Dual MGH30BT Instrucciones de funcionamiento

MGH30BT

INSTALLATION/OWNER'S MANUAL

AM/FM Gauge Hole Receiver

MGH30BT OPERATION

Mounting & Wiring

Please read entire manual before installation.

Before You Start

• Disconnect negative battery terminal. Consult a qualified technician for instructions.

• Avoid installing the unit where it would be subject to high temperatures, such as from

direct sunlight, or where it would be subject to dust, dirt or excessive vibration.

Getting Started

• Once a suitable location has been determined, drill the hole and secure the stereo

using the metal mounting bracket. If the bracket needs to be shortened, remove the

appropriate number of breakaway segments using a pair of pliers.

Fuse:

When replacing the fuse, make sure

new fuse is the correct type and

amperage. Using an incorrect fuse

could damage the radio.

Tip:

When a suitable ground wire is

not present in the vehicle wiring

harness, connect the black ground

wire to the vehicle chassis.

Break Lines

Color Connection

Red 12V Ignition / Accessory

Black Ground

Blue Remote Turn-on B (+)

Grey Right Front (+)

Grey/Black Right Front (-)

White Left Front (+)

White/Black Left Front (-)

Violet Right Rear (+)

Violet/Black Right Rear (-)

Green Left Rear (+)

Green/Black Left Rear (-)

MGH30BT OPERATION

Installation

Mounting the Radio

1. Choose a mounting location on the dash board or instrument panel that will

allow room behind to run radio cables to the power source. Consider how you will use

the AUX IN, LINE OUT and USB connectors and route the appropriate extension cables

to an accessible area.

2. Cut a hole in the dash board using the template provided in the back of this manual. At

least 3 3/4” depth is needed to mount the radio.

IMPORTANT! Do not mount this unit where it can be submerged in water.

3. Slide the included spring washers (B) over the screw posts (A) and attach the screw

posts to the back of the radio.

4. Place the radio in front of the dashboard opening so the wiring can be brought through

the opening.

5. After completing the wiring connections, turn the radio on to confirm operation (vehicle

accessory switch must be on). If the radio does not operate, recheck all wiring until the

problem is corrected. Once proper operation is achieved, turn the accessory switch off

and proceed with final mounting of the radio. Refer to the “Wiring Diagram” on page 5.

NOTE: Before final installation, test the wiring connections to make sure the unit is con-

nected properly and the system works.

6. Insert the radio into the mounting hole.

7. Place the “U” bracket (C) over the screw posts and secure the radio to the dash using

the included hex nuts (D). If necessary, cut the score marks (E) on either side of the

mounting bracket to custom fit the bracket length for your application. See Figure A.

Installation

3 Inch Hole

MGH30BT OPERATION

Control Locations - Receiver

Select / Thumbs Up

Volume Up

Volume Down

Mode / Thumbs Down

Audio / Menu

Power

Mute

Band / Go Back

Tune Down

Tune Up

Play / Pause

MGH30BT OPERATION

Control Locations - Remote

Preset 6 / Folder Up

Display

Mute

Preset 5 / Folder Down

Preset 4 / Play / Pause

Preset 1 / Repeat

Band / Go Back

Tune / Track Down

Mode

Volume Up

Power

Select

Tune / Track Up

Volume Down

Audio / Menu

Preset 3 / Intro

Preset 2 / Random

MGH30BT OPERATION

Press or any other button to turn the unit on. Press and

hold to turn the unit off.

Press MODE to enter the Mode Menu, then press MODE

to select between Tuner, Aux, USB, iPod, Bluetooth and

Pandora modes. Modes of operation are shown in the

display.

The MGH30BT offers rear RCA auxiliary input ports for

connecting an audio device, MP3 player, etc. Press MODE to

select auxiliary input mode.

Adjust volume using volume keys.

Press DISP to toggle between ID3 tag and file/folder name

for MP3/WMA files being played from CDs or USB devices.

If abnormal operation occurs, press MENU and TUNE

for three seconds to reset the unit to the default factory

settings.

Power On/Off

Mode

Auxiliary Input

Volume

Display

Reset

General Operation

MGH30BT OPERATION

General Operation

Audio Setup Menu

Menu Function Options

Equalization

Curves

Use the VOL+ or VOL- buttons to cycle through the following equalization

curves: Flat, Pop, Jazz, Classic, Beat, Rock and User. Any manual adjustment to

the Bass or Treble settings are automatically saved as User.

