Ei Electronics Ei166R Manual de usuario

Model Ei166R Optical

•Remote control capability

•Easi-Fit base

•Tamper proof rechargeable lithium battery back up

•High performance optical chamber with integral

insect screen

•Test/Hush button

•Advanced suppression and calibration technology

•Interconnectable to other Ei mains powered alarms

•Built in auto self test feature

•Low power cell warning

•Kitemarked to BS5446-1:2000

•5 year guarantee

Product Description

The Ei166R is an Optical Smoke Alarm that runs on

230V AC mains power, and has built in tamper proof

rechargeable lithium cells that act as a battery back up in

the event of mains failure. These rechargeable lithium

cells are designed to have a ten year life and outlast the

life of the smoke alarm itself, whilst providing up to six

months of smoke alarm operation without mains power.

The Ei166R is supplied with the Easi-Fit base that allows

very quick and simple installation of the smoke alarm,

combined with simple detector head removal and

replacement. The Easi-Fit base automatically connects

both mains power and battery as the detector head

slides on to the Easi-Fit base.

The Ei166R allows the detector to be controlled remotely

by either a “Test/Hush” Switch (Ei152), a “Locate” Switch

(Ei159) or a Manual Call Point (MCP400). If the Ei166R

is also interconnected to other Ei mains powered alarms

then the whole system can be controlled remotely.

The Ei166R has other advanced features such as

integral insect screens to reduce the chances of false

alarms, as well as the ability to interconnect up to twelve

alarms.

The Ei166R has built in circuitry to aid suppression of

voltage transients and RF interference to further reduce

the chances of false alarms under such conditions.

Operation

•The green indicator will illuminate to show mains

power is present

•The red indicator will flash every 40 seconds to

show that the detector has performed an automatic

self test

•The red indicator will flash rapidly to show an alarm

condition for the smoke detector

•The “Test/Hush” button will either silence false

alarms or perform a unit self test

•In “Test” mode the alarm will perform a self test and

sound the horn

•In “Hush” mode the alarm enters a ten minute period

of reduced sensitivity to overcome false alarm

conditions, and will then automatically reset itself

•When interconnected to other Ei mains powered

alarms, an alarm on one detector will trigger all other

interconnected alarms within one second (only the

triggered alarm will flash a red indicator)

•The smoke detector will emit a beep and flash the

red light every 40 seconds to indicate that the

battery back up is depleted and needs recharging

•

MAINS POWERED 230V~

Rechargeable Battery Back-Up

Shannon Free Zone, Shannon, Co. Clare, Ireland.

Ph.+353 61 471277 Fx.+353 61 471053

Email. [email protected]

www.eielectronics.com

Model Ei166R Optical

Installation & Placement

Wiring for Interconnected Alarms

Be very careful about correctly wiring the alarms as mixing Live and Neutral

will blow/damage interconnected alarms.

Alarms should be placed in accordance with the general guidelines shown in

the diagram above. These recommendations are based on the problem of

areas of “dead air” close to corners of rooms and apexes of ceilings, which

could result in the prevention of smoke reaching the smoke detector

Please consult instruction booklet for specific installation details

Important Precaution:

Do not install the actual smoke/heat alarm

itself in new or renovated buildings until all

work is completed (including floor

coverings) and the building has been fully

cleaned. The wiring can be installed when

appropriate. (Excessive dust and debris

from building work can contaminate the

smoke chamber and cause problems, and

it will also invalidate the guarantee). If it

must be installed, cover it completely,

particularly around the edges, with a dust

cover (eg. a plastic bag), until all cleaning

is finished.. Connect wires to the unit as in

wiring diagram. All wiring must comply

with local codes.

Technical Specification

Sensor Optical, uses light scatter from

smoke

Sensitivity: Complies with BS 5446 Part 1:

2000

Source: Contains no radioactive material

Airspeed: Essentially immune to the effect

of airspeed.

Button Test: Simulates the effect of smoke and

checks chamber, electronics and

horn.

Ambient Light: Chamber housing design and

compensation overcomes

problems with stray light.

Automatic Self-Test: Smoke Chamber is tested every 40

Sec. and unit beeps (without LED

flash) if it is degraded.

