de lista de piezas

KLINGER

KLINGER CMF V Series Manual de usuario

EXFO

EXFO FTB-2 Manual de operación y mantenimiento

Keysight

Keysight M8290A Manual de usuario

ADTEK

ADTEK MW-5 Manual de usuario