Loudness Use the VOL+ or VOL- buttons to activate or deactivate the Loudness feature,

which increases bass and treble levels at low volume.

Bass Level Use the VOL+ or VOL- buttons to adjust the bass level setting

(-6 minimum / +6 maximum).

Bass Frequency Use the VOL+ or VOL- buttons to select one of the following bass frequency

settings: 60 Hz, 80 Hz, 100 Hz or 200 Hz.

Middle Level Use the VOL+ or VOL- buttons to adjust the middle level setting

(-6 minimum / +6 maximum).

Middle Frequency Use the VOL+ or VOL- buttons to select one of the following middle frequency

settings: 500 Hz, 1 kHz, 1.5 kHz or 2.5 kHz.

Treble Level Use the VOL+ or VOL- buttons to adjust the treble level setting

(-6 minimum / +6 maximum).

Treble Frequency Use the VOL+ or VOL- buttons to select one of the following treble frequency

settings: 10 KHz, 12.5 KHz, 15 KHz or 17.5 KHz.

Balance Use the VOL+ or VOL- buttons to adjust the balance setting.

(12-L to 12-R; 0 represents equal balance).

Fader Use the VOL+ or VOL- buttons to adjust the fader setting.

(12-F to 12-R; 0 represents equal balance)

Press MENU to toggle through and select one of the

following setup menus: Audio, General, Gain and Screen.

1. Once the desired menu is displayed, use the VOL+ or

VOL- buttons to scroll through the list of menu features.

2. Press SELECT to select a specific feature to adjust, then

use the VOL+ or VOL- buttons to adjust or activate

the desired feature.

3. Press SELECT to confirm and save the changes.

Setup Menu

MGH30BT OPERATION

General Operation

Menu Function Options Action

Tuner

Frequency

Spacing

USA Programs the unit to USA tuner spacing.

(200kHz for FM and 10kHz for AM).

S-America Programs the unit to South American tuner spacing.

(100kHz for FM and 10kHz for AM).

Europe Programs the unit to European tuner spacing.

(50kHz for FM and 9kHz for AM).

Auto Station

Store AUTO STORE Press SELECT to seek and save 6 strong stations in the

current band.

Local/Distance

Tuning

Off Activates distance tuning.

On Activates local tuning for strong station reception only.

Scrolling

Option

Off Programs the unit to not scroll any information on the

display.

Once Programs the unit to only scroll information once.

15Sec Programs unit to scroll information once every 15 seconds

(default).

On Programs unit to scroll information continuously.

iPod Control

Full Programs the head unit to advanced control of the iPod/

iPhone device.

Manual

Programs the head unit to manual control of the iPod/iPhone

device and allows music to be controlled from the iPod/

iPhone device.

Beep

Confirmation

Off Disables the confirmation beep.

On Enables the confirmation beep.

Programmable

Turn On Volume

Variable

Value

Programs unit to always turn on at a specific volume

(default is Off). A volume level of 1-30 can be selected.

General Setup Menu

Low Battery ON

Battery Voltage drops(10.8V+/-0.03V)a Beep will sound.(default)

OFF

Battery Voltage drops(10.8V+/-0.03V)a Beep will not sound.

MGH30BT OPERATION

General Operation

Gain Setup Menu

Menu Function Options

Tuner Gain Use the VOL+ or VOL- buttons to adjust the tuner gain.

(-6 minimum / +6 maximum)

Aux Gain Use the VOL+ or VOL- buttons to adjust the gain for the front auxiliary input.

(-6 minimum / +6 maximum)

Bluetooth Gain

Use the VOL+ or VOL- buttons to adjust the gain for the Bluetooth A2DP

Playback.

(-6 minimum / +6 maximum)

USB Gain Use the VOL+ or VOL- buttons to adjust the gain for USB playback.

(-6 minimum / +6 maximum)

iPod Gain Use the VOL+ or VOL- buttons to adjust the gain for iPod playback.

(-6 minimum / +6 maximum)

Pandora Gain Use the VOL+ or VOL- buttons to adjust the gain for Pandora playback.

(-6 minimum / +6 maximum)

Screen Setup Menu

Menu Function Options

Color Use the VOL+ or VOL- buttons to adjust the color settings of the display screen

from 0 to 50.