Insect Screen: Prevents insects or debris entering

chamber (1.00mm mesh size)

Supply Voltage: 240V AC

Battery back up: Rechargeable lithium cells

Specifications are subject to change

Power-On Indicator: Continuous green LED

Alarm: Electronic Piezoelectric horn

Alarm Sound Output: 85dB (minimum) at 3m

Alarm Status: Red LED flashes every second on

unit sensing fire

Temperature Range: 0 to 40°C

Humidity Range: 15% to 95% Relative Humidity

Remote Control: Ei152, Ei159 or MCP400

Interconnect: Up to 12 interconnected

EI140/141/143/144/145/146/161/1

64/166 smoke or heat alarms,

along with an EI128 relay base

Fixing: Easi-Fit mounting base

Plastic material: UL94VO flame retardant

Dimensions: 152mm diameter x 50mm depth

Weight: 385g

Warranty: 5 year (limited) warranty

Approvals: Kitemarked to BS5446-1:2000, CE

Approved

Shannon Free Zone, Shannon, Co. Clare, Ireland.

Ph.+353 61 471277 Fx.+353 61 471053

Email. [email protected]

www.eielectronics.com

Otros manuales de Detector de humo de Ei Electronics

Ei Electronics

Ei Electronics Ei141EK Manual de usuario

Ei Electronics

Ei Electronics Ei161e Manual de usuario

Ei Electronics

Ei Electronics Ei 175 Ionisation Manual de usuario

Ei Electronics

Ei Electronics Ei 176 Optical Manual de usuario

Ei Electronics

Ei Electronics Ei 3105TYCH Optical Manual de usuario

Ei Electronics

Ei Electronics EI 100L Emergency Light Manual de usuario

Ei Electronics

Ei Electronics Ei161RC Ionisation Manual de usuario

Ei Electronics

Ei Electronics Ei 169 Manual de usuario

Ei Electronics

Ei Electronics EI 103C Manual

Ei Electronics

Ei Electronics Ei141 Ionisation Manual de usuario

Ei Electronics

Ei Electronics EI 100S Silencer Manual de usuario

Ei Electronics

Ei Electronics Heat Alarm Ei 164R Heat Manual de usuario

Ei Electronics

Ei Electronics Ei175 Ionisation Manual de usuario

Ei Electronics

Ei Electronics Ei146 Optical Manual de usuario

Ei Electronics

Ei Electronics Ei 105C Optical Manual

Ei Electronics

Ei Electronics Ei 100B Ionisation Manual de instrucciones

Ei Electronics

Ei Electronics Ei127 Manual de usuario

Ei Electronics

Ei Electronics Ei100BNX Manual

Ei Electronics

Ei Electronics Ei 100TYC Ionisation Manual de usuario

Ei Electronics

Ei Electronics Ei3100RF? Ei3500RF Manual

Ei Electronics

Ei Electronics Ei603CRF Manual de usuario

Ei Electronics

Ei Electronics Ei Ei168RC Manual de usuario

Ei Electronics

Ei Electronics Ei 151TLR Ionisation Manual de usuario

Ei Electronics

Ei Electronics EI 170 Manual

Manuales populares de Detector de humo de otras marcas

x-sense

x-sense SD19-W Manual de usuario

BRK electronic

BRK electronic First Alert P1010 Manual de usuario

FireAngel

FireAngel Thermoptek ST-622 Manual de usuario

teko

teko Astra-42A Manual de usuario

Safetec

Safetec SDS-2/6 Manual del propietario

Siemens

Siemens PE-11C Manual de usuario

System Sensor

System Sensor DH500ACDC Manual de usuario

Resolution Products

Resolution Products RE612 CryptiX Manual de usuario

First Alert

First Alert PC900V Manual de usuario

Eminent

Eminent EM6590 E-Domotica Manual de usuario

Carrier

Carrier Kidde Quell Q301 Manual de usuario

VESDA

VESDA VLF-500 Manual de usuario

ELRO

ELRO FS8110 Manual de usuario

Heiman

Heiman SMOKI NS-626PHS Manual de usuario

Regin

Regin SDD-S65 Manual de usuario

Family Gard

Family Gard FG225 Manual de usuario

Greystone

Greystone DSD120 Manual de usuario

Aparton

Aparton ASD-10 Manual de usuario