Eureka VISTA Manual del propietario
TECHNICAL INSTRUCTION MANUAL: VISTA™ PEAK-TOP FRAME TENTS
©2018 Johnson Outdoors Gear, Inc. Product Code 5643895 - Rev. G / Jan 2018
Instruction Manual
VISTA™ PEAK-TOP FRAME TENTS
20' x 40' • 20' x 30' • 20' x 20'
15' x 15' • 10' x 20' • 10' x 10'
Featuring Eureka!'s Exclusive
Patented Swivel Corner Bracket
Patent # 7,219,681
TECHNICAL INSTRUCTION MANUAL: VISTA™ PEAK-TOP FRAME TENTS
©2018 Johnson Outdoors Gear, Inc.
www.eurekapartytents.com
Product Code 5643895 - Rev. G / Jan 2018
Prior to installing any tent, always make sure you check for overhead and underground obstructions!
For safe assembly, we recommend:
• Steel Toe Safety Shoes • Hard Hats/Helmets • Safety Gloves
• Utility Aprons • Step Ladders • Drop Cloths
• Cleaning Supplies • Sledge Hammer • Canopy Jacks
ALWAYS READ THE TECHNICAL INSTRUCTION MANUAL COMPLETELY BEFORE BEGINNING.
IF YOU HAVE ANY QUESTIONS, PLEASE CONTACT YOUR SALES REPRESENTATIVE OR THE
MANUFACTURER BEFORE YOU BEGIN.
Whether you are planning to do it yourself or hire a professional tent installation company,
always know what's underground. Call 811 prior to installing your tent and make sure your
underground utility lines are marked. It's FREE and helps prevent accidents and/or injury.
STOP
Whenever you install a tent with hardware at -
or above - the shoulders, always wear a hard
hat.
CAUTION
Proper staking is required on all tents. Soil
conditions can vary from site to site and within a
set up site. Additional stakes may be required in
soft soil conditions or whenever stakes pull up
from the ground. Vista Peak-Top Frame Tents
are NOT engineered or wind-rated.
CAUTION
Whenever you install a frame tent, you MUST
use the recommended number of Tent Jacks.
The “Rule of Thumb” is one (1) Tent Jack per
leg and/or tting along the length of the tent.
CAUTION
NEVER pick up a tent from the legs and
attempt to move it to a new location. The Peak
may get close to overhead power lines and
cause injury or death.
CAUTION
TECHNICAL INSTRUCTION MANUAL: VISTA™ PEAK-TOP FRAME TENTS
©2018 Johnson Outdoors Gear, Inc.
www.eurekapartytents.com
Product Code 5643895 - Rev. G / Jan 2018
1. Inspect the site and make sure the area is level, free of
underground utilities and any overhead obstructions.
2. Unload frame parts and tent bundles. Using the drawings at the
back of this manual, lay out the frame parts according to the drawing,
putting each frame bracket, cables, tubing and baseplates in their
approximate positions.
3. If you are using the 20' wide with Splice -- Pre-assemble the
perimeter tubes. Insert the splice into WHITE tubes and secure with
quick pins.
4. Next, starting at a corner bracket, begin to pin the perimeter of the
tent. Work clockwise and install the perimeter sections in sequence
by connecting the perimeter tubing from one bracket to the next. Work
your way around until the entire frame is complete. NOTE: The Swivel
Brackets should be placed in opposite corners for ease of use.
Assembly (20'x20' Shown)
TECHNICAL INSTRUCTION MANUAL: VISTA™ PEAK-TOP FRAME TENTS
©2018 Johnson Outdoors Gear, Inc.
www.eurekapartytents.com
Product Code 5643895 - Rev. G / Jan 2018
5. NOTE: It is important to attach the perimeter tubes at an angle. The
top of the tube should lean to the inside.
6. NOTE: On the 10'x10', make sure that the pin / hook faces to
the inside of the frame as shown. It will rip the fabric if turned to the
outside.
8. Next, attach the cross-cables. On square tents, there will be two
cables, there will be four on the rectangle tents. Attach the rst cable
diagonally across the frame, connecting the loop on the end of each
cable to the button on the inside top of each corner bracket. Next
attach the second cable. As you work on the second cable, lift the
perimeter frame corner so that the cable will reach. Lower the corner
and both cables will tighten.
