Eden WT-1000 Manual de usuario
WT-1000 Users Manual
High Power Bass Guitar Amplifier
Revised 3-28-03
Congratulations on your purchase of the Eden WT-1000 Bass Instrument Amplifier. You have
purchased what we feel is one of the finest bass amplifiers in the world. The WT-1000 produces
450 watts of pure power into 4 ohms (240 watts into 8 ohms) with min. 3db of dynamic headroom.
This compact, rack mountable package houses modular circuits made with superior components
and designed for years of trouble-free service.
Thank you for choosing Eden. Please take the time to review this manual and to send in your
warranty registration card.
CAUTION!
Your ears are your most important piece of equipment. Unfortunately, they
cannot be replacedas easily as your other gear. Please take the following
warning seriously.
This product, when used in combination with a sound source and loudspeakers
or headphones, may be capable of producing sound levels that could cause
permanent hearing loss. DO NOToperate at high volume levels or at a level that
is uncomfortable. DO NOT place your ears next to the speakers. If you
experience any discomfort or ringing in the ears or suspect hearing loss, you
should consult a health care professional.
Please complete for your records:
Date of Purchase: __________________________
Model: ___________________________________
Serial Number: _____________________________
Dealer: ___________________________________
General Specifications
Size 3.5” x 19” x 14”
Weight 28 Lbs.
EIA rack 2 Space w/ min. clearance
Power Output @ 8 ohm x 2 240 Watts RMS
Headroom +3dB min.
Damping Factor better than 100 from 20Hz to 1Khz
Slew Rate 128V/8us
Rise time 11us
Frequency Response 13Hz to 36KHz +/-3dB
Distortion THD .06 %
Power Requirements
The WT-1000 needs a separate properly grounded 20 Amp circuit @ 120
Volts for correct operation and best sound quality. FOR YOUR SAFETY
DO NOT REMOVE OR MODIFEY THE GROUND ON YOUR POWER
CABLE.
Fuse Requirements
USA @ 120 Volts /60 HZ (12) Amps, 5 x 20 mm GMC/T/slow blow
Europe @ 240 Volts/50 Hz (6) Amps, 5 x 20 mm GMC/T/slow blow
Japan @ 100 Volts/60 Hz (14) Amps, 5 x 20 mm GMC/T/slow blow
Operation and power requirements
For best electrical operation and sound quality this unit should have a
properly grounded, dedicated 20 Amp circuit for itself.
Front Panel Features
The WT-1000 has several unique features. Each channel is equipped with a
volume control, tone shift control, and an output limit level indicator.
Volume Control
This control sets the level of signal going to the amplifier output stage. The
further the control is turned to the right the less signal is required to drive the
amplifier to full output.
Tone Balance control
The tone balance allows the player to adjust the entire audio spectrum with
one simple control. The tone balance is a teeter totter type control. When the
Bass is turned up the level goes up in the bass ,shifts back to neutral across
the midrange and shifts lower in the treble ranges. The opposite happens
when the treble control side is turned up.
This control is very useful in rooms with unusual or bad acoustic
characteristics. For example in a room that is very dead or over damped ,
raising the treble level will allow the Bass to cut though better. If the room
has too much bass the same solution will be helpful. In a very live or
reverberant room turning down the treble will mellow out the Bass tone
quickly without upsetting your normal tone control settings.
Limit LED
This LED displays the amplifier maximum output condition and lets you
know that the amplifier has reached full output. It’s fine for the LED to blink
often at high power operation . It should not however remain lit
continuously. This LED also indicates that the internal limiter is engaging.
Signal path switching ( Stereo, Dual Mono, Mono Bridged)
The WT-1000 has the input signal path switching on the front panel along
with indicator LEDs. This allows for an easy set up of the signal routing and
a highly visible display of the operating choices.
You can select Dual Mono (both channels see the same input), True Stereo
(each channel has its own input left and right), or Mono Bridged ( both
channels combine into one big channel and produce twice the power output).
You can operate in Bridged Mono @ either 8 ohms or 4 Ohms with this unit.
Channel Output Indicator
This LED indicates that the amplifier channel has reached maximum output
and is going into limiting.
On / Off Switch
This turns the unit on and off .
Front Panel Air Intake
Do not obstruct the airflow to this intake.
Back Panel Features
Inputs ( Balanced & Unbalanced)
The inputs are configured as a Balanced/unbalanced TRS ( Tip, ring, sleeve
¼” jack ) and a 3 pin XLR balanced Mic. Connector. These are wired in
parallel without buffers.
Signal outputs
These are provided by TRS ¼” jacks with buffers (150 Ohms). Use these for
linking to other amplifiers etc.
Main Power Amplifier Outputs
NOTE** Be careful with these connection points, this is a big amplifier. It
can produce a lot of output voltage. It is possible to get a shock from any
large audio amplifier under certain conditions.
The WT-1000 is provided with the following connections , 2 of the ¼”
phone plug, 5 way binding post, and NL4 connectors.
AC Inletand Fuse Holder
Your unit is fitted with an IEC interface for universal AC cable connection.
The fuse is selected for the country of operation (see list at front of manual).
Replace the fuse ONLY with the same type and size as the original.
Airflow Exit
Do Not Block This Exit. If the airflow exit becomes obstructed the amplifier
will over heat and go into thermal limiting. The unit should be cleaned and
serviced about once a year by a qualified technician.
Factory Service
If you need service, encounter a problem or have questions about your
amplifier please contact us @ Customer Service (847-949-0444) Monday
through Friday.
Eden Electronics
Division of US Music
444 E Courtland Rd.
Mundelein , IL 60060
847-949-0444
847-949-8444(fax)
Please Ship Authorized returns for service to :
Eden Electronics
115 Second St.
Montrose, MN 55363
763-675-1890
763-675-3777 (fax)
Email @
eden@eden-electronics.com
Web Sight @
http://www.eden-electronics.com
Tabla de contenidos
Otros manuales de Amplificador de Eden
Eden
Eden E300 NEVER COMPROMISE Manual de usuario
Eden
Eden Nemesis N8 Manual de usuario
Eden
Eden EX410 Manual de usuario
Eden
Eden Nemesis RS Series Combos Manual de usuario
Eden
Eden Navigator WP-100 Manual de usuario
Eden
Eden NEMESIS NA-600 Manual de usuario
Eden
Eden ENX-260 Manual de usuario
Eden
Eden WT-405 Time Traveler Manual de usuario
Eden
Eden WTB-300 Manual de usuario
Eden
Eden WTX-264 Manual de usuario
Eden
Eden World Tour WTX1000N Powered Navigator Manual de usuario
Eden
Eden Nemesis NA650 Manual de usuario
Eden
Eden WTX-500 Manual de usuario
Eden
Eden Solo CXC-300 Manual de usuario
Eden
Eden NEMESIS NC-200A Manual de usuario
Eden
Eden EM25 METROMIX SERIES Manual de usuario
Eden
Eden METRO DC-210XLT Combo Manual de usuario
Eden
Eden EC8 Manual de usuario
Eden
Eden Valvetech VT-300A Manual de usuario
Eden
Eden EM25 METROMIX SERIES Manual de usuario
