Edelbrock 63-0181 Manual de usuario

Catalog #70014 & 70015

Brochure # 63-0181

Rev. 6/08 Page 1 of 2

Component Installation

1. Install your new Victor Jr. Nitrous Plate (Item A) onto the carburetor pad using the 4 supplied Carburetor Studs (Item B) and 2

supplied Gaskets (Item C).

2. Install the correct jets (Item D), selected from the chart below, into their corresponding jet holders on the plate. Be sure you

install the selected fuel jet into the fuel fitting and the correct nitrous jet into the nitrous fitting. Failure to install

the jets correctly may result in catastrophic engine damage.

3. Install the 4AN x 1/8”NPT Tee’s (Item E) into the outlet port of your solenoids using Teflon Paste. Be sure to use the red fittings

for the fuel solenoids and blue fittings for the nitrous solenoids to make line identification easier for future tuning or use.

4. Install the Blue Nitrous Lines (Item F) from the nitrous jet holders to the blue outlet tee from the solenoid. Repeat this step for

the Red Fuel Lines.

Victor Jr. Plate Kits

Catalog #70014 & 70015

INSTALLATION INSTRUCTIONS

Please study all instructions carefully before you install your new Victor Jr. Plate Kit. If you have any questions, please call our

Technical Hotline at: 1-800-416-8628, 7:00 a.m. to 5:00 p.m., Monday through Friday, Pacific Standard Time or e-mail us at

[email protected].

DESCRIPTION: This kit is an upgrade to your existing system or a replacement for your current plate system. Some additional

components may be required for a complete installation. You must currently have 2 nitrous solenoids and 2 fuel solenoids of the

same style for this system to operate correctly. You also must currently have the bottle, feed lines, solenoid inlet fittings, and any

other components that may be required for a complete system. The Victor Jr. Nitrous Plate was dyno tested and proven using

only Edelbrock components. The dyno testing and jet map are based upon using 2 Performer RPM nitrous solenoids, 2 Performer

RPM Fuel Solenoids, -6AN feed line, and -6AN lines from the feed line to the solenoid inlets. Any variations from this configuration

may change the jet map curve. Tune your nitrous system accordingly.

IMPORTANT NOTE:

Proper installation is the responsibility of the installer. Improper installation will void warranty and may result in

poor performance and engine or vehicle damage.

Catalog #70014 & 70015

Brochure # 63-0181

Rev. 6/08 Page 2 of 2

Edelbrock Corporation, 2700 California Street, Torrance, CA 90503

Tech Line: (800) 416-8628, Office: (310) 781-2222

Tech Fax: (310) 972-2730

Tech E-Mail: [email protected]

JET MAP INFORMATION

Edelbrock engineering has conducted dyno testing with the Victor Jr. system to provide jetting maps for two separate plates at

different jetting levels. These jet combinations are supplied with this system to enable you to vary your engine’s power output.

DOMINATOR-FLANGE JET MAP

SQUARE-FLANGE JET MAP

NOTES: All of the jet maps shown on this page were developed using a steady fuel pressure of 6.5 psi. Variations in fuel pressure

can create a rich or lean condition which could potentially damage the engine. All jet maps shown on this page require 110 Octane

or better race gas to prevent detonation. The provided timing adjustments represent a suggested guideline only, various engine

components will affect the ideal ignition point. Edelbrock recommends an NGK spark plug 2 heat ranges colder than what the engine

would run naturally aspirated for use with all power levels shown on this page. When in doubt, always go to the next cooler heat

range plug.

The dyno tests were conducted at Edelbrock using a highly modified Big Block Chevrolet. Modifications included Edelbrock intake

manifold, cylinder heads dyno headers, pistons, rods, crankshaft, and improved ignition. These tests were conducted with 950 psi

nitrous and 6.5 psi fuel pressure. All stated timing adjustments listed in the jet map is where the motor being tested worked best.

Final timing should be adjusted to achieve best power and/or MPH per application.

See section “5.0 Ignition Timing and Nitrous” for

more information on timing selection.

