Dual XDM6800 Instrucciones de funcionamiento

INSTALLATION/OWNERS MANUAL

AM/FM/CD/MP3 Receiver with Detach Face

XDM68

XDM68 INSTALLATION

Preparation

RESET

BUTTON

SECURITY

LED

KEYS

Please read entire manual before installation.

Before You Start

• Disconnect negative battery terminal.

(consult a qualified technician for instructions)

• Avoid installing the unit where it would be subject to high temperatures,

such as from direct sunlight, or where it would be subject to dust, dirt or

excessive vibration.

Getting Started

•Remove 2 transit screws located on

top of the unit.

•Insert the supplied keys into the

slots as shown, and slide the unit

out of the mounting sleeve.

•Install mounting sleeve into dash

opening, bending tabs to secure.

•Certain vehicles may require an

installation kit and/or wiring

harness adapter (sold separately).

AMP

YELLOW Auxiliary Input

Remote Turn-On

Connect to amplifier or power

antenna. Insulate wire if not used.

RCA Cable

(sold separately)

BLUE

Antenna Connector

Rear Preamp Output

Connect to amplifier RCA Input

GREY

Ground

Connect to vehicle

chassis ground.

BLACK

Accessory

Connect to existing ignition

circuit or switched 12 volt source.

RED

Memory

Connect to battery

circuit or constant 12 volt source.

Right Front

Gray/Black (-)

Gray (+)

Left Front

White/Black (-)

White (+)

Right Rear

Violet/Black (-)

Violet (+)

Left Rear

Green/Black (-)

Green (+)

YELLOW

XDM68 INSTALLATION

Wiring Diagram

FUSE

When replacing a fuse,

make sure new fuse is the

correct type and amperage.

Using an incorrect fuse

could damage radio.

The XDM6800 uses one

10 amp ATO fuse located

below wiring connector.

XDM68 OPERATION

Control Locations

Release

Power

Audio

Tune/Track Up

Tune/Track Down

Loud

Display

Auto Store/Preset Scan

Play/Pause/Band

Eject

Mode

Preset 10

Preset 9

Preset 8

Preset 7

Preset 6/CD Intro

Preset 5/CD Random

Preset 4/CD Repeat

Preset 3/CD Program

Preset 2/MP3 Folder Up

Preset 1/MP3 Folder Down

Tuner Scan/MP3 Folder

Mute

The XDM6800 allows playback of your favorite MP3 files recorded on CD-R and CD-RW

discs. MP3 is a compression technology for music that provides data reduction while

maintaining near-CD sound quality. Powerful on-board DSP decodes audio and provides

alphanumeric display of ID3 tags. Record 100-200 songs on a single disc!

21 20 19 18 17 16 15 14 13 1222

1 2 3 6 7 84 5 10911

General Operation

XDM68 OPERATION

Press REL and pull away from the left side to remove.

To re-install, insert right side of faceplate first then push left

side to secure.

*For semi-permanent faceplate installation, remove trim ring and install

supplied Phillips head #1 screw through left side of mounting frame into

faceplate.

Press PWR or any other button (except eject) to turn the unit

on. Inserting a CD will turn the unit on automatically. Press

PWR to turn the unit off.

Press MODE to select between tuner, CD player and

auxiliary input. Modes of operation are indicated in the

display.

Press LOUD to activate and deactivate the loudness contour

curve. Activating this feature will enhance the bass and

treble frequencies when listening to music at low volumes.

Adjust volume using rotary encoder (00-46).

Press and hold PWR for 3 seconds to program currently

selected volume level.

Press rotary encoder for 3 seconds to turn confirmation

beep on/off.

Press MUTE to silence the audio. Press any button to cancel.

Press DISP to select between clock and radio frequency

(tuner mode) or CD track/elapsed time (CD player mode).

With the unit on, press and hold DISP until clock begins

to flash, then release. Press TUNE

to adjust the hours

and TUNE

to adjust the minutes. Press DISP

momentarily to save the selected time.

The clock will display 12-hour AM/PM time in U.S. frequency

spacing mode (6:00 AM). In European frequency spacing

mode, the clock will display 24-hour time (06:00).

Faceplate Removal

Power On/Off

Mode

Loudness

Volume

Programmable

Turn-On Volume

Confirmation Beep

Mute

Display

Set the Clock

12/24-hour Clock

XDM68 OPERATION

General Operation

Press and hold DISP then press TUNE

to select radio

frequency (tuner mode) or CD track/elapsed time (CD player

mode) display priority (default). Clock is accessed by

pressing DISP momentarily.

Press and hold DISP then press TUNE

to select clock

display priority. Radio frequency or CD track/elapsed time is

accessed by pressing DISP momentarily.

