Ergotron Workfit Single LD Manual de usuario
WorkFit Single LD Monitor Kit
for WorkFit-T and WorkFit-PD
EDCBA
1
2
3
4
14mm
1x 2x
1x
M3 x 6mm
2x
M6 x 30mm
M4 x 10mm
4x
M4 x 7mm
4x
1x
M5 x 8mm
1x
1x
6x
1x
1x
4mm
3mm
2x M6 x 35mm
4x
4x
M6 x 25mm
ENGLISH
User’s Guide 1/8
0333 220 0375
TM
WARNING
Impact Hazard!
Moving Parts can Crush and Cut.
Raise monitor to top of vertical adjustment
BEFORE removing.
Failure to heed this warning may result in serious
personal injury or property damage!
822-635
ENGLISH
These symbols alert users of a safety condi-
tion that demands attention. All users should
be able to recognize and understand the
significance of the following Safety Hazards
if encountered on the product or within the
documentation. Children who are not able
to recognize and respond appropriately to
Safety Alerts should not use this product with-
out adult supervision!
Hazard Symbols
Review
Symbol Signal Word Level of Hazard
NOTE A NOTE indicates important information that helps you
make better use of this product.
CAUTION
A CAUTION indicates either potential damage to
hardware or loss of data and tells you how to avoid the
problem.
WARNING A WARNING indicates either potential for property dam-
age, personal injury, or death.
ELECTRICAL
An Electrical indicates an impending electrical hazard
and/or death.
Safety
Important! You will need to adjust this product after installation is complete. Make sure all your
equipment is properly installed on the product before attempting adjustments. This product should move
smoothly and easily through the full range of motion and stay where you set it. If movements are too
easy or difficult or if product does not stay in desired positions, follow the adjustment instructions to
create smooth and easy movements. Depending on your product and the adjustment, it may take many
turns to notice a difference.Any time equipment is added or removed from this product, resulting in a
change in the weight of the mounted load, you should repeat these adjustment steps to ensure safe and
optimum operation.
Warning: Impact Hazard! Moving Parts can Crush and Cut.
Raise worksurface to top of vertical adjustment BEFORE removing equipment.
Failure to heed this warning may result in serious personal injury and or property damage!
Warning: Impact Hazard! Moving Parts can Crush and Cut.
Raise monitor to top of vertical adjustment before removing.
User’s Guide 2/8
0333 220 0375
TM
6 - 16 lbs
(2.7-7.3 kg)
6 - 16 lbs
(2.7-7.3 kg)
< 5 lbs
(2.25 kg)
< 2 lbs
(0.9 kg)
< 5 lbs
(2.25 kg)
AA
BB
CC
A+B+C< 31 lbs (14 kg)
A+B+C< 28.4 lbs (12.88 kg)
5"
(127 mm)
20˚
10˚
WorkFit-PDWorkFit-T
ENGLISH
0333 220 0375
TM
User’s Guide 3/8
1
2x
M6 x 30mm
4mm
a
b
2x
M6 x 35mm
WorkFit-PD
1
a
c
b
WorkFit-T
4x
4x
M6 x 25mm
4mm
ENGLISH
User’s Guide 4/8
0333 220 0375
TM
2
0°
M3 x 6mm
1x
M4 x 10mm
M4 x 7mm
4x
4x
31x
M5 x 8mm
3mm
46x 2x
1x
ENGLISH
0333 220 0375
TM
User’s Guide 5/8
5
a
4mm
b
ENGLISH
Adjustment Step
Important! You will need to adjust this product after installation is complete. Make sure all your equipment is
properly installed on the product before attempting adjustments. This product should move smoothly and easily
through the full range of motion and stay where you set it. If movements are too easy or difficult or if product
does not stay in desired positions, follow the adjustment instructions to create smooth and easy movements.
Depending on your product and the adjustment, it may take many turns to notice a difference.Any time
equipment is added or removed from this product, resulting in a change in the weight of the mounted load, you
should repeat these adjustment steps to ensure safe and optimum operation.
Increase Lift Strength
If the mounted weight is too heavy or
this product does not stay up when
raised, then you'll need to increase
Lift Strength:
Decrease Lift Strength
If the mounted weight is too light or
this product does not stay down when
lowered, then you'll need to decrease
Lift Strength:
Increase Friction
If this product moves too easily, then
you'll need to increase friction:
Decrease Friction
If this product is too difficult to move,
then you'll need to decrease friction:
User’s Guide 6/8
0333 220 0375
TM
c1
2
14mm
1
2
ENGLISH
Increase Lift Strength
If the mounted weight is too heavy or
this product does not stay up when
raised, then you'll need to increase
Lift Strength:
Decrease Lift Strength
If the mounted weight is too light or
this product does not stay down when
lowered, then you'll need to decrease
Lift Strength:
WorkFit-PD only
0333 220 0375
TM
User’s Guide 7/8
ENGLISH
Learn more about ergonomic computer use at:
www.computingcomfort.org
Set Your Workstation to Work For YOU!
Height Position top of screen slightly below eye level.
Position keyboard at about elbow height with wrists flat.
Distance Position screen an arm's length from face—at least 20” (508mm).
Position keyboard close enough to create a 90˚angle in elbow.
Angle Tilt screen to eliminate glare.
Tilt the keyboard back 10° so that your wrists remain flat.
To Reduce Fatigue
Breathe - Breathe deeply through your nose.
Blink - Blink often to avoid dry eyes.
Break • 2 to 3 minutes every 20 minutes
• 15 to 20 minutes every 2 hours.
0333 220 0375
TM
User’s Guide 8/8
Tabla de contenidos
Otros manuales de Rack y soporte de Ergotron
Ergotron
Ergotron LX Desk Mount LCD Arm Manual de usuario
Ergotron
Ergotron StyleView Manual de usuario
Ergotron
Ergotron Grommet Kit Manual de usuario
Ergotron
Ergotron 97 815 Manual de usuario
Ergotron
Ergotron WorkFit Elevate 24-804-S894 Manual de usuario
Ergotron
Ergotron StyleView SV31 Manual de usuario
Ergotron
Ergotron LX Desk Mount LCD Arm Manual de usuario
Ergotron
Ergotron DS100 Series Manual de usuario
Ergotron
Ergotron MXV Manual de usuario
Ergotron
Ergotron Neo-Flex Series Manual de usuario
Ergotron
Ergotron Neo-Flex LCD Arm Manual de usuario
Ergotron
Ergotron LCD/Notebook Arm Guía de instalación
Ergotron
Ergotron Neo-Flex Wall Mount Lift Dimensiones
Ergotron
Ergotron Neo-Flex Laptop Cart Manual de usuario
Ergotron
Ergotron 45-295 Manual de usuario
Ergotron
Ergotron LX Manual de usuario
Ergotron
Ergotron Neo-Flex Mobile MediaCenter VHD Manual de usuario
Ergotron
Ergotron 97-718-009 Manual de usuario
Ergotron
Ergotron 888-33-332 Manual de usuario
Ergotron
Ergotron WorkFit-P Manual de usuario
