Dwyer Instruments HT Series Manual de usuario

BULLETIN E-90-HT

SERIES HT RH/Temperature Transmitter

Specifications – Installation and Operating Instructions

DWYER INSTRUMENTS, INC.

Phone: 219/879-8000 www.dwyer-inst.com

P.O. BOX 373 • MICHIGAN CITY, INDIANA 46361, ,U.S.A. Fax: 219/872-9057 e-mail: info@dwyer-inst.com

Lit-By Fax: 888/891-4963

DESCRIPTION

Monitor and control relative humidity and temperature in

building energy management systems with the Series HT

Humidity Temperature Transmitter. Designed for demanding

HVAC/EMCS applications, the Series HT provides ±3% RH

accuracy and ±1% stability per year. Routine calibration is

not required with the fully interchangeable sensor. Two-wire

connections allow easy installation directly into air ducts or

within a controlled area.

INSTALLATION

Mounting

The duct mount models must be mounted as described

below:

1. Drill four 1/8(3.2 mm) diameter holes for the mounting

screws in the locations shown in Figure 1.

2. Cut a 0.866(22 mm) diameter hole in the duct for the

sensor in the location shown in Figure 1.

3. Attach the duct mounting bracket to the duct with the

four screws provided.

4. Slide the sensor/transmitter assembly through the

center hole in the mounting bracket and secure into

place by tightening the screw located on the side of the

raised square portion of the mounting bracket.

Reminder: Remove the yellow sensor protection cap

beforeinstalling the sensor into your duct.

PHYSICAL DATA

Relative Humidity Range: 10 to 90% RH.

Temperature Range: Duct mount: -40 to 140˚F (-40 to 60˚C), wall

mount: 23 to 131˚F (-5 to 55˚C).

Accuracy: ±3% RH @ 25˚C; ±0.3˚C @ 25˚C.

Stability: ±2% RH over 2 years.

RH Temperature Dependence: <±1.5% RH from 14 to 140˚ (-10

to 60˚C).

Temperature Dependence: 0.01˚C/˚C.

Temperature Sensor: Pt 1000ΩRTD.

Response Time: 15 seconds.

Output Signal: 4 to 20 mA.

Supply Voltage: 10 to 28 VDC.

Current Consumption: 4 mA minimum.

Operating Humidity Range: Duct mount: 0 to 100%, wall mount:

0 to 90%.

Operating Temperature Range: Duct mount: 14 to 140˚F (-10 to

60˚C), wall mount: 23 to 131˚F (-5 to 55˚C).

Storage Temperature Range: -40 to 140˚F (-40 to 60˚C).

Conduit Connection:

 NPT.

Mounting Connection:

 NPT.

Housing Material: ABS plastic.

Enclosure: Duct mount only/IP65.

Weight: 0.6 lb (0.3 kg).

3-5/32

[80.17]

3-5/32

[80.17]

1-1/2

[38.10]

19/32 DIA.

[15.09]

15/32 DIA.

[11.91]

11-5/8 [295.3]

8-1/2 [215.9] 2-1/8

[53.98]

SERIES HT RH/TEMPERATURE TRANSMITTERS

*Wall mount not shown

Model Description

Number

HT00* Humidity Transmitter, wall mount

HT01 Humidity Transmitter, duct mount

HT10* Humidity/Temp Transmitter, wall mount

HT11 Humidity/Temp Transmitter, duct mount

Accessories

No. HT5, Replacement Humidity Sensor

No. HT6, Replacement Pt1000ΩRTD

1.65

[42]

1.65

[42]

Ø 0.866 [22] min

Ø.125 [3.2]

Tapping Screw

DIN 7981

FIGURE 1: Drilling Dimensions for Duct Mount Units

*Duct Mount unit shown.

REPLACEMENT SENSORS

Series HT Temperature/Humidity Transmitters incorporate

fully interchangeable humidity and temperature sensors.

These transmitters do not require recalibration when the

sensor is changed.

In duct mount models, the sensors are located beneath the

filter membrane in the tip of the duct probe. Simply

unscrew the filter membrane and remove the sensor.

In wall mount models, the sensors are located on the circuit

board. Gently unsnap the light gray front casing from the

back portion of the housing and replace the sensor.

MAINTENANCE/REPAIR

No routine maintenance is required on the Series HT

RH/Temperature Transmitter. These units are not field

repairable and should be returned to the factory if service is

required. After first obtaining a Returned Goods

Authorization (RGA) number, send the unit, freight prepaid

to the following address. Please include a clear description

of the problem plus any application information available.

Dwyer Instruments, INC.

Attn: Repair Department

102 Indiana Highway 212

Michigan City, IN 46360

DWYER INSTRUMENTS, INC.