*Programmable Display Priority is not available when playing an MP3 disc.

Press and hold for more than 2 seconds to RESET the unit

upon initial installation. The RESET button is located behind

the faceplate.

Press rotary encoder to select between Volume (default),

Bass, Treble, Balance & Fader.

Press rotary encoder until BASS appears

Rotate encoder left/right to adjust

(+6 maximum / -6 minimum)

Press rotary encoder until TRE appears

Rotate encoder left/right to adjust

(+6 maximum / -6 minimum)

Press rotary encoder until BAL appears

Rotate encoder left/right to adjust

(L12-00-R12) 00 represents equal balance.

Press rotary encoder until FAD appears

Rotate encoder left/right to adjust

(F12-00-R12) 00 represents equal fader.

Programmable

Display Priority

Reset

Audio

Bass

Treble

Balance

Fader

XDM68 OPERATION

Tuner Operation

Press TUNE

or TUNE

momentarily to seek the

next strong station.

Press TUNE

or TUNE

for more than 5 seconds,

then release. Press TUNE

or TUNE

momentarily

to move radio frequency up or down one step at a time. Press

and hold to advance quickly. If tuning is not adjusted for 5

seconds, the unit will return to seek tuning mode (default).

Press SCAN to preview strong stations on the current band,

pausing for 5 seconds at each. Press SCAN again to cancel.

Press BAND to select between FM1, FM2 and AM bands.

Press and hold BAND then press TUNE

to select

European frequency spacing. Press and hold BAND then

press TUNE

to select U.S. frequency spacing (default).

Anytime frequency spacing is changed, all station presets

and clock settings are erased.

Up to 20 FM stations and 10 AM stations can be stored. To

store a station, select the desired band and station. Press

and hold the desired preset button for more than 3 seconds.

When stored, the preset number will appear in the display.

The station can be recalled anytime by pressing the

corresponding preset button.

Press AS/PS for more than 3 seconds to automatically store

the ten strongest stations in the current band. Automatic

Local/Distance is activated during the initial band scan.

Press AS/PS for less than 3 seconds to scan presets 1-10

on the current band, pausing for 5 seconds at each. Press

AS/PS again to cancel.

Seek Tuning

Manual Tuning

Scan Tuning

Band

Frequency Spacing

Storing and Recalling

Station Presets

Automatically Store Stations

Preset Scan

XDM68 OPERATION

CD/MP3 Player Operation

With the label facing up, insert a standard 5" CD into the CD

slot. The CD will automatically begin playback.

Press the EJECT button to stop and eject the CD. The unit will

change to previous mode of operation (tuner or auxiliary input).

If the disc is not removed within 10 seconds, the unit will reload

the disc. The unit does not have to be turned on to eject CD.

Press TRACK

to skip to the beginning of the next track.

Press TRACK

to return to the beginning of the current

track. Pressing TRACK

again skips to the beginning of

the previous track.

Press and hold TRACK

or TRACK

to fast forward

or reverse a track.

*Fast Forward and Reverse is not available when playing an MP3 disc.

Press

to temporarily stop CD playback. Press

again to resume playback.

Press INT for more than 3 seconds to play the first 10

seconds of each track. Press INT again to cancel.

Press RPT for more than 3 seconds to continuously repeat

selected track. Press RPT again to cancel.

Press RDM for more than 3 seconds to play all tracks in

random order. Press RDM again to cancel.

Select desired track by pressing keys (1-0). If unavailable,

CD NO TRACK appears in the display.

Press PGM for more than 3 seconds. PROGRAM icon will

flash indicating up to 24 tracks can be programmed. The

display will show one of the following:

P-01 = Program is empty, P-24 = Last track in memory;

PROG CLEAR = Program has been cleared, or PROGRAM

FULL = Program is full.

In program mode, press TRACK

or TRACK

select a track. Press PGM to program selected track into

memory. P-02 will now appear in the display. Repeat

process to program up to 24 tracks into memory.

Insert CD

Eject CD

Track Select

Fast Forward and Reverse

Pause

Intro

Repeat

Random

Direct Track Access

Program Mode

Store Tracks in Memory

CLOCKTRACK TIME TRACK NAME ARTIST NAME FOLDER NAME

XDM68 OPERATION

CD/MP3 Player Operation

In program mode, press

to begin program playback.

In program mode, press PGM for more than 3 seconds to

clear program memory.

When an MP3 encoded disc is inserted, FILE SCAN will

appear in the display. Depending on the number of files and

folders, this may take several seconds.

When file scanning is complete, the total number of files

and folders found on the disc will be displayed.

Select desired file by pressing keys (1-0). If unavailable,

CD NO TRACK will appear in the display. File count

references the total files recorded on the disc. Files cannot

be directly accessed within a folder.