7. At this point, lay a clean, dry drop cloth on the ground.
CORRECT
CORRECT
INCORRECT
TECHNICAL INSTRUCTION MANUAL: VISTA™ PEAK-TOP FRAME TENTS
©2018 Johnson Outdoors Gear, Inc.
www.eurekapartytents.com
Product Code 5643895 - Rev. G / Jan 2018
9. Drape the fabric over the perimeter frame, on top of the drop cloth.
Attach the small web loops on the top to the standard corner bracket
hooks. NOTE: Attach the top to the two standard brackets rst, then
intermediate brackets (on rectangle tents) and then attach the two
swivel brackets.
10. NO MORE FIGHTING WITH TIGHT FITTING CORNERS!!! With
the swivel bracket connected to the frame, and the swivel leg at out,
hook the small web loop over the metal rod.
12. Lastly, attach the snap pin through the bracket and center arm
to secure the corner. Repeat this process for any remaining Swivel
Corner Brackets.
11. Next, push down on the leg insert to swivel the corner into place.
TECHNICAL INSTRUCTION MANUAL: VISTA™ PEAK-TOP FRAME TENTS
©2018 Johnson Outdoors Gear, Inc.
www.eurekapartytents.com
Product Code 5643895 - Rev. G / Jan 2018
13. Attach the legs on one side. Lift one side of the perimeter frame.
Insert and pin a leg into each of the exposed corner and intermediate
brackets.
14. Assemble and attach the poke-up rod. To assemble the poke-up
rod for the rst time, remove the end pin located inside the tube. Insert
the pin into the top of the rod and secure. Insert the pulley bar into the
other end of the tube and secure with a bolt.
NOTE: The top pin of the poke-up rod may be inverted into the pole
for shipping purposes. Undo the bolt and pull out the top pin for
installation.
15. NOTE: For the 20'x20', 20'x30' and 20'x40' -- use a round hole.
For the 10'x10', 10'x20' and 15'x15' -- use the rst "oval" hole.
ROUND
Holes
OVAL
Hole
16. Push the top pin of the rod through the steel ring at the tent’s
peak. Remove the safety cap and roll the pulley insert across the top
cable toward the center. At center, pull down on the other cable and t
it into the slot in the bottom of the poke-up rod. Replace the safety cap.
TECHNICAL INSTRUCTION MANUAL: VISTA™ PEAK-TOP FRAME TENTS
©2018 Johnson Outdoors Gear, Inc.
www.eurekapartytents.com
Product Code 5643895 - Rev. G / Jan 2018
17. Attach the remaining legs. Lift the other side of the perimeter
frame. Insert and pin a leg into each of the remaining corner and
intermediate brackets. Adjust the height of the base plates as
necessary.
NOTE: When lifting large frames we recommend using canopy jacks.
18. Position the tent and straighten each leg. Adjust the baseplate
height for uneven ground. Then, stake each leg using a double
nailhead stake, secured through the hole in the baseplate.
NOTE: Before staking, make sure to check for underground utilities.
20. The Vista is now ready for use.
NOTE: For additional staking, attach guy ropes around corner and
intermediate brackets and tie off to stakes approximately 4' out from
the leg.
For takedown, follow the instructions in reverse.
19. Attach the web and ratchet straps at each corner and intermediate
bracket. Thread the small silver ring and web from the right side of
fabric through the silver ring on opposite side of the tent top. Then,
thread the left side web and ring through the right side. Pull both webs
down and attach an S-hook onto BOTH rings. Attach the other S-hook
on the ratchet to the hole on the baseplate toe. Working around the
frame, adjust the ratchets to tension and secure the fabric around the
tent evenly. Repeat with the remaining webs. Do not overtighten.
