
8
Prior to starting work Check
• the oil level. If necessary, rell oiler (line oiler or maintenance unit)
• if the drilling tool is rmly clamped to the drill chuck.
• if the pneumatic hose is correctly connected.
Start the machine by actuating the valve trigger 1 and start operation. (The speed can be adjusted
by opening the valve more or less, or by increasing, respectively lowering, the drill pressure.)
After nishing the work
• Shut the valve
• Shut compressed air supply and disconnect air hose.
• Dismount drilling tool, if necessary
• Check oiler
BASIC SAFETY INSTRUCTIONS
Read operation instructions/safety instructions!
Before working on or with the tool, read the safety instructions and follow the instructions during
operation.
Do not modify machine or machine tools and accessories after receipt. Permission from the
manufacturer must be obtained before any modications or alterations are done in compliance with
all safety instructions. Use the machine only for its intended use. Observe the technical data of the
equipment and the ambient temperatures. Pay attention to labels, restrictions of use and special
instruction notes on the machine tools and the machine itself. Regularly check that the type plate
and symbols on the machine are legible. If necessary, contact the manufacturer to replace them.
Only operators with technical knowledge, trained by authorized responsible technical personnel,
may install, adjust, operate, transport and store the machine.
OWNER OBLIGATIONS
Generally, the machine owner is responsible for correct condition/operation of the machine and
adherence to the safety regulations. The state-of-the-art machine is built according to recognized
technical safety regulations. However there is still a risk of accidents to the operator or third parties
or damage to the machine or other objects, when using it. All current regulations and specications
which apply to the site of operation in regards to accident prevention, installation of electrical and
mechanical systems as well as radio interference must be observed.
IMPORTANT - The owner must make sure that...
• Risk assessment is carried out for the specic risks, which can occur due to any operation of
the machine.