Ⓒ elero GmbH EN | 7
2 Safety
2.1 General safety instructions
The operating instructions contain all safety instructions
which must be observed in order to prevent dangers inher-
ent to handling the device in connection with the drives and
components to be controlled in the individual life cycles.
Safe use of the device can only be ensured if all given
safety instructions are observed.
2.2 Safety principles and general obligations of
the operator
The device is designed according to state of the art and
recognized safety standards and is safe to operate. In the
design process of the device, the basic health and safety
requirements of the applicable laws, standards, and directi-
ves were applied. The safety of the device is confi rmed by
the EC declaration of conformity.
Any information relating to safety are based on the currently
valid regulations of the European Union. In other countries,
it must be ensured by the operator that the applicable laws
and state regulations are followed.
In addition to the safety instructions in these operating inst-
ructions, the general regulations for accident prevention and
environmental protection must be observed and adhered to.
The device is to be used only in technically fl awless state
as well as in accordance with the requirements, conscious
of risk and in compliance with the operating instructions.
The device is designed for use as described in chapter
"Intended Use." In case of improper use, threats to life and
limb of the user or third parties or damage to the device
or other property may occur. Accidents or near accidents
when using the device, resulting, or potentially resulting, in
personal injury and/or damage to the environment, shall be
reported immediately to the manufacturers directly.
