3
W: EchomasterEurope.co.uk
T: +44(0)1420 487110
SIDE ALERT SENSORS I SA-US4 User Manual
Fitting Instructions
Recommended Tools for Installation
u High torque drill.
Use on Slow Speed (approx 400 rpm)
u Marker Pen for marking holes prior to drilling
u 1/8” carbide tipped drill bit for starting pilot hole
u Hole Saw 24mm (included)
u Pliers, Crimpers & Soldering Iron
u Multi-Meter
u Zinc galvaniser or a rust inhibitor for metal
u Safety goggles
Optional Tools
u Panel tool (for situations requiring
plastic, inner panels to be removed)
u Phillips screwdriver
u Wire pulling tool (for routing wires)
u Semi-circular metal le (for smoothing
hole edges when necessary)
DO NOT use ngers to test holes
for burrs or smoothness.
PLEASE NOTE
For vehicles with metal panels, it is recommended to install with rubber sleeves using the 24mm hole saw
provided. If installing without the rubber sleeves, use a 22mm hole saw, which is not included.
Determining Sensor Position: Measure Twice, Cut Once!
Inspect behind the panel in the approximate mounting area to check for any possible
obstructions.
A proper installation will take into consideration two factors:
(1) Placement: height and distance.
(2) Angle: accurate detection depends on the correct sensor angle.
Each sensor head requires a 50mm clearance space behind the panel to be completely inserted.
Some areas have an outside cover or fascia and a metal backing. You may have to drill through
both layers to ensure you have enough clearance in order to t the sensors.
PLEASE NOTE
When routing cables be careful of hot engine parts and/or sharp edges under vehicle.
uDip switch settings for detection zone
distance and warning adjustment
uVisual & audible in cab warnings
uActivation upon turn signal
uConcentrated warning zone when brake
pedal is depressed
uLow prole, paintable sensors
uFlush mount or underslung tment
uDaisy chained sensor heads
uWide detection angle with minimal
blind area
uTriangulation technology
uOE sounding buzzer