Phone: 219/879-8000 www.dwyer-inst.com

P.O. BOX 373 • MICHIGAN CITY, INDIANA 46361, ,U.S.A. Fax: 219/872-9057 e-mail: info@dwyer-inst.com

Lit-By Fax: 888/891-4963

+RH

-RH

POWER

SUPPLY

10...28VDC

4-20mA

-T

POWER

SUPPLY

10...28VDC

4-20mA

+RH

-RH

POWER

SUPPLY

10...28VDC

4-20mA

Figure 2: Wiring Diagram for HT00 & HT01

Figure 3: Wiring Diagram for HT10 & HT11

Wire the humidity and temperature transmitters models

HT01 and HT11 as shown in Figure 3.

Installing the Cable Seal (Duct mount units only)

Included with the duct mount models HT01 and HT11 is a

rubber cable seal. This seal helps provide a dust and water

tight housing and ensures environmental protection per

IP65. Install the cable seal as described below:

1. Press the rubber seal into the conduit hole located on

the side of the housing.

2. Pierce the center of the seal with a cable or a

screwdriver.

3. Pull the cable through the hole in the center of the seal.

Designed for cable diameters 7...10 mm.

Electrical Connections

The Series HT RH/Humidity Transmitter is a true 2-wire, 4-

20 mA current output device. Electrical connections are

made to screw terminals located beneath the light gray

front casing. For duct mount units, remove the 4 screws

located on the front face of the housing. For wall mount

units, gently unsnap the light gray front casing from the

back portion of the housing.

Wire the humidity transmitters models HT00 and HT01 as

shown in Figure 2.

Este manual sirve para los siguientes modelos

Otros manuales de Transmisor de Dwyer Instruments

Dwyer Instruments

Dwyer Instruments 626 Series Manual de usuario

Dwyer Instruments

Dwyer Instruments PROXIMITY Series Manual de usuario

Dwyer Instruments

Dwyer Instruments Series 616 Manual de usuario

Dwyer Instruments

Dwyer Instruments One-Touch 616OT Series Manual de usuario

Dwyer Instruments

Dwyer Instruments CMT200 Manual de usuario

Dwyer Instruments

Dwyer Instruments 607 Series Instrucciones de instalación y funcionamiento

Dwyer Instruments

Dwyer Instruments Magnesense II MS2-X102 Manual de usuario

Dwyer Instruments

Dwyer Instruments 629C series Instrucciones de instalación y funcionamiento

Dwyer Instruments

Dwyer Instruments 650 Series Instrucciones de instalación y funcionamiento

Dwyer Instruments

Dwyer Instruments 3400 Series Instrucciones de instalación y funcionamiento

Dwyer Instruments

Dwyer Instruments GSTC Series Suplemento

Dwyer Instruments

Dwyer Instruments ProxiMity UL Series Manual de usuario

Dwyer Instruments

Dwyer Instruments Magnesense Pro MSX Series Instrucciones de instalación y funcionamiento

Dwyer Instruments

Dwyer Instruments 641RM Series Manual de usuario

Dwyer Instruments

Dwyer Instruments TBU-00 Instrucciones de instalación y funcionamiento

Dwyer Instruments

Dwyer Instruments CDT Series Manual de usuario

Dwyer Instruments

Dwyer Instruments 629 Series Manual de usuario

Dwyer Instruments

Dwyer Instruments IEF Series Manual de usuario

Dwyer Instruments

Dwyer Instruments DM-2000 Manual de usuario

Dwyer Instruments

Dwyer Instruments CDT Series Manual de usuario

Dwyer Instruments

Dwyer Instruments DM DigiMag Series Manual de usuario

Dwyer Instruments

Dwyer Instruments UL series Instrucciones de instalación y funcionamiento

Dwyer Instruments

Dwyer Instruments RHP-W series Instrucciones de instalación y funcionamiento

Dwyer Instruments

Dwyer Instruments AVPT Series Instrucciones de instalación y funcionamiento

Manuales populares de Transmisor de otras marcas

NIVELCO

NIVELCO EasyTREK SCA-300 Series Manual del propietario

Honeywell

Honeywell 5816WMBR Manual de usuario

Kamstrup

Kamstrup READy MTU Instrucciones de funcionamiento

Omega

Omega ZW Series Manual de usuario

ABB

ABB Field 264H Guía

Alinco

Alinco DJ-V17T Manual de usuario

Dejero

Dejero EnGo 3x Manual de usuario

Rosemount

Rosemount 4600 Manual de usuario

Speaka Professional

Speaka Professional 2342740 Manual de usuario

trubomat

trubomat GAB 1000 Manual de usuario

Teledyne Analytical Instruments

Teledyne Analytical Instruments LXT-380 Manual de usuario

Rondish

Rondish UT-11 Manual de usuario

MG 10JRE Manual de usuario

Burkert

Burkert 8177 Manual de usuario

Firetide

Firetide HotPort 3203 Manual

Tele Radio

Tele Radio T9-02 Manual de usuario

Rotronic

Rotronic HygroFlex HF3 Series Manual de usuario

Jamara

Jamara FCX6 Pro Tel Manual de usuario