Any variations in jetting patterns other than what is listed above and engine damage could occur. Please contact Edelbrock Technical

Department with any questions you have concerning jetting patterns and their effects on engine performance.

Edelbrock recommends an NGK spark plug with a heat range between -9 and -11, depending on the power level being used. When

in doubt, always go to the next cooler heat range.

The Victor Jr. Series Nitrous Systems are intended for single-plane manifolds only.

Do not use a dual-plane manifold

with the Victor Jr. Series Nitrous Systems. In testing, we found that dual-plane manifolds have some distribution problems at these

super high flow rates that could cause serious engine damage.

Approximate HP Gain Nitrous Jet Fuel Jet Timing Adjustment

200 35 35 7°-9° retard

300 50 50 11°-13° retard

400 59 59 15°-17° retard

Approximate HP Gain Nitrous Jet Fuel Jet Timing Adjustment

200 35 35 7°-9° retard

300 48 48 11°-13° retard

400 57 57 15°-17° retard

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Pieza de automóvil de Edelbrock

Edelbrock

Edelbrock 5791 Manual de usuario

Edelbrock

Edelbrock THUNDER SERIES AVS 1803 Manual de usuario

Edelbrock

Edelbrock 3638 Manual de usuario

Edelbrock

Edelbrock 15016 Manual de usuario

Edelbrock

Edelbrock 17930 Manual de usuario

Edelbrock

Edelbrock 5652 Manual de usuario

Edelbrock

Edelbrock Victor Jr. 70057 Manual de usuario

Edelbrock

Edelbrock Qwikdata 91195 Manual de usuario

Edelbrock

Edelbrock Russell 207-2 Manual

Edelbrock

Edelbrock 2161 Manual de usuario

Edelbrock

Edelbrock 4771 Manual de usuario

Edelbrock

Edelbrock Chevrolet 1500-6500 Manual de usuario

Edelbrock

Edelbrock 68782 Manual de usuario

Edelbrock

Edelbrock 70402 Manual de usuario

Edelbrock

Edelbrock Predator Carburetor Manual del propietario

Edelbrock

Edelbrock 5210 Manual de usuario

Edelbrock

Edelbrock 9629 Manual de usuario

Edelbrock

Edelbrock 3842 Manual de usuario

Edelbrock

Edelbrock 5280 Manual de usuario

Edelbrock

Edelbrock 3824 Manual de usuario

Edelbrock

Edelbrock 5262 Manual de usuario

Edelbrock

Edelbrock Performer 1403 Manual de usuario

Edelbrock

Edelbrock 5735 Manual de usuario

Edelbrock

Edelbrock 5756 Manual de usuario

Manuales populares de Pieza de automóvil de otras marcas

Dakota Digital

Dakota Digital 650277 Manual de usuario

bosal

bosal 037031 Manual de usuario

Vintage Air

Vintage Air 571063 Manual de usuario

GFB

GFB EX38 Manual de usuario

bosal

bosal 028091 Manual de usuario

Dodge

Dodge 8W-43 Guía de inicio rápido

ICI

ICI Magnum FBM10DGN Manual de usuario

Volant Perfomance

Volant Perfomance 19435 Manual de usuario

BENDIX

BENDIX GEN 4 GEN 5 ABS Manual de usuario

Vintage Air

Vintage Air 571065 Manual de usuario

Rugged Ridge

Rugged Ridge 11503.13 Manual de usuario

BENDIX

BENDIX CYCLONE DURADRAIN TRAILER WATER Manual de usuario

Porsche

Porsche 968 - ASSEMBLY INSPECTION PROCEDURE AND MAINTENANCE... Guía

Sumitomo

Sumitomo FINE CYCLO FC-A 15 G Manual de usuario

Toshiba

Toshiba 48-1250 A Manual de usuario

aldes

aldes EHT2 Manual de usuario

Go Rhino

Go Rhino 24371T Manual de usuario

BBK

BBK 18950 Manual de usuario