Press FOLDER momentarily, FOLDER icon will be

displayed. Press FOLDER or FOLDER to select

next or previous folder.

*Folder access is only available on discs recorded with more than one folder (ROOT).

Press DISP to select between MP3 Track/Elapsed Time

(default), Clock, Track Name, Artist Name & Folder Name.

•ISO9660 level 1 and level 2

•44.1 kHz sampling rate frequency

•Constant rates from 8 ~ 320 kbps

•Variable bit rates

•ID3 tags Version 1.0 and 1.1

*This model is not compatible with ID3 Version 2.0 or greater tags.

•Track name –30 character maximum

•Artist name –30 character maximum

•Folder name –28 character maximum

32 character maximum (including .mp3 extension)

Play Program Tracks

Clear Program Tracks

Playing an MP3 Disc

Direct File Access

Folder Access

ID3 Tag Display

Supports the Following

MP3 formats:

ID3 Tag Display Information:

Filename Display Information

XDM68 OPERATION

CD/MP3 Player Operation

A high-performance 5-second ESP (Electronic Shock

Protection) buffer virtually eliminates skipping.

(MP3 encoded discs only)

When playing a disc recorded with regular audio files

(CD-DA) and MP3 files, the unit will play the regular audio

files only.

Only MP3 files with filename extension (.mp3) can be played.

This model is not compatible with MP3 PRO format or MP3 playlists.

MP3 playback sequence is based on recorded order of files

and begins in the ROOT folder of the disc (F001 T001). Any

folders that do not include MP3 files are skipped.

“F”indicates folder number and “T”indicates track or file

number. Example: F 3 T 67 in the display indicates 3

folders (including ROOT) and 67 tracks or files.

Some CD-Rs and CD-RWs may be incompatible with

this unit, depending on media type and recording method.

Additional MP3 Information

CD-R/CD-RW Compatibility

Tabla de contenidos

Otros manuales de Receptor de Dual

Dual

Dual XDM17BT Manual de usuario

Dual

Dual DCPA901 Instrucciones de funcionamiento

Dual

Dual MGH37BT Instrucciones de funcionamiento

Dual

Dual XDVD251BT Instrucciones de funcionamiento

Dual

Dual VX2529 Instrucciones de funcionamiento

Dual

Dual MXD339BT Instrucciones de funcionamiento

Dual

Dual DMCPA79BT Instrucciones de funcionamiento

Dual

Dual XD28BT Manual de usuario

Dual

Dual XVM279NAV Instrucciones de funcionamiento

Dual

Dual XRM69RGB Manual de usuario

Dual

Dual XRM47BT Manual de usuario

Dual

Dual XDVD8181 Manual de usuario

Dual

Dual DSA1116BT Instrucciones de funcionamiento

Dual

Dual XGPS170D Manual de usuario

Dual

Dual XDVD770BT Instrucciones de funcionamiento

Dual

Dual XVM1000Ui Instrucciones de funcionamiento

Dual

Dual CR 1780 Manual de usuario

Dual

Dual DM720 Instrucciones de funcionamiento

Dual

Dual XDVD9101 Instrucciones de funcionamiento

Dual

Dual XRM59BT Instrucciones de funcionamiento

Dual

Dual AXV830 Instrucciones de funcionamiento

Dual

Dual xdvd136bt Instrucciones de funcionamiento

Dual

Dual XDM280BT Manual de usuario

Dual

Dual XVM279BT Instrucciones de funcionamiento

Manuales populares de Receptor de otras marcas

Garmin

Garmin GA 23 Manual de usuario

Aiphone

Aiphone PS-12F Manual de usuario

IMES

IMES TCS-01CA-PMI Manual de usuario

BWI Eagle

BWI Eagle AIR-EAGLE SR Manual

AMIMON

AMIMON AMN12310 WHDI Manual de usuario

Sound Associates

Sound Associates SA652P Manual de usuario

Sherwood

Sherwood NewCastle R-772 Manual de usuario

Audio

Audio A10-RX Series Manual de usuario

AllSee

AllSee PushShare PSRV1.1 Manual de usuario

DEMAG

DEMAG DRC-DR D2 Manual de usuario

Teleco

Teleco TVRCL868A02 Manual de usuario

Bosch

Bosch RF3222E Manual de usuario

Kramer

Kramer 631R Manual de usuario

Xpress

Xpress xmc10 Manual de usuario

JVC

JVC KD-MR1BTS Manual de usuario

Omega Engineering

Omega Engineering UWTC-REC3 Manual de usuario

e-survey

e-survey E300 Pro Manual de usuario

Dish Network

Dish Network Satellite Television Manual de usuario