Eddy Wireless EDW-310BB Manual de usuario
GPS Vehicle Tracker EDW-310BB
USER MANUAL
ZY INTERNATIONAL LIMITED GPSTrackerVT310BBManual
1.Introduction........................................................................................3
2. EDW-310BB overview .5
3. Specification .. 12
4. Function .. ..15
5. Get start .. ..18
6. Trouble shoot .21
7. More SMS command .23
1.Introduction
EDW-310BB which come in a compact design is a powerful real time
fleet management and vehicle tracking system using high sensitivity
GPS and wireless GSM/GPRS communication. This self-contained and
autonomous tracking device including GSM module, GPS receiver, Li-
ion battery and Multi analog input is able to be used as observing the
location of vehicle ,detecting temperature ,detecting fuel costing.
Figure 1. EDW-310BB appearance
2.EDW-310BB overview
2.1 EDW-310BB unit
EDW-310BB is designed in a compact and simple rugged
Aluminum enclosure. At the end of the unit ,there are 2 LED
indicators shows the status of the unit. And various ports for
vehicle interface, USB interface, external GSM/GPRS antenna
connector ,external GPS antenna connector are on both side of
the device.
No. Name
1 Connect 1
2 Connect 2
3 External GSM antenna connect port
4 External GPS antenna connect port
5 External Micro phone connect port
6 GSM status indicator
7 GPS status indicator
2.2 LED indicators
Logo LED name Description
M GSM/GPRS status
indicator Green LED on: GSM/GPRS connection
status
Green LED blinking: Boot completion
status
Green LED off: Idle status
S GPS status indicator Orange LED on: GPS position fixed
Orange LED blinking: During GPS signal
reception
2.3 Connect 1
Please refer to the following table to understand the function
of each pin at UART port.
Pin
Number
Description
A Configuration Serial port RXD1
(only for update)
B Digital input 3 IN3,which is negative
trigger
C GND
D Configuration Serial port TXD1
(only for update)
A
C
B
D
2.5 Connect 2
Please refer to the following table to understand the
function of each pin at Connect 3.
Pin
Number
Description
1 Digital input 1,also used as
SOS input *
2 Digital input2 *
3 Digital input 4**
4 Digital input 5**
5 GND
6 Analog input 1
7 Analog input 2
8 Power
9 Digital output1
10 Digital output2
11 Digital output3
12 Digital output4
Remark
*: Digital input 1,Digital input2,Digital input 3 is negative trigger
**:Digital input 4,Digital input 5 is positive trigger
2.6 External GSM/GPRS antenna
EDW-310BB has the quad-band GSM/GPRS antenna
according to the supported bandwidth in users areas.
2.7 External GPS antenna
EDW-310BB has an external GPS antenna.
2.8 Package contents
The basic package is including EDW-310BB,GPS antenna,
1
2
3
4
5
6
7
8
9
1
0
1
1
1
2
GSM/GPRS antenna, cables. The optional accessory
including :Hand-free kit, Mobile data terminal, CCD camera,
RFID reader, temperature sensor, tank fuel level sensor. For
more details about optional accessory ,please refer to “GPS
AVL Accessory Guide V2[1].0”
3Specification
3.1 Software Features
SMS mode/GPRS mode/SMS+GPRS mode
Position request via SMS or GPRS
Data logging capacity: up to max 144,000 point
Store in GSM blind area and forward when GSM signal
re-establish
Mileage report
Upload/download settings, locations, and update firmware via
GPRS
Configurable GEO-fencing
Configurable 2 analog input for status detection
Configurable 5 digital input for status detection
Configurable 5 digital output for remote control of vehicle
3.2 Hardware Features
GSM/GPRS core
Simcom:SIM300D:900/1800/1900MHz
Simcom:SIM340D:850/900/1800/1900MHz
GSM/GPRS services: Data, SMS/GPRS class B,class 10,TCP
UDP,IP
Physical characteristics
Dimensions(L*W*H): 104*73*29.8mm
Weight:approx:160g(including build-in battery)
Temperature range
Operation:-20 Celsius degree to +80 Celsius degree
Power sources
Input voltage:10~32 Volt DC regulated/Max 2A
Rechargeable Li-ion battery 1800mAh
Antenna
External GSM/GPRS antenna
GPS antenna
Indication:2 LED indicator for GSM/GPRS and GPS status
3.3 Technical specification
GSM/GPRS specification
Frequency
Bands Simcom 300D:900/1800/1900Mhz
Simcom 340D:
850/900/1800/1900Mhz
GSM class Small MS
Transmit
power Class 4(2w) at EGSM900 and GSM850
Class 1(1W) at DCS1800 and PCS 1900
GPRS
connectivity GPRS multi-slot class 10
GPRS mobile station class B
Data GPRS Data up/downlink transfer:
Max.85.6/42.8kbps
Coding scheme:cs-1,cs-2,cs-3 and cs-4
Supports the protocols PAP and CHAP commonly
used for PPP connections
Data CSD CSD transmission rates:2.4,4.8,9.6,14.4 kbps
SMS SMS,MT,MO,CB,Text and PDU mode
Support transmission of SMS alternatively over
CSD or GPRS
User can choose preferred mode
TCP/IP stack Internet
services:TCP,UDP,HTTP,FTP,SMTP,POP3
FAX Group 3:Class 1,Class 2
SIM Supported SIM card:3V
GPS module specification
Receive Frequency 1.57542Ghz +/-1.023MhzGeneral GPS datum WGS-84
Acquisition Rate Conventional mode
Cold/warm/hot start<
42/38/1 sec (95% typical)
Accuracy Position:10 meters CEP without SA
Velcocity:0.1meters/s,without SA
Time: 1ms sync to GPS time
SIRF star III chipset
Channel 24 channel GPS
4. Function
EDW-310BB is able to be powered from 10V to
32V DC. The VIN,GND and ignition line of the vehicle
port should be connected with the vehicle to use car
management. The VIN line should be connected to
+12V or +24V DC of vehicle parts using 2A fuse, for
example the vehicle battery. And also ,the SIM card
capable of GSM/GPRS should be inserted before connect
with power. After completing the connection, the user
should change the configuration for its network operator
and user s environment.
EDW-310BB receives GPS data via GPS antenna after
fixing GPS signal. And then the device sends the location
data to control center according to its configuration
which is able to be set by control center or user s SIM.
4.1 Communication function
EDW-310BB is able to be communicated by GSM and
GPRS network using SMS and GPRS packet. The device
can support both GSM and GPRS network, but the
control center software is able to be distinguished by the
application of SMS and IP packet.
Following communication mode is supported:
- SMS only mode:
When the control center does not have
internet connection, it can be communicated with the
device via SMS. To conduct it, the control center
should connect with GSM modem.
- GPRS only mode:
When the control center have internet connection,
the device is communicated with the control center
via GPRS packet at time interval. The time interval
can be preset by customer thru GPRS/SMS/UART
configuration cable.
- SMS and GPRS mode
When the control center connect with GSM modem
and internet ,the control center communicates with
the device through both GPRS packet and SMS at
time interval. The time interval can be preset by
customer thru GPRS/SMS/UART config cable.
4.2 Alarm function
EDW-310BB send alarm SMS/GPRS package to the
predefined SMS number/IP address. The alarm package
is able to be activated for following functions:
Journey start/end alarm
Over speed alarm
Panic alarm
Towing alarm
Geo-fence alarm
Alarm may also preset by customer, such as
over temperature alarm and tank fuel change alarm.
For more info about how to use alarm, please
refer to GPRS communication protocol.
4.3 Data logging and forward function
EDW-310BB can save data, including position data,
the data from sensor such as temperature sensor when
enter GPRS blind area and forward the data when GPRS
re-establish.
For more info about how to use the data logging
and forward function, please refer to GPRS
communication protocol
Tabla de contenidos
Otros manuales de GPS de Eddy Wireless
