Dymo 1570 Manual de usuario

DYMO 1570

Adjusting Space on Label Ends

For more blank spaces before and after messages: Turn the tape feeder (B) .

For less blank spaces: Turn the tape feeder (B) in reverse, emboss the message, turn feeder

forward, and cut.

To center a message: Advance completed label 3 spaces (5 space for 1530 Office Mate I)

Squeeze tape cutter.

Troubleshooting

Label shows letters instead of blank space: Squeeze handle half way until you hear a click,

then release.

Letters too light: Squeeze harder by holding the upper end of the handle.

Tape jam: In the unlikely event the tape does not feed properly, remove the tape wheel, discard

left over tape ends, and replace the wheel.

Preparing Problem Surfaces

Use non-residual solvents (i.e., alcohol, acetone) to clean oily or greasy surfaces. If the surface is

rough or porous, coat it with a sealer (i.e. shellac, lacquer). Once stuck, water will not affect the

label. Do not apply labels to surfaces exceeding 140 F.

1. Load Tape

Expose 3" of the tape, open the tape compartment (A), and insert so that ‘U’ shape opening in the

tape cartridge points down. Insert the tape into the feed slot and thread forward until visible.

Close the tape compartment to lock in the tape.

2. Advance Tape

By turning the feeder (B) or with several half-squeezes (squeeze until click sound is audible) of

the handle (F), advance the tape 1/4" past front of embosser.

3. Emboss Letters

Turn the wheel (E) until the desired letter aligns with selector. Squeeze the handle (F) firmly and

repeat for each letter. To space between words, half-squeeze handle until click is heard.

DO NOT HOLD WHEEL WHILE EMBOSSING.

4. Cut Tape

Squeeze the cutter (C) and remove excess tape from the end of the embosser.

5. Apply Label

Pull the end of the tab to strip the backing. Apply tape to a clean dry surface.

6. Change Wheel

Push wheel right to left and remove. Snap in the new wheel.

DO NOT SQUEEZE HANDLE WHILE CHANGING WHEEL.

Tabla de contenidos

Otros manuales de Etiquetadora de Dymo

Dymo

Dymo ILP 219 Manual de usuario

Dymo

Dymo LabelManager 500TS Guía de instalación

Dymo

Dymo RhinoPRO 1000 Manual de usuario

Dymo

Dymo Rhino 3000 Industrial Label Printer Manual de usuario

Dymo

Dymo LabelMANAGER 150 Manual de usuario

Dymo

Dymo Rhino 1000 Manual de usuario

Dymo

Dymo LabelManager 300 Manual de usuario

Dymo

Dymo RHINO 6000 Manual de usuario

Dymo

Dymo RhinoPRO 1000 Manual de usuario

Dymo

Dymo LM 100 Manual de usuario

Dymo

Dymo 2000 Manual de usuario

Dymo

Dymo PL100 Manual de usuario

Dymo

Dymo LW 450 Manual de usuario

Dymo

Dymo LabelManager 400 Manual de usuario

Dymo

Dymo LabelWriter 300 Manual de usuario

Dymo

Dymo COLORPOP Manual de usuario

Dymo

Dymo LabelManager 220P Manual de usuario

Dymo

Dymo LabelManager 450D Manual de usuario

Dymo

Dymo Rhino 3000 Industrial Label Printer Manual de usuario

Dymo

Dymo M1011 Manual de usuario

Dymo

Dymo Rhino 5200 Manual de usuario

Dymo

Dymo LabelWriter 4XL Label Printer Manual de usuario

Dymo

Dymo LabelPOINT 100 Manual de usuario

Dymo

Dymo M1011 Manual de usuario

Manuales populares de Etiquetadora de otras marcas

Brother

Brother P-Touch 2420PC Manual de usuario

newell

newell Dymo LabelManager 210D Manual de usuario

Brother

Brother TD-4000 Manual de usuario

U-Line

U-Line BROTHER H-8754 Manual de usuario

Tharo Systems

Tharo Systems H-435+ Manual de usuario

Brother

Brother E300 Manual de usuario

Godex

Godex RT700 SERIES Manual de usuario

ID Technology

ID Technology 252 Manual de usuario

Labelmate

Labelmate MC-11 Manual de usuario

CAB

CAB XD4M/300 Manual de usuario

Avery Dennison

Avery Dennison Pathfinder 6057 Manual de servicio

Brother

Brother P-touch PT-9700PC Manual de usuario

TSC

TSC PEX1000 Series Manual de usuario

Adkins

Adkins Label Master Manual de usuario

Epson

Epson LabelWorks LW-400 Manual de usuario

Primera

Primera 510212 Manual de usuario

Brady

Brady BradyPrinter S3100 Manual de usuario

DuraLabel

DuraLabel LabPRO Manual de usuario