TECHNICAL INSTRUCTION MANUAL: VISTA™ PEAK-TOP FRAME TENTS
©2018 Johnson Outdoors Gear, Inc.
www.eurekapartytents.com
Product Code 5643895 - Rev. G / Jan 2018
20'x40' Specications
17'7"
16'1"
10"
8'1"
2'
18"
9'7"
8'
20’x40’ Side View (Length of the tent)
FRONT
16'7" 15'1"
7'or
or
or
20’20'
20’ Wide End View (Width of the tent)
BLUE 19’4”
BLUE 19’4”
BLUE 19’4”
BLUE 19’4”
BLUE 19’4”
BLUE 19’4” BLUE 19’4”
18"
9'7"
20'
40’
20’
8'1"
BASEPLATE
POKE UP
TECHNICAL INSTRUCTION MANUAL: VISTA™ PEAK-TOP FRAME TENTS
©2018 Johnson Outdoors Gear, Inc.
www.eurekapartytents.com
Product Code 5643895 - Rev. G / Jan 2018
20'x40' Overhead View & Parts List
Vista Corner Bracket 5573110 Qty. 2
Vista Swivel Bracket 2454026 Qty. 2
Vista Intermediate Bracket 2455127 Qty. 2
Vista/TT+ Baseplate 2455102 Qty. 6
Cable - 20'x20' cross cables 5574013 Qty. 4
Alum 2x4 19'4" BLUE 2450485 Qty. 7
Alum 2x4 6'8" CLEAR 2450492 Qty. 6
Alum 2x4 7'8" BLACK 2450480 Qty. 6
Vista Pulley Bar & Safety Cap 5574011 Qty. 2
Vista 20' Poke-Up Rod 5574014 Qty. 2
Web & Ratchets 2454025 Qty. 6
Silver Quick Pins 2450432 Qty. 12
Fastpin, #C5-25R 2 1/2" 2455105 Qty. 14
Bolt - 1/4x20 CR-8 5574015 Qty. 2
Lock Nut for 1/4x20 Bolt 5574016 Qty. 2
Snap Pin for Swivel Brkt 5558640 Qty. 2
LEGS - choose CLEAR for 7' legs
and BLACK for 8' legs
S
S
S
BB
B B B
B
B
B
C
Bk
TECHNICAL INSTRUCTION MANUAL: VISTA™ PEAK-TOP FRAME TENTS
©2018 Johnson Outdoors Gear, Inc.
www.eurekapartytents.com
Product Code 5643895 - Rev. G / Jan 2018
20'x30' Specications
17'7"
16'1"
10"
8'1"
2'
18"
9'7"
8'
20’x30’ Side View (Length of the tent)
FRONT
16'7" 15'1"
7'or
or
or
15' 15'
20’ Wide End View (Width of the tent)
BLUE 19’4”
BLUE 19’4”
BLUE 19’4”
RED 14’4”
RED 14’4”
RED 14’4” RED 14’4”
18"
9'7"
20'
30'
15'
8'1"
PLAN
BASEPLATE
POKE UP
Tabla de contenidos
Otros manuales de Carpa de Eureka
Eureka
Eureka Lone Tree 3 Manual de lista de piezas
Eureka
Eureka High Camp Manual de usuario
Eureka
Eureka Assault Outfitter 08 Manual de usuario
Eureka
Eureka Solar Shade Manual de usuario
Eureka
Eureka Sunrise Manual de usuario
Eureka
Eureka Gaspesie 2XT Manual de usuario
Eureka
Eureka Grand Manan 7 Manual de usuario
Eureka
Eureka Apex XT Manual de usuario
Eureka
Eureka Forte SQ 2XT Manual de usuario
Eureka
Eureka Genesis Manual de usuario
Eureka
Eureka TIMBERLINE 4XT Guía de configuración
Eureka
Eureka Timberline SQ XT Manual de usuario
Eureka
Eureka Chrysalis Manual de usuario
Eureka
Eureka N!ergy 1210 Manual de usuario
Eureka
Eureka Apex 2XT Manual
Eureka
Eureka Wild Basin 4 Manual de lista de piezas
Eureka
Eureka N!ergy 1310 Manual de usuario
Eureka
Eureka Combat Manual de usuario
Eureka
Eureka Forte SQ 2 Manual de usuario
Eureka
Eureka Tetragon 1610 Manual de usuario