Contrast Use the VOL+ or VOL- buttons to adjust the contrast settings of the display

screen from 0 to 50.

Brightness Use the VOL+ or VOL- buttons to adjust the brightness settings of the display

screen from 0 to 50.

Demo Use the VOL+ or VOL- buttons to to enable (ON) or disable (OFF) the

demonstration mode.

MGH30BT OPERATION

Manual Tuning

Seek Tuning

Band

Manually Storing

Preset Stations

Automatically Store

Preset Stations

Recalling

Preset Stations

Press TUNE

or TUNE

momentarily to change

radio frequency up or down one step at a time. Press and

hold to advance quickly.

Press TUNE

or TUNE

for more than two seconds

(then release) to automatically seek and tune to the next

strong station.

Press BAND to select between FM1, FM2, FM3, AM1 and

AM2 bands.

Up to 18 FM stations and 12 AM stations can be stored.

To manually store a station, select the desired band and

station. Press and hold Play/Pause for more than two

seconds, then press Volume Up to step through preset

numbers one through six. When the desired preset number

is reached, press SELECT to save the selection.

Press MENU twice, then press Volume Up to select Auto

Station Store. Press SELECT to confirm. The unit will

automatically scan and store the six strongest stations in

the current band as presets.

Once stations have been saved, press Play/Pause to step

through each preset station.

AM/FM Tuner Operation

Tabla de contenidos

Otros manuales de Receptor de coche de Dual

Dual

Dual XR4115 Instrucciones de funcionamiento

Dual

Dual DVM179 Instrucciones de funcionamiento

Dual

Dual MXD105 Instrucciones de funcionamiento

Dual

Dual XD5125 Instrucciones de funcionamiento

Dual

Dual DC204 Instrucciones de funcionamiento

Dual

Dual XHD7714 - V3 Instrucciones de funcionamiento

Dual

Dual XDVD1265BT Instrucciones de funcionamiento

Dual

Dual DV927BT Instrucciones de funcionamiento

Dual

Dual XDVD1175BT Manual de usuario

Dual

Dual MXCP44 Instrucciones de funcionamiento

Dual

Dual XML8110 Instrucciones de funcionamiento

Dual

Dual XHD7720 Instrucciones de funcionamiento

Dual

Dual XDVD110BT Instrucciones de funcionamiento

Dual

Dual XD5250 Instrucciones de funcionamiento

Dual

Dual DV695MB Instrucciones de funcionamiento

Dual

Dual DSA1007 Instrucciones de funcionamiento

Dual

Dual XP Series Instrucciones de funcionamiento

Dual

Dual DXRM59BT Instrucciones de funcionamiento

Dual

Dual DCBT304U Instrucciones de funcionamiento

Dual

Dual XDMA6438 Instrucciones de funcionamiento

Dual

Dual XDVD1265BT Manual de usuario

Dual

Dual XDCPA10BT Instrucciones de funcionamiento

Dual

Dual DC416BT Instrucciones de funcionamiento

Dual

Dual DMCPA70BT Instrucciones de funcionamiento

Manuales populares de Receptor de coche de otras marcas

Motorola

Motorola VWA63 Manual de usuario

Nextar

Nextar D3201 Manual de usuario

Alpine

Alpine CDE-163BT Manual de usuario

Pioneer

Pioneer DEH-P645R Manual de usuario

Axxera

Axxera XDMA7600 Instrucciones de funcionamiento

XM OnyX Manual de usuario

Sound Storm

Sound Storm STM93R Manual de usuario

Soundstream

Soundstream VIR-5000 Manual de usuario

Avson

Avson MKT Platform Manual de usuario

Sony

Sony MEX-1HD - Audio Library System Manual de usuario

Pioneer

Pioneer DVH-P500UB Manual de usuario

JVC

JVC KD-AHD69 Manual de usuario

Blaupunkt

Blaupunkt SANTIAGO CR 87 Manual de usuario

Sony

Sony CDX-4160 - Cd Receiver Manual de usuario

XFIRE AUDIO

XFIRE AUDIO BMW42S Manual de usuario

VDO

VDO CD 2253 Manual de usuario

Volvo

Volvo 13 84 580 Manual de usuario

ZENEC

ZENEC ZE-160DVD Manual